Which Spark Plugs should you run on your F30 335 AND how to install them!

[@maxwellkeeling3781]

One thing I'd recommend is leaving the engine cover off and hood up and fire up the car, rev lightly to make sure there isn't any missing. I had a coil that I didn't plug in just right and it was missing and I had to virtually open everything back up again to diagnose. Great video as always!

[@saman1820]

Missing what? A unplugged coil will shake ur engine

[@arsenic5322]

Crazy to see what this channel has become, I remember the good old days when you started! Keep up the amazing content Brian!

[@bmw_knight_f3088]

Love the F-30 mods. I remember watching your video couple years ago, when I was changing my own spark plugs on my F-30🤙👍 Thank you kiesmotorsport.

[@NinjaTactiks]

I did mine this winter for the first time following Kies. :D

[@kpy3p]

Very easy to follow and spot on DIY, thank yo so much! Only thing i'd comment is that it would be easier to remove the plastic trim piece that goes above the foam insulation towards the back of the engine and then just re-install the foam before putting the trim back on.

[@jg_media9]

Ngk one step colder plugs 👌

[@brainsgains7487]

I would replace the coil packs when you're already in there changing out the sparks. Last thing you want is to do all that work and have to do it all over if one of the coils are faulty or on the way out. Plus, with FCP you have lifetime warranty so you only pay for a set of new sparks and coils once!

[@GhostTownRanch]

Mission complete, thanks man. Saved me $$$

[@Ashley_van_Schooneveld]

I'm running full stock on my N55 so I'm using the Bosch OE plug that I replaced at 49k miles. Still I have the charge pipe upgrade and M Performance exhaust.

[@josephmgomez3921]

Same here I got the high poer bosch

[@RyanPaz1215]

Do you have an updated link for the Bosch plugs? ✌️

[@BMWDIYGuy]

Super helpful, thanks yall!

[@lucasborka3714]

Should just use the oem bosch plugs. Of you have problems with them then go one step colder or tighten the gap. Bosch are fragile to gapping tho. 435i fbo stage 2 e30 with stock bosch, runs strong!

[@MegaTony805]

I have the same car just had plugs coils and vcg done. How long have you been running stage 2?

[@MegaTony805]

2016?

[@lucasborka3714]

@@MegaTony805 Been running stage 2 for a year now, zero problems! Car is a 2015 49.7k miles

[@mariomunoz7167]

I’m having issues with the Ngk 97506. I get a choppy idle at lower gap, and miss up top at .26. So should I use the stock? I’m on an e40 blend fbo m2

[@mikelechler399]

Great video as always!

[@shanepadayachee9344]

Your videos are always so detailed and you make everything seem so easy to do.👍

[@Flysohighx21]

Another amazing and helpful DIY! Thanks!

[@robertbradford8918]

Yess! Been needing this detailed vid as this is my next step with the stage 2 BM3 flash. Awesome video Brian!

[@pabloalbertopastrana1309]

Great job and very helpful. 🎉

[@maxwellkeeling3781]

"I'll gap one with you!" gee thanks man! In the most proud dad voice 😂😊

[@BMWEnjoyer]

Brian is very handsome and nice, he is also very good at doing instructional videos. The car girls really appreciate you! I have an F30 335i with full bolt ons :)

[@cammgt3rs370]

Ohhhh BOY.

[@ExhaustedOutdoors]

NGK gang 🔥

[@OscarCastillo1]

It would be nice if you offered Fx0 or Gx0 performance and/or regular maintenance packages with all the best matching parts to target those looking for performance mods or just better than OEM parts for maintenance. Like a 3 tier, good, better, best for suspension, engine, or just for aesthetics.

[@ayyyman_]

Thanks for reminding me, I need to upgrade my spark plugs lol

[@senadselimovic8649]

Can i put original b48 330i f30 spark plugs to a tunned b48 320i? And when do i need to change the first spark plugs change on a new car?

[@frankwang7491]

Hi Brian! I have a 2011 535i with a N55 engine I have the OTS stage 1 map and currently im having the new stock ones. is the NKG more recommended? Or the stock ones for stage 1 just fine

[@kenkobra]

Nice video!

[@olliebeast1012]

On a stock or stage 1 F30 328i do the Bosch plugs come at the right clearance out of the box?

[@Christopher9835]

Can you make a video of blending ethanol with pump gas, let say 91oct or 93oct

[@terrancecollins2696]

Man idk if I can ever go back to a V8 car after working on this inline 6 lol people make it seem like BMWs are nightmares to work on and I’ve legit only have bad positive experiences working on my 435

[@mcdeelo7]

If I'm running no tune at all Just have a few mods Like Castles downpipe injen intake muffler delete. Can i still use the NGK plugs or do you recommend the Bosh plugs? Tia

[@tajdidajman4889]

Whats the gap for a f30 335i with just a mppk tune?

[@kausar456]

No anti seize on plug threads or dielectric grease on boots?

[@elsparky35]

awesome videos. may i have the link to the torque wrench you're using?

[@NinjaTactiks]

Would you use the NGK if it's just Stage 1 and mostly stock minus the intercooler and charge pipe?

[@fr3dyy232]

Wondering the same thing lmk if you find out lol

[@josephcluse9783]

Same question did u find out???

[@77cvalle77]

Same here -

[@luiscarlosmontanosaenz7717]

Hello ! , how about now in 2024 for a bmw m8 2020 coupe tune stage 2 .which ones do u recommend NGK 2 step or original ones please i need to know

[@KiesMotorsports]

NGK 👍

[@luiscarlosmontanosaenz7717]

@@KiesMotorsports Hello, now I am about to update from stage 1oct 93 to stage 2 e30. but I have a doubt, the ots map says that I require downpipes on my m8 s63, But I honestly don't like the idea of stinky smells. so I thought about catted downpipes 200cell but do you think that bring me problems with the stage 2 ots e30. ?

[@kevinryan2556]

Hi Brian I have a F80 with Dinan stage 1. What are the absolute best plugs?

[@MrMrDopeMan]

I have a 2012 535i I’m currently running a stage 2 tune with all bolt ons and e30. Getting ready to swap the plugs out as well. What should I gap the plugs to for this setup?

[@droppinBOMBS310]

So I have F30 N55 Stage 2 ACN 91 tune on BM3, still on stock plugs. Should I swap plugs ???

[@spussego]

does anyone know what those bolts are on either end of the brace bar is? Bryan says they should be replaced, but does not say what bolts they are.... M10 hex? M12 Hex? 75 mm, 125 mm, 100 mm?

[@gregpapagno5683]

Hey Brian I have a f80 with bootmod cs map. What plugs should I run?

[@realtruth97]

Do I have to gap my oem plugs too if I don't have mods? How bout the ngk plugs? If I don't have mods do I have to gap them too? I just had a misfire [drivetrain malfunction] while in the highway trying to go fast. Can that be the culprit? Anyone know? Can an aftermarket plug with no gap create a misfire problem?

[@G80Michaels]

Oem is gapped fine, gap ngk to 0.022

[@cscf3052]

Brian!! What's the most efficient spark plug and gap will I need for a b48 (2017 330i 4 cylinder twin turbo) with full bolt-ons and BM3 stage 2 aggressive?

[@DansJB_M3]

Have you guys done precision racework coils for your f30 yet?

[@bizzy]

what if for those n13 engine stage 2 . those oem borsh plug is it still ok to gap 0.022 or even stock too? Some said and forum said all the n13/n20 also are better with 0.022 gap?

[@CarringtonAdkins]

Updated link to spark plugs?

[@zarkov821]

If i run stage 1 with cooler and cold air intake and MHD stage 1, i still need to gap to 0.22 right??

[@ramisiljazi9540]

Any content coming up on a f15 x5??

[@cuttthroatperformance2752]

MMR Oil pan baffling system for the n55??

[@slowloudanbangn]

Is a .20 gap still okay with ngk plugs on a stage 2 93 oct tune from your professional experience?

[@inelv612]

You can use stock plugs, i have a PS2 turbo on mine and left it at the original gap lol

[@petrhozdek7042]

Hi Kies .. ive got 2019 bmw 320i g20 ... can you help me to find original product number for spark plugs I need or OEM number .. thank you

[@nash3557]

Hi. Will 0.020 gap work on n55 mhd stage 2 plus?

[@andrewcervantes3312]

Stock f30 N55 spark plug gap? What is it at?

[@lilerik58]

can u run the ngk on a stock car? and if so - what gap?

[@jpalsen7653]

Hi Brian I have a 235i Dinan stage 4, with oversized turbo running 455hp, what gap should I use and should I get the program check out. New to this so any info is great.

[@GhostTownRanch]

Just ask Dinan?

[@cheffondo7]

Link to the Bosch spark plug no longer works.

[@cheffondo7]

Following up on comment above. Do you have the link to the Bosch spark plug?

[@josephcluse9783]

I work at oreilys and they have these in stock should I buy them or are they not the same???

[@GhostTownRanch]

The ones that came from Amazon are $6.30 a piece, the ones at ORiely are like $16 a piece only diff. Make sure to check the gap, out of 6 only 1 was gapped correctly

[@Mrkev_47]

i went stage 1 91 octane , and changed my plugs to ngk and went 0.22 and im losing power rofl

[@stoss-11]

i have an f30 n55 if i run e30 should i just run the .22 or do i need to go down to .20

[@N55Koby]

what did you end up going with im in the same boat

[@somewhereoverit711]

Why the extra 90 degrees

[@GhostTownRanch]

So you can smash your fingers trying to get the two top bolts…

[@esteemedenergy]

Anti seize on plugs?

[@Areku06]

Nope, bmw doesn’t recommend it.

[@ing.josemartinez8221]

Hi, Great Video!!, i Have a question? What happen if I install NGK plugs in N20 Stock? Thanks for you comments

[@RaymondLo84]

Impossible to dislike this... Ok maybe his hair, but nope, I don't care anymore

[@theodorestamatis512]

Hello, i am currently stage 1 on my n55 with after market intercooler and its time to change my spark plugs, i already got the ngk 97506 should i still gap them at 0.022?

[@cammgt3rs370]

I have similar stage with mods and I just installed the 97506 at .032 and they work great. I will try in the future with tighter gaps to see if they work better. The tighter gapping is to reduce flame out conditions. I noticed in the past that the larger the gap without flameout is more powerful. My car is fast as heck for what mods I did and runs great.

[@ramirezserge187]

Great vid! Thanks! I once bought a BMW spark plug socket when I changed the plugs on my E90 335i. Will that same socket work for the F30 335i?

[@Roomooh_123]

Damm is it really that easy ?