Wil-Rich 357 InLine Ripper: Walk Around | Väderstad

[@herbhouston5378]

It's a good lookin' tool, but I will never understand running it shallower than a turning plow.

[@thewil-richguy9057]

In our area running too deep will bring up clay. We just like to run at the very bottom edge of the hard pan. This gives a nice fracture. Running too deep below the hard pan only allows the shank to cut a slit through the ground and you don’t get the fracturing of the hard pan.

[@amosmoses9247]

@@thewil-richguy9057 Running the point at the bottom of the hard pan makes perfect sense. The 3" wide point vs the 1" ripper shank gives more disruption.

[@brycepaule3067]

Looks like it needs another set of lift wheels, rolls side to side too much

[@japllseed]

Waste of money.The ware and tare on your tractor ain’t worth the yield difference not counting the fuel loss pulling it