Wind Loads Simulation - Autodesk Robot Structural Analysis Professional 2015

[@vasiliyrohach3166]

Hi. Can you explain how you set the wind velocity and wind profile? How to set the wind profile when calculating according to EN 1991-1-4?

[@MultyKonstantin]

Интересно, а программа учитывает образующиеся зоны низкого давления?

[@darko2603]

Great feature especially for complicated structures!

[@ProMrAD]

Nice. It's always a little bite complicated to put the correct wind load in EN. Especially when the construction is not a typical one. We will see how it works :-)

[@FCHConsult]

Que fantástico!

[@khimpitou8862]

Does it work with ASCE ?

[@rithydany8089]

Hello sir! Can i get this project in dwg? Thank you.

[@tomaszduleba1314]

The module generates the loads incorrectly if the panels are not parallel to the global coordinate system! Map pressure is valid but final loads generated on panels are wrong - have a much underestimated values.

[@gmmgmmg]

are you sure?

[@tomaszduleba1314]

Giorgio M Just do the test. During the simulation you can see the resultant load of the wind. Compare it with the reactions.

[@ncotagtiam6562]

Thanks for sharing

[@MolotovWithLux]

#steelmonsters