Wire an IEC 320 C14 Power Socket with LED Rocker Switch - Arcade Build Series

[@mikeyfoofoo]

Quick and to the point. Still frame on the detail. Thanks!

[@WeBuildStuff]

thanks for watching!

[@sebleveille]

Funny enough that I also needed this for an Arcade cabinet I am building.

[@WeBuildStuff]

Glad it can help!

[@davegreen3861]

Excellent, just what I needed - many thanks.

[@buditan95]

Thanks man, i need this for building an my playbox (playstation box portable)

[@tonyt8796]

Thanks for the video, I have a IEC 320 connector with a noise filter that protrudes 2" beyond the face. The connections are made at the end of the filter. Do you feel its safe to mount this on a wood keyboard amp frame? There is no room to cut a hole on the metal surface where the transformer, electronics and dials/jacks are mounted. Because the filter is so long, the connections would be clear of the wood surface. Thanks again

[@paultinajero9733]

Your use two diferent sizes of faston terminals bro?

[@smartgadgets9347]

Sir may I ask what size of therminal did you use on this one the female and male therminal thanks

[@WeBuildStuff]

If you see the beginning of the video I chose my size based on the thickness of the wire and whatever ones fit over the metal tabs. They may have been 10-12 gauge or 16-14 gauge. Use the thickest ones possible that fit your parts. I typically buy a bulk set from my local hardware store

[@smartgadgets9347]

@@WeBuildStuff Thank you sir ☺️

[@aldinosukmana7954]

What if my terminal just has two cable, it still ok sir?

[@ianmcdonald7021]

Basic question: what's an "insulated quick connector"?

[@WeBuildStuff]

There are lots of different kinds. Insulated is basically just covered to help prevent short circuits www.pcboard.ca/spade-terminal-fdd2-250-insulated

[@ianmcdonald7021]

@@WeBuildStuff Thanks :)

[@Notlisted4u]

what gauge wire should i use to make the jumpers?

[@WeBuildStuff]

Between 16-12g. 16g is usually rated for light duty with 14-12 for heavier duty

[@jack4xxnew]

Depends on the maximum amp you are planning on using and the wire length. You can find a wire diameter calculator that tells what gauge to use for your application.