WOOD-MIZER Lt40, Lt50 Guide Arm Repair

Simple in/out guide arm repair and alignment for loose or damaged guide arm.

[@timklein8413]

Owned and sawed with my LT40 super for about 24 years and just learned something on alignment with your movie clip. Thanks for sharing. The woodmizer is a wonderfully engineered piece of equipment. Very durable and easy to work on. My mill still performs very well and turns out precise lumber but I am thinking about trading up for a 50 just for the (I think) better log turning chain turner and I think a little better production speed (I am 74 and need all the help in the speed department I can get)! Still great fun getting out there and breaking out a nice red oak and the grain is always fun to see when you brush off the sawdust.

[@jgcchapman]

Huge help thank you very much

[@davidmuncher1920]

Thanks for the video. Just bought a 2007 Lt 50 and watching videos to learn about maintenance and trouble shooting. I’ll be saving this video for later if I run into this problem.

[@halfshark101]

Lt50 is an amazing machine! Happy sawing! If you have any problems or questions, or would like a quick video made on a specific issue, message here and I'll do my best to help out!

[@jerrylittle8922]

Thank you.

[@aleahafrank5030]

I like your hands ;) what size is your wedding ring?

[@edowney5467]

I have a request. Could you make a video on replacing the bearings in the drive housing ( housing that has the belt drive wheel on one side and the drive side blade drive wheel on the other side). My mill is a mid 90's LT40 hydraulic with gas engine. Thanks for your videos, they are well done and helpful.

[@halfshark101]

Great suggestion! Next mill i have in for bearing replacement i will definitely make a how-to. The 90's style drive bearings are definitely a pain but i can save people a lot of time with short cuts and time save tips.