#woodworking

No video

#woodworking

Рет қаралды 176

Күн бұрын

hi~
It's Carpenter's Road near Daegu.
Today, we're going to talk about what 3D printer club requested.
I'll be the chief of the chamber.~
The upper box and the lower leg are separated... After hearing the shocking news,
After much consideration, this shape came out.
Form only follows function. lol
And there's an order for the box to be light and the legs to be strong.
The upper part is made of paulownia wood.
First of all, the upper box is woven with a fistula.
The front panel was punched out first, and the interior door space was dug out with a Lutheran table. Hah!
If you do it the other way around. I'm going to break everything down. Because I didn't get the books;;;
And the inside is caulked with silicon so that there is no air outside of the ventilation shaft.
Also, the part where the door closes, the chamber, and the top of the leg meet, I put a foam packing pad on it.
I've narrowed it as much as I can.~
We've got a flame spray on the inside for the fire. Hah!
In the case of the left and right back plates, you need to punch it with 120 pi.
They're going to install a ventilator.
Left and right are suctioned, and rear are discharged.
Filament, a 3D printed material... They say it's pretty unhealthy. Hah!
And well-done... Not to that extent, I did a rare torchburning.
I don't think the longitude is coming out as much as the Nakdong.
The literary man is a writer.
I put in 5T acrylic.
I heard you have to look inside again.
The bridge is made of bamboo.
I made a double angle with a tapered jig on my leg.~
Also, for the removal of the leg and the upper chamber,
Latch-type toggle clamp installed on left and right~
It's stronger than a cicada ring.
There's a disadvantage of the design dying. Hah!
I want to see how a 3D printer works inside.
I'll be able to see you after tomorrow's delivery. Hah!
then
It was Carpenter's Road in Daegu, where it's getting cold.