Working with a complex PerCutContour on the BN20

[@itsalimohamedali]

Thank you for showing the process! Very informative.

[@Lynn.Panadero4242]

The length didn’t bother me at all, because what you were showing was exactly what I was looking for. I didn’t realize that it was long.

[@reqless0ne]

Great video, did you ever realize your spelling mistake. Ordnance on main logo, Ordiance on the lower website.

[@cannachrissd]

Do you laminate your stickers? Also try out Briteline Vinyl from Grimco. That stuff is similar to 3m but without the bad smell. I don't even perf cut anymore and just cut straight out now.

[@C0UTZ]

Good insight into the intricacies of perf cutting. Side note... is it me or is the website spelled wrong? 😅

[@zumografx]

No, I think you were right on that one. I ended up correcting it for the final job.

[@joebenavides7258]

Great tutorial thank you so much.I been trying to figure out how to do a perfcut with my Roland bn20 and it always bunches up when it cuts.where can I purchase the 3m material I tried looking for it but no luck

[@zumografx]

Sorry for the late response, but make sure you pull out extra material at the very start of your job before you start a cut that will help keeping the material from bunching up

[@MrEldjhectic]

How or where can I purchase the 3M media?

[@benisikoff]

you changed the pressure for the contour cut not the perf cut...? does that do anything when there is no contour cut line? you have the perf set to 200 which seems high especially without laminate

[@brandogeberbin7563]

Wow, ever think about adusting the screw tip to let more blade out? Your dragging the head of the blade and not letting the knife cut. JUST WOW. If you dont know what your doing why are you putting a video out! And you dont know where your stop and start is on your decal for cutting!