Arduino Prototyping Outputs #83: DC Motors (H-Bridge)

[@damithtennakoon3239]

This was so helpful! Thank you so much. I've been trying to create an H-bridge using transistors but I kept running into overheating issues with them so this was super helpful!

[@MarcdeVinck]

Glad it helped! Even a dedicated IC can overheat, so make sure you have cooling if needed. And always check the datatsheets!

[@anthonytesta3716]

So the slip ring need a motor to turn the output end?

[@kuchalaggyan2502]

Sir, can you make a video related to motor deriver and their variant. Because I have motor’s ratings are 12V 10A, which motor driver would you use?

[@MarcdeVinck]

10A is a lot. I would use a motor driver breakout board. There are dozens available online.

[@kuchalaggyan2502]

@@MarcdeVinck Yes, you are right. But I am confused which one is the best from all this.