#XIAXIU

XIAXIU H650 RAPTOR with openTX Transmitter Jumper T-Pro

[@theoztreecrasher2647]

Works a treat, Pete! 😉 Now all we need is to see if Bob's servo expander idea will give us the correct motor reversing capability. 🤔 The servo linkages ARE pretty sloppy even with the stock set-up. Tightening them up should help. 😊

[@Retep12]

Yes, I have to shrink the holes in the servo horns with hot glue and bend the linkage a bit. I think the servos won't last long, so I'll install higher quality ones. I also saw the bearing play in the video. Still flies well.😉

[@RCBobOng]

@@Retep12 You can use slightly thicker rods as well. The stock ones are 0.9mm. I'm using 1.0mm rods with the stock servo horns, they reduce the sloppiness by a lot. 😁

[@RCBobOng]

Wow, very nice flying! I need to get some videos of it driving around the car park. 🤣 Interesting that the rudder has so much corrective movement. I assume that's from the gyro?

[@Retep12]

Yes, the rudder corrections come from the gyro. That was Acrobat mode, which I misunderstood.

[@adareone]

I just recovered mine today from the trees, the back motor mount wing broke of a the bottom of the fuselage. However two bambo skew stick from the bottom up and the last remaining glue that came with the plan its back into position. however my servo for the two flight plains on both sides of the tail is not working. Questions 1. where do I get more glue? and 2. where do I get another servo?

[@Retep12]

The glue "Uhu Por" is very suitable. Servos are 3.7g. You can get them from specialist retailers or from Aliexpress. Make sure they are waterproof. Other spare parts are also available from Aliexpress.

[@mike_t_007]

So how did the repair go?

[@adareone]

@@mike_t_007 the parts never arrived from Banggood to try out. Ordered a new plane

[@mike_t_007]

@adareone 😯 sorry to hear about that. Did you order the same plane or a different one

[@adareone]

@@mike_t_007 same one only in red