XK A280 P-51 Mustang | Unboxing | Review | Flight

[@AndrejSturm]

XK A280 P-51 Mustang: shorturl.at/QrQj2

[@StickJockeyFPV]

For lights on your transmitter, download latest multi-module firmware and install it on your transmitter. The lights will be on Channel 9 and use a momentary switch to go through the 3 light modes.

[@glObOfad365]

Would this work for Jumper T-lite? It doesn't have momentary switch but only rocker switch. I wonder if this can still work.

[@StickJockeyFPV]

@@glObOfad365 I don't know. A momentary switch gives a value of 100 quickly and then back to 0. Flipping a switch on and off might work in theory.

[@darkangel2850]

I would love to see the setup on how it was binded to the radio master and the switches setup for the xk A280

[@trevorsmyth8210]

you're a good pilot very good pilot nicely done you no what you're talking about

[@egertkabilattekivi2496]

Beautiful looking rc scale plane.👍👍👍

[@dano579]

Very good video! Very in depth!

[@dano579]

Have you flown the volantex 750mm mustang? I can't decide between the two

[@vincentcimino1963]

Andrej, did you have to change the plug in the plane to use those 520 batteries?

[@glObOfad365]

Did you encounter these... * Battery low power alarm ringing barely 2 minutes into flight. When you return to charge it, it's fully charged in like 15 minutes. * Plane goes into vertically straight up when in 6G mode, sometimes making vertical loops

[@joegaudin3535]

Did you notice that there is not much aileron movement in senior mode?

[@glObOfad365]

Are you using the receiver board that has an S-bus connector meaning the old board?

[@JBSATE]

😮parece bem estabilizado

[@StickJockeyFPV]

You have such a beautiful place to fly! I fly this plane FPV with head tracking and have videos of it on my channel.

[@kianwong4625]

Hi great flight. Yours sounds a lot noisier than mine. Is this due to the Higher voltage 2s battery, I run mine on a 2 blade 7x4, and 3s 45c battery and it works well. Ps where did you buy this 2s high voltage battery from -link please ? Thanks

[@gerochevargas5151]

Hermoso avión. Lo volaste en modo 3D??

[@AndrejSturm]

I have flown it in 6g and 3d mode, but mostly in 3d mode.

[@magneresjuan]

is this one better than the New Volantex brushless?

[@AndrejSturm]

This one flies better: shorturl.at/62pWU

[@Davide-vl7uc]

@@AndrejSturmso this bigger xk flies worse?

[@AndrejSturm]

@Davide-vl7uc The bigger one is less nimble and has less powerful motor. Otherwise it flies OK.

[@darkangel2850]

1 ? I have the same plane but I have a head time to set up the switches for it do you have a video showing how you set up that A280 on a radioMaster tx16

[@StickJockeyFPV]

SETUP Internal RF: MULTI, Type: V911S, Subtype: E119 - MIXES CH1-4: AETR, CH6: Rates, CH7: 6G/3D, CH8: Senior, CH9: Lights (if you have updated version of firmware) - OUTPUTS invert CH2 and CH6&7 if desired

[@darkangel2850]

Thanks for the info I tried it out and now I am flying with the birds

[@bvng2345]

Hello Andre, I also have this P-51 Mustang (XK A280) and a TX16S transmitter, but I haven't discovered the proper menu selections to get them to bind. Would you be so kind to share the setup configurations on the TX16S to allow proper binding and the various switches (except LED lights) to function properly please? I subscribed to your KZbin channel, so if you can post the TX16S configuration setup, I'll find it. I'm sure there are others who are also wanting to bind this XK P-51 with the TX16S. Thank you! Brian

[@StickJockeyFPV]

SETUP Internal RF: MULTI, Type: V911S, Subtype: E119 - MIXES CH1-4: AETR, CH6: Rates, CH7: 6G/3D, CH8: Senior, CH9: Lights (if you have updated version of firmware) - OUTPUTS invert CH2 and CH6&7 if desired

[@virgiliocarrilalvarez6638]

👌👍👌👌😍😎 Gracias.

[@blackrider83]

8:08 you don´t want to show us where the cables must be plugged in? because the manual says a shit about that!

[@alessiomorelli7621]

I don't know what country you live in, one thing is for sure. even in your country there is a lot of climate manipulation, the sky is full of chemtrails. I'm so sorry. a hug

[@DUCATI600CC]

Could be a good video if only one could understand what the hell the commentator is saying half of the time-----often just gabble gabble !