xTool S1 Full Wrap Laser Engraved Glass Ornament Tutorial with RA2 Rotary

[@SharonChico]

Instructions were so clear and concise --- loved it!!

[@winterwhitechocolate]

Beautiful!!

[@liciatoday]

Thank you!

[@GordonRock1]

You do very nice work, Licia! Liked and subscribed. 👍👍

[@liciatoday]

Thank you!

[@RichardM-r7u]

Great job covering the steps to engraving on the RA2 and tips for the best results. This is an S1 attachment I haven't tried yet so this was very helpful.

[@pamwiggins9447]

Great video! I've been looking for a video showing how to do this with S1. Glad I found this.

[@liciatoday]

Thank You. Take care!

[@houston360photobooth8]

Great job

[@liciatoday]

Thank You!

[@hangflyer907]

Great tutorial. I can't wait to try it.

[@nahnisjourney1406]

You have gotten really good at this! OUTSTANDING!!!

[@liciatoday]

Thanks so much!

[@nahnisjourney1406]

NICE!!! Very Creative! 🎄

[@liciatoday]

Thank you! 😊

[@jewijk]

Thanks for the video, great work!

[@ronr179]

I wonder if it got smushed together because you didn’t unit you only grouped it together. Whenever unit it starts from left to right and doesn’t jump back and forth

[@Ysalomet]

...Can you do this with plastic ornaments, too?

[@liciatoday]

Not sure. I have not tried.

[@Ysalomet]

OK thanks I have the S1/20w with the RA2... I haven't tried it out yet, either...😅

[@awildyoutuberappeared9325]

You can but be sure it's coated plastic and not solid molded ones. They both work but coated will gove you see through engraving while solid molded ones will just leave engraving marks.

[@Ysalomet]

@@awildyoutuberappeared9325 Ok thanks

[@claudiocioffi8978]

I keep getting a weird yellowish haze when I do anything near the sides, I have the same exact setup but near the rounded edges it really seems yellow and frosted not clear through

[@liciatoday]

Maybe it’s the type of glass ornament or sizing? Have you tried the material test array? I just did a video on the how to get the best settings for your laser.