Thanks for the videos dude! I just bought a yzf426 and the engine was completely disassembled. Now im rebuilding it with your help. Thanks again and im waiting for part 3! Greetings from Argentina. Keep it up!
@tonytnanbc3 жыл бұрын
What kind of oil are you using in your little oil can there?
@TobiBig893 жыл бұрын
Thanks, much help for my own rebuild!
@rikmoens776311 ай бұрын
Hi, we just bought our own YZ400F but with the engine not completely installed. In this video we see you put a bullet on the shaft before putting the bearing on top (at 6:25). In no explosion drawing the bullet is mentioned. Whey do you put it in? Thank for your respons!
@TheSkinnyboy12343 жыл бұрын
Did you cut the port holes in the casings? I see 2 walls between the crank have huge holes rather than the Tiny ones that come original 🤔
@tomatoknuckles3 жыл бұрын
Part 1 and 2 where great. Is there a part 3 finishing it off?
@wrenchmaster88893 жыл бұрын
Part 3 in on its way.
@justintrammell87452 жыл бұрын
Do your gears behind and on the left of the clutch basket have a lot of play?
@mike873643 жыл бұрын
Dood these videos are amazing
@paydirt3473 жыл бұрын
PRO TIP - counter balance shaft on the 450's (mine is 2012) need installing before closing the case back up. Followed this video and now i have to pull my case apart again and redo it all. Only other way is to remove a bearing, put shaft in then press a bearing on over the shaft. Doesnt seem plausible. Really annoyed. My own fault though.
@FullPayGaming3 жыл бұрын
Pretty sure you're done with bike by now. But what you could do for future reference. Order manual on ebay, and pause video and cross reference things with service manual. Im working on 450 too, 2008 tho and ever section Im working on, I use YT for visual help but also go through that section in manual to verify actual steps.
@matthewanderson77663 жыл бұрын
What are all the torque specs
@wrenchmaster88893 жыл бұрын
Refer to the service manual. You find them easy online for yamaha.