Yamaha XT350 ydis carburetor work

[@bultacochispa9861]

Congratulations!! Great job. I have the same model in Spain. It´s a marvellous bike.

[@halvardollikainen3999]

Thanks! I like the bike a lot 🙂👍! Just like the 50cc dual sport mopeds I drove when 16, just a bit faster 😅

[@mattdrat3087]

Ser veldig bra ut! Si fra når du har tid til å ordne min XT350😁! Takk for videoen!

[@halvardollikainen3999]

Takk 😊. Det skal eg gjera, hehe 😅👍.

[@DouweBuruma]

I think I have to do the same with mine. Takk før videoen.

[@halvardollikainen3999]

Thank you for the comment 😊. If I can do it, so can you. Good luck 😊👍

[@DouweBuruma]

@@halvardollikainen3999 Thank you!

[@thomash6055]

Overstunning clean carburettor 😅👍

[@halvardollikainen3999]

It’s the inside that counts 😅

[@tendsticksask]

Hi! I’m renovating a tt350 ‘89 and need to get a rebuild kit for the carburetor as well as that diaphragm, where did you buy it?? 😊

[@halvardollikainen3999]

Hi! Good te hear these old dual sport bikes are still taken care of 😊👍. Most parts that I replaced was original parts still available from a yamaha dealer. Strangely, the diaphragm in the secondary carburetor (right side) is discontinued and not possible to get new original part. Quite stupid, as this is one of the most likely parts to go bad.. that diaphragm I bought from a seller on ebay (after marker part), but it works great. And installation was relatively easy, as long as you dont screw up the glueing part (which I did the first try 😅). I think you will find a seller for a similar diaphragm by searching «diaphragm xt350 carburetor». Good luck 😊

[@tendsticksask]

@ thank you, i’ve found and ordered the parts from eBay as you said! Can’t wait to get it going 👍🏼

[@Xt350-fz6gc]

den låter att gå bra efter det jobbet

[@halvardollikainen3999]

Den blei litt friskare og sprekare. Kjekt når jobben gir positive resultat 👍. Sikkert rom for finjustering, men nå føles den sprek og fin å kjøra 🙂