Yaskawa GA500 VFD, remote control, MOP speed control, Multi frequency set up. English

[@sssssssssggggggg]

Late in the day Ingus - but you have saved my life. Thank you. I have a 22kw motor that needed to ramp up to 50HZ in 30 seconds. The load is heavy until full speed and no matter what I did - the drive tripped with OL/2 fault (over current for too long) I read the manual for multi speeds and it was defeating me. Your explanation and demo showed me how. I programed the speed sequence into a plc and paused between each ramp-up to allow the Amps to come down (65A down to 17A) It now reaches full speed with no OL messages. Thanks again.

[@martinxxo15]

Thanks for your explanation, wanted to know if you made the software video, didnt find it in your channel.

[@IFoundThisNow]

Hello Over there :) I wish that u make a video about using 2 different decelerations and accelerations, and use them for a 2 speeds. Regards

[@sajek4246]

well done 👌

[@josecarlosfranca6397]

Se fala em português seria mais facil

[@IGSElectronics]

Mas eu não sinto muito

[@lucasrramenda]

O cara é Americano.

[@خالدالقمودي-ذ6م]

Realy ! u do an afaviur to me ! Thanks allot