You’s a fine Ford Bronco, better back that A$$ up (tailgate reinforcement by Mabett)

[@GroovyGeek]

A couple of comments that would make realignment easier and safer 1) mark the original position of the tailgate with painters tape 2) support the tailgate with shims when removing/installing 3) mark the position of the hinges on the body with a sharpie, I believe they the countours are identical 4) be paranoid about the tailgate floating nuts, if they fall out you are up a creek 5) test alignment with and without the tire 6) another company has also stated that squareness adjustments (panel gaps) should be done with the 4 screws on the tailgate while tilt should be corrected with the hinger bolts. Mine arrives tomorrow, will attempt install this weekend. I only run 33s at the moment so doing this mostly for the looks. May put in 35s when I replace the tires a few years down the road.

[@shantbeezee487]

how's it been holding up? were you able to get it realigned with the tire on it? looking to pull the trigger on these. great video!

[@BroncosaurusTales]

Holding up great! No issues at all.

[@ThePounder001]

Great video. How long did it take to get the tailgate aligned?

[@BroncosaurusTales]

About 10 minutes, but honestly I need to do it again after putting the wheel/tire back on. I highly recommend someone help you with this part.