zero turn engine removal

removing engine from a toro 5000 zero turn

[@brownchapman2562]

Your video came in handy. I'm doing an engine swap this April. I love your shop and the lift that you are using is "bad to the bone". It would make the job a lot easier on tall old guys like me... LOL 😆.I hope the clutch that I'm dealing with comes off a lot easier... but more than likely it will not... Thanks for the video.

[@commercialmechanics09]

Thanks. Much appreciated

[@philliphall5198]

Merry Christmas Be safe winter is here again

[@commercialmechanics09]

You as well. Merry Christmas

[@commercialmechanics09]

I used a combination of pry bars. Lady's foot, 12" standard along with some pin point heat where safe. It took about 30 min why not in video.

[@philliphall5198]

At the price of new mower I see a lot of new engine will be installed this year

[@cousinfester4621]

What kind of "persuasion" did you use on the clutch? I'll be replacing the Intek on my Deere Z-trak in a couple of months. I have everything set in my mind on how to do it, except how I'll handle it if the clutch is seized on the shaft.

[@philliphall5198]

Start spraying it with liquid wrench now so it has time to work, spray every day