I have a 91 zx7 and all of a sudden have an issue with fuel coming out of one of the "T" connectors between carbs 1&2. The "T" connectors do not have anything connected to the end of them... basically just dangle down. I think vent tubes are supposed to be connected to them but I am not sure. Why is fuel pouring out of it and should there be lines attached to the "T" connectors .. if so, where should they run.. Noting in the manual about it. Thanks in advance.
@FRANKNITTY567 жыл бұрын
I wish somebody would show me how to take the carburetor off the bike!
@jesusber39975 жыл бұрын
Nise ayncing but could you show the readings better on tge sync bar. And what they might read different to each other. For example. +1,-1,+2,...
@mdbx6337 жыл бұрын
through the side of the frame there is a small Alan hole
@spadeguidingstar2554 жыл бұрын
Can you help with advise on getting my 99 to idle, please!
@mdbx6334 жыл бұрын
Did you check your ports under the carbs ?
@spadeguidingstar2554 жыл бұрын
@@mdbx633 Are u talking in the bows?
@mdbx6334 жыл бұрын
No undernather the carb intake boots there are test ports that need to be blocked off when you are not balancing the carbs, plus if your idle is wonky check your valve timing, check all ignition parts, I remember this bike was a bitch to tune if not fuel injected