ZX9R E2 Project, Ep 12, Going Back Together!

[@tonymontana897]

Is that a custom shock ? I may have missed something along the way. I don't see the piggy back reservoir.

[@HalfdeadRider]

Do you have a link to those spacers mate, might put one or two on mine when I get around to fitting my shock I reconditioned. Also if you want, check my latest video on ideas for your crankcase breather, I connected it to the KLEEN air system that I see you removed too, I also shimmed the needle jets, shew one being done in the video.

[@8713Thomas]

Yeah, I’ll have a look at that then! Cheers. Got them on eBay. www.ebay.co.uk/itm/M16-x-20MM-OR-25MM-O-D-303-STAINLESS-STEEL-SPACERS-BUSHERS-COLLAR-BONNET-RAISERS-/293751524683?mkcid=16&mkevt=1&_trksid=p2349624.m46890.l6249&mkrid=710-127635-2958-0 M16, 20mm od in 5mm increments. If that link doesn’t work, just search for m16 spacers.

[@HalfdeadRider]

@@8713Thomas thanks bud 👍 apparently they turn in quicker lifting the rear a bit, some people lower the front a little too, I won't do that though I don't think.

[@8713Thomas]

@@HalfdeadRider I have. 5mm. It does turn in quickly. A bit too much might hurt it though. So, I might not lower the front any more. Even though it would look badass. What’s your next job! I’d better subscribe, I didn’t realise I wasn’t! 😂

[@HalfdeadRider]

@@8713Thomas Maybe I'll think to do that when I fit my shock, a small amount each end. My next job will be the shock fitment, sometime soon, might film it, don't film everything like that. I also need to paint my top yoke at some point, and would like to refresh the front forks as don't know if it's ever been done. If you do subscribe, thanks 👍

[@8713Thomas]

@@HalfdeadRider have done. I just did a video on my front forks. Not too bad of a job. I also polished my top yolk. Brushed finish. Need a new ignition barrel as it looks terrible and key falls out.

[@reginaldgalluzzo5093]

𝐩яⓞ𝓂𝓞Ş𝐦 🌸