if you look this pdf , its programming manual for atv9xx series media.distributordatasolutions.com/schneider/2016q2/fef677e41765147443ac338c0ffc3ad128a2d0f9.pdf look for page 540 and 541 so you can see the Address of the first input word is 3201 (EtA) and Address of the first output word is 8501(CMd).

For me also same doubt

No it's not Modbus registers, it's IO Scanner address. in your VFD you set it up.

EL MOSTRO JAJA

@@MRKD_Studio El mostroo haha

Hi Preston, I have found there to be a slight improvement in communication speed when communicating via Ethernet TCP, however, I believe the limiting factor is the refresh/scan rate of SoMove which cannot be adjusted. But Ethernet TCP is better for other reasons such as the obvious - no more usb to serial adaptor cable, also if you don't have SoMove on your PC you can access the VSD web server to change parameters and extract the configuration.

Hi Moises, the procedure is very similar when using the Modbus TCP ethernet card on the ATV71 or ATV61. There are some small differences that you must be aware of. The scanner table will be a maximum of 11 words read and write, however the first word in each is a reserved word and needs to be ignored.