Charlie S

Пікірлер

@mikeford5106 3 ай бұрын

Excellent info. regarding fitting lab. seals correctly, .... thank you.

@bowman2108 3 ай бұрын

I brought the wrong spider injector, I need a returnless but the one I bought is set up for a return line. You think I could pull the individual injectors off the new one and put them on the old spider module…. ?

@triplecranks 3 ай бұрын

I would say yes

@rodneysteffen6376 4 ай бұрын

What are you doing at 2:55 - a few taps with a pin punch or center punch?

@triplecranks 4 ай бұрын

Makes sure sections two and three go back together with each other during assembly.

@paulsthormes251 8 ай бұрын

thanks👍

@jontg429 10 ай бұрын

Interesting, I have a Triumph 650 I am rebuilding, and my main bearing just fell of the crank upon disassembly. Mechanic wanted to knurl the crank, but I am thinking adding some 620 as well as knurling the crank. Do you think 620 i strong enough to hold the inner bearing races to the crank?

@triplecranks 10 ай бұрын

Yes. Better than knurling. Knurling provides about a 50% surface area to hold the bearings. Loctite 620 gives 100% surface area. A good machinist should know never to use knurling for any type of press fit.

@icarossavvides2641 Жыл бұрын

What am I missing? All I could get was how to fit a specific seal and not how they actually work?

@triplecranks 9 ай бұрын

I’m sorry. You are correct. I should have mentioned how the air has to go past the “speed bumps” to get from one side to the other. By the time it reaches the other side, it is being pressed upon from pressure coming in the other direction. The air just kind of bounces back and forth within the seal while running.

@pulipatisubhash6390 Жыл бұрын

Nice explanation

@JS2Tango Жыл бұрын

Great explanation, clear and calm. Thank you.

@julioolbera7431 Жыл бұрын

Would you know if I messed up the injector by pushing tapping it out the housing and damaging the middle part between the two prongs. It’s like wax sorta

@triplecranks Жыл бұрын

You should be fine as long as you didn’t rip it completely out.

@lukaswimmer7426 Жыл бұрын

This is exactly how I want my teacher to explain it. Thank you so much! You helped me a lot.

@turbobobby1 Жыл бұрын

nice, I was curious as to how those get lined back up when putting back together....I see those little pins, let's you know it is correctly phased. thanks for sharing👍