We can't see which top part of the spark plug you are touching with the probe. The center or the bent tip...
@ashleykelley201021 сағат бұрын
You’re my hero. I knew how to tighten the knob but must of taken it apart three times before I gave in and found your video. Easy peasy. Take that Moen
@je6019Күн бұрын
Worked like a charm. Thanks! The hardest part was getting the hex key in. Hard to see what you're doing. Probably took 10 minutes start to finish.
@mindyweaver9770Күн бұрын
How to set temperature
@texasRoofDoctorКүн бұрын
Great job. That is a solid fix.
@jeffmccurry741Күн бұрын
EXCELLENT DIY Video.... Thank You, Thank You !!
@Dty555Күн бұрын
A little knowledge can be dangerous. If you do a power down reset at the breaker panel, be very aware that power is available in the furnace. Its always better to check once too many than once too few. At the least you might cause more system damage than at the start, at the worst you or a loved one can be killed. Electricity is intolerant of mistakes.
@haldunn56742 күн бұрын
Wouldn't tapcons be better? Really not sure, just asking.
@kidanegzgabher92852 күн бұрын
OMG, it’s went off after plugged out the-ve battery for 5 minutes. Appreciate for your support and dedication 🎉
@kimpeter79342 күн бұрын
Like the tip of turning the screw counter clockwise.
@jamesfrank32132 күн бұрын
Check your bulbs aren't just out of position. My left side wasn't working, opened the cover, pulled the bulb out, the filament was still intact so as soon as it went back up the light came on. I immediately cancelled my order for LED bulbs for now since no need yet. Tested the button switch as well as the interior light mode switch and everything works! Still thanks for the video it was how I found out how to get started messing with it.
@kCD-x8u2 күн бұрын
My garage door will open with my remote but won't close with remote?
@jm91772 күн бұрын
Thx for the detailed video.. is it safe enough to leave all those extension cord splitter plugs exposed to rain and snow? Or, are there any specific precautions to be taken to shield the junction points/plugs?
@ChristmasMorning19952 күн бұрын
The element in mine only glows red sometimes and takes forever to preheat. Tonight I attempted to make cookies and the instructions said 12-13 minutes. I was cooking 45 minutes before I gave up. They were still raw
@certautotech2 күн бұрын
How about putting the leads in the correct places? They’re reversed.
@trumpzilla41932 күн бұрын
Dude thanks for making this video!
@Chris-jh3tg3 күн бұрын
Perfect.
@FrancisFreeman-g9e3 күн бұрын
I have a Kenmore the end of The wire for the light switch were the two screws are on the side that holds Gizmo is gone
@dane87613 күн бұрын
MY ENGINE CHECKLIGHT WAS ON AND I REMOVE THE BATTERY TERMINAL AS YOU SAID FOR 5 MINS AND THEN IT DISAPPEAR. THANKS
@mattwhite93983 күн бұрын
For those also struggling withe the clip that many need to remove before the bulb will turn: I used a 12" peg hook to depress the tab. The little bend at the end of the hook is perfect to reach the tab from the other side of the windshield washer tank. I was able to depress the tab, then reach in after that and pull the harness right off. One minute job after that to remove and replace the bulb and reattach the harness! Thanks to all the left comments about getting the harness off!
@CocoChanelle-13 күн бұрын
Wear a mask and eyewear
@nettiea93843 күн бұрын
Or Needs a new battery!!!!
@alwedworth4 күн бұрын
I replaced the plugs with stainless screws
@FiveEighthsWonder4 күн бұрын
Very helpful! Thanks
@Thebunholio4 күн бұрын
Thing looks ancient
@mk.christ26714 күн бұрын
It just happened to my car front and back signal are not working, I tried the fuse it still not working, what should I do next.
@HB-kp6rl4 күн бұрын
Tundras are the best bro
@Joel-j6j6 күн бұрын
Just a tip. Never clean or scrape a spark plug with a metallic instrument like a screw driver. It will leave conductive traces of metal on the insulator and the voltage will have a tendency to carbon arc across the metallic trace instead of jumping the plug gap and firing the cylinder. A blaster with a non metallic abrasive medium is your best bet.
@krispoli226 күн бұрын
Just the tip.🎉🎉😂😂
@El_LeChErO916 күн бұрын
Now my problem with my lennox furnace is slow alternating lights which is the watch gaurd with 3 potential issues. I cleaned my igniter and sensor both that sit in front of burners and nothing. You have any ideas? I come to your channel because you previously helped me with the high limit switch.
@michaelh.2737 күн бұрын
Roombas used to be excellent but the last couple I bought (I own 4) suck and so does customer service/support. I will be trying a different company in the future.
@matthewm15257 күн бұрын
Maybe you could add failed hypothesis to the end? 👍
@SgtHodl7 күн бұрын
This was a good explanation TY
@Mr.EeToMyself7 күн бұрын
I don't care what is wrong with it now.
@DCH-2227 күн бұрын
Heat shrink is right next to where you buy those clip/cap things.
@lynettedufresne78768 күн бұрын
Thanks for the video! Followed it and everything went fine! 😊
@davidsierra66828 күн бұрын
Can you tell us what that part/ part number is for the switch?
@Zoundz1238 күн бұрын
You do NOT need to tear the top off the dryer to service and replace the heating element. I was able to remove the front panel below the front door (four screws) then remove the screw that held the upright support. Very unnecessary work!
@billedinger718 күн бұрын
With all due respect what size is the damn Allen key?
@GrantHealy8 күн бұрын
You need to add that the allen key is 7/64
@rnbj11899 күн бұрын
Should we be concerned about cracking the tank when you fill it with hot water?
@princessue19719 күн бұрын
Gotta try this today! Thank you so much. The only question is, can I use WD40 if I don’t have the thing you use after the toothpaste?
@pyewhackett15989 күн бұрын
success, thx tightwad
@onetransmission78719 күн бұрын
The only way to check spark plugs is throw them in the trash can. Brand of new plugs is far more important. Some work. Some don't. Plugs can only be checked with the engine running, under load, on a scope. You've never worked one day as a mechanic. Please don't do videos.
@ColdPetRat2.999 күн бұрын
how long
@MelindaEmery-d4g9 күн бұрын
Thanks so much. This really helped.
@chupapi12839 күн бұрын
thank you, I put the insulation on the pipe outside AC unit,but left the wire that is on the side of pipe inside the insulation. Was it bad? is the thermostat wire
@regigilman22559 күн бұрын
Crank/start is definitely not the same as start/run According to the initial turn key to start sound like it's cranking but not starting/run
@Txepsiyu9 күн бұрын
My OCD was hollering to wipe off the chrome bumper edge. :)