Need to buy a new E-brake caliper for 1999 Miata MX 5 were can I find one seems harder than it should be...
@PatienceBristol2 күн бұрын
the red button is already depressed is it supposed to be up? or in?
@dcdad5564 күн бұрын
I've got a '91 and original owner. Heard in the day that the handle, without u touching the release button, should get 5-6 clicks for proper adjustment.
@rubenw27705 күн бұрын
This was so helpful man thanks a lot 🙏🏼🙏🏼
@quinlyeee6 күн бұрын
Touching tail light bulb with hands?
@MDHenry48 күн бұрын
Thanks
@fyaglidere10 күн бұрын
I appreciate that you unclogged that drain live first try and took us through the symptoms and observations during the process. Makes it much more natural for me to learn. The spare car guide is perfect too
@Souper-l77610 күн бұрын
My 91 b2600i started doing this today
@DissidiaDiogenes10 күн бұрын
I have a 97 miata but my problem is the lights keep going out, I can put them up and down but they just don’t light up but then light up again another day.
@jackiegraat440012 күн бұрын
Is it ok if I can only unplug 1 at the front and 1 at the back or do all 4 need to be open?
@mrheatseeker600312 күн бұрын
What is the relay next to the retractor relay, with the Light Green wire going into it. I seem to be missing that one
@TomMusick14 күн бұрын
Thank you. I have two 2013 miatas and this was the only thing keeping me from swapping the beat up silver interior stuff out of my SE for the black bezels & vents in the other car.
@zzrock998514 күн бұрын
Hi...could i use gasket maker to install back the iacv?.
@Skrimzey17 күн бұрын
Is the mx5 1.6 thermostat same as 1.6 eunos
@Biglouis82420 күн бұрын
Use painters tape around the perimeter of your light to protect your paint job
@ibraheemmonks886620 күн бұрын
Just made the mistake of jacking in the middle of the frame rail to be able to put the stands on the points you’ve shown and ended up bending it all the way in. I’d actually recommend jacking from the rear diff and/or front subframe to give you enough room to put stands under the frame rails. The frame rails are very malleable so ideally dont Jack up from them at all and be careful to put the axle stand full across the bottom face of the frame rails, otherwise when you lower the car the edge of the axle stand top will push into the frame rails and bend them in.
@egold207121 күн бұрын
My lovely '04 MazdaSpeed rode home on a flatbed tonight, dang it - 1st time in 20 years though, so we aite. I was driving home and the clutch pedal suddenly didn't push back as normal. Kinda flaccid. I coasted to a stop in neutral. Car wouldn't go in to 1st, or any gear. Clutch fully pressed, but it was like the gears were blocked off....? I turned the engine off, then ah...if I pressed the clutch in, it would go into 1st gear. Clutch still pressed... started the engine and it lurched forward and stalled. Hoping that the fix in this fine video is what I'll need... Any thoughts/comments n'at are appreciated!🤞
@davebeck473422 күн бұрын
Helped with my frayed 99 seatbelt replacement. The tips were very helpful. Thanks.
@micll322925 күн бұрын
Could you tell me the spec of the light bulb?
@STorm_Trooper26 күн бұрын
Miata Man- thanks for all your videos. They have been a life saver as I just picked up my first NB Miata this week. Question- if the rubber drain is degraded and torn, is it possible to replace it ?
@multo_soro26 күн бұрын
how complicated is the fix if the relay isn't working?
@martinlyons737326 күн бұрын
It’s not a parts car anymore 👻👻👻
@gami2k27 күн бұрын
okay i did the fuse but it doesn’t seem to have worked but mine was definitely blown
@pest213329 күн бұрын
That top part of the door panel is lose on my miata so i didt have to too anything else than lift it up
@user-nt8lc9lk5q29 күн бұрын
Can you tell me where to find the coolant sensor on a 2007???
@chrisnielsen9221Ай бұрын
but how do you get the door panel off when its stuck shut
@user-nt8lc9lk5qАй бұрын
Is this the same as a Mazda Miata MX 5 Touring Convertible 2007
@SurWrexalotАй бұрын
Thank you for making this video.!
@roberthagstrom259Ай бұрын
Lifesaver! My son just got a 96 na. Alternator belt turned to dust before we got the car home.
@stephanegenest6793Ай бұрын
Now watching 2024 it's about time to change it 4 a new video 😅
@oldmanwaughАй бұрын
I'm surprised you didn't tape off the surrounding?
@joegriggsjr.6511Ай бұрын
My car stopped going into gear. Like no gear would open up. This was the 3rd and final time within a month it did it. I opened up the shifter and there is no bushing on the end and I see chunks like particles down in the turret. When I got the vehicle, that shifter was getting really hot. I then popped it off and put a new boot on it. That helped tremendously. I recently changed the transmission oil and differential oil under the vehicle only recently. Now, that it doesn’t go in gear, I wonder if it is because I need a shifter rebuild? Mainly the bushing? Whatcha think?
@daylindrake768Ай бұрын
Gawd I can figure out why my horn has no power but I had airbags Your other video shows the headlight relay almost had the wires I was trying to see
@jspear98Ай бұрын
This is just the video i needed. The last owner removed the male connector and hard wired in 4 switches to make a push to start mod. Been looking for a video of the wiring pre rat nest
@michaelthomas7898Ай бұрын
Thanks Miata Man! The bulb is a 921 as far as the owner's manual goes, but your help is priceless.
@bundazliga9618Ай бұрын
I fucking love you!
@RC-ox9yxАй бұрын
Great content, I subscribed today! I have a 1994 Miata with the "R Package" 4,200 original miles. I'm the original owner and just retired. I'm going to start enjoying this little baby now. Great content, keep up the great job.
@rayrecklessАй бұрын
What a simple and informative video - just what I was looking for! Thanks.
@lyslou8956Ай бұрын
What would be a good ace hardware replacement for those housing bolts. Both mine have snapped? Also, my fan switch pigtails has snapped off. What was his fix on that a see a red someing in the switch? Thank you
@mnap89Ай бұрын
These screws are not philips. These are JIS. You can tell by the small dot on it. Philips is too narrow angle and it can slip, damaging the head and make it impossible to remove.
@yourusernamehereАй бұрын
Holy crap I can’t believe it was this simple. Months of annoying squeaky windows fixed in 4 minutes. Thanks!
@justinstatham6378Ай бұрын
Can you help with my 1990? Hello everyone I have a 1990 Miata 5 speed manual that I brought back from the dead after 15+ years of sitting. I have pretty much replaced almost everything. I am having a problem when it’s cold It is misses between 1800-2000 rpm’s. The longer you drive it the better it gets but it never fully goes away. Anyone have any suggestions on what to check. Here is everything that’s been done. New timing belt,water pump, hoses, plugs,wires, gas tank,fuel pump, coil, used Air flow meter, used ECU. I am sure there are other parts I am missing. I have checked for codes and there are none. Compression #1 202 #2 190 #3 165 #4
@MindyBurgeАй бұрын
I only have air coming out of the defrost vent and nowhere else. What would cause this?
@hungngo8075Ай бұрын
You're a good man for making videos like these. Thank you so much. I've learned so much and got some confidence to work on my NB.
@zhiquancao4751Ай бұрын
Just curious, why do we all choose 51R group size?
@scottsteibelАй бұрын
Thanks!
@wasabi-_-senpai2202Ай бұрын
So you can get away with just cleaning and replacing pump and running it daily after running seafoam and everything else to try to eliminate rust after pumping old gas out and vaccuming my miata is sitting in the same exact situation and i just wanna know if i can save it without habing ti replace the whole tank it doesnt leak it just foesnt start due to pump and im worried i got some in Injectores and engine last time it ran will i be okay 😢
@PeterHatch-mx7zcАй бұрын
Great build got 1970 M.G.B. would that set up work
@luisgonzalez3057Ай бұрын
Will a switch having this issue keep the car from starting?