The Touge RS getting new goods!

Do you have any recommendations for the dash? I did the first row of stitching with the long single piece of thread. Due to the constant friction, the tread freyed over time (didn't break I was careful) and it looks fuzzy. In shorter lengths it may be much better but I'm not sure how to hide the knots

The previous own put in some alarm now window don’t blink or horn. I want to put it back. But where do I start

My coolant cracked whilst on highway due to being brittle and pissed coolsnt everywhere. I have ordered new coolant tank and fluid. It probbaly lost 50%. Should i fill new tank with di water until its full then start car with fan to burp air out and refil to level if needed. Then drain the tank completely whilst on or turned off? And then close drsin plug and refill with nee mix?

Is there no fuse to pull?

Feo

Been stuck for 8 hrs trying to get the cup out of the transmission someone save me please

Thanks for sharing this video and it was very helpful 😊

Extra Crunchy like Jif! 😂

Might rev faster with the lighter fly wheel, you will loose heaps of rpm during gear changes tho .

Hello, "MyNameIdeasWereTaken" I was analyzing your channel and saw that in your channel have some problem, That's why your channel is not much growing and not getting much engagement, If you can solve these problems, Your channel will grow like a storm. If you tell I can tell these problems. Where can I tell? Here or ig or where?

Good job mike.

I've put plenty of miles on HP+ pads and never had any issue with shaking.

Any Idea what causes car to jerk when accelerating mostly when changing gears. V40 t4

Any Idea what causes car to jerk when accelerating mostly when changing gears. V40 t4

Hey, you mention wireharnesses in this video. do you know of anyone that sells the harness for the ignition coils on a SPA V60?

Quick question in mine I can’t put it fully in manual mode only half way in the slot and Gear 1 will show if I fully put it to the side it doesn’t switch it stays in Drive this happened when I had to replace the Auto trans shifter slide cover

The plug does not fit well after warm-up. The plastic like material tends to lose its rigidity.

You said the intake and exhaust solenoid is different which one is this, the code i have P0027/P0026 which sensor suppose to be replaced for Volvo C30 please response

Where do you buy the Porsche Crest?

I have a V50 AWD with similar mods. Have you done a 0-60 run with the AWD? It was already sub 5 FWD so would be interested to see the difference. My V50 takes 4.2 and yours will be lighter!

Shifter feeling, handling response, engine sound and seats are elements I love about my S60 from 2008 as well. Nevertheless I upgraded to the KW V2 suspension because the grip in fast corners was awful and the car was moving even at small bumps. It's a daily pleasure driving it.

Gmc is terrible, never more

thank you

Where can I get the rubber piece

Just got it replaced thanks so much!

Would this fit a t5 v50?

I cannot seem to find the first Arch anywhere online. Do you have a link somewhere of the one that you used on your car?

There’s only one drain plug? Do the Sti’s have two and the WRX has one?

What codes did you have ?

Actually looks better am just doing that but bc the removing the heating core :/ need the space to change it

So lucky that you found it !

At least you got to get a vid driving away sounds awesome

One question: If you do nothing about it, will it be dangerous?

I run the same Valve on my Volvo S40 works like a Charm 👍🏾

That v50 was t5 as well?

I Heard something about using the Diesel Engine Bottom End to Hold 1,000 Horsepower on the T2.5 i5

helpful, thanks :)

I just shook a new one and it rattles too

How do i compress the suspension?

How did you make it awd??

It looks like you pull out the rubber piece that goes through the firewall. Do you reuse that or just run the new line through the firewall?

0:18 nowadays with the d5t5 vdd obd2 dongle you can reset the codes yourself from an app on your phone, just pay a small subscription fee for the carrier signal from inside that dongle.

Great video! Have you had any challenges with install? Currently struggling to get the replaced axle to set / completely go into differential. I assume it’s my c ring not being aligned but your axle went in so easily I’m wondering what I may be missing? c30 m66

Fuck yeah man. It's great to see another with so much enthusiasm for the C30, still active and bringing knowledge to the community. Hats off to you!

Wow very good job thakns

Just here to say thanks for the super quick video!