Type r isnt stock tune.. i walk them in my ko4 beetle turbo.. same with snackpacks
@eliasfloresramirez40048 күн бұрын
Amen in JESUS name.
@AlexMK78 күн бұрын
@@eliasfloresramirez4004 Amen brother🙏🏼
@Justin-hh9ro15 күн бұрын
cheers mate, worked on my ‘99 328i (Aus delivered so technically still OBD1)
@regievillanueva191921 күн бұрын
Awesome, worked for my e36 320i thanks a lot. 👍
@1jasonz1Ай бұрын
Had a 2015 autobahn dsg, and currently have 2015 autobahn manual, no question prefer the dsg, too much lag in the manual transmission.
@rudydaberry122Ай бұрын
What are the best brake material On mk7.5 GTi?
@startodo2 ай бұрын
Very helpful thanks very much. 👍
@joaocostapt162 ай бұрын
Worked in a ‘98 E46, thank you ❤️
@undutifuljet65693 ай бұрын
Can safely say it works
@GregKos19964 ай бұрын
My first thought was it can't be real but it actually fucking works 😂😂
@lasrazonesdenuestrafe14174 ай бұрын
Did the preforms clutch make the clutch pedal hard? I have that issue.
@user-vn6bt1br8o4 ай бұрын
Have you installed i-boost controller? And if you have is necessary to install a bigger map sensor.?
@rudydaberry1225 ай бұрын
I have a mk7.5 gti and it’s stock because it’s still under warranty for a little bit longer. Do I need to mess with internals when going stage 2 or doing is38? I don’t want to blow my car up
@IsaakMK719 күн бұрын
No its pretty safe
@larryracer87236 ай бұрын
I haven’t installed my down pipe yet. Does anyone know if an integrated engineering stage 2 tune makes the check engine light go away?
@larryracer87236 ай бұрын
I got the same down pipe. I can’t fucking wait oh my god
@MrGordoxD3 ай бұрын
Did you get any check engine light after you installed?
@MoroccanAnwar6 ай бұрын
Wow that easy, they quoted me £350 for this 😂😂😂
@orcahang216 ай бұрын
Good 👍 ASS job Brudda ✌.
@chaseteter4 ай бұрын
🏳️🌈
@lrdez63406 ай бұрын
But please where is the place of this speed sensor in bmw e36 gazoil
@nxvii8507 ай бұрын
do you still have the mufflers on it?
@jefmk72277 ай бұрын
Hey Im trying to figure out from where i can run my cables from the gauge to the sensor,my clutch pedal is there .. did you drill a hole or you remove clutch pedal to be able to run those wires
@dr.ali.mualla7 ай бұрын
Thanks it worked
@suneilkumar8 ай бұрын
Thanks for sharing. My MK7.5 is at 60k and I had concerns about carbon build-up since the US Gen 3 doesn't have multi-port injection (direct only). I'll address this if/when the water pump/thermostat housing needs replacement.
@DarkLilika8 ай бұрын
Thanks you showed it was possible without removing the steering wheel. I didn't like the idea of doing that from other videos. Ima give it a go 😊
@iroquoispliskin42638 ай бұрын
You used 75700-S5T-E01 on your rear. It was actually made as front emblem of EP3. There’s one made for the rear which is 75701-S5T-E01. Have you tried that?
@outlaw83889 ай бұрын
Mine dosent light up.
@nightynine40619 ай бұрын
Thanks man. You explained it well. Rather than just blastic music and saying its done!
@WhiteCheddar.10 ай бұрын
You skipped a step player. Youre supposed to drain the excess while the car is running.
@christianozuna11678 ай бұрын
I did that when I saw your comment and know I don’t know how to explain this to VW and let them know I found a factory defect on their dsg transmission, it’s making an stupid noise when I go reverse.
@WhiteCheddar.8 ай бұрын
@@christianozuna1167 I just did mine for the 3rd time 115k miles. Ask dap shows how to do this
@mr.adventure55911 ай бұрын
I like how it doesn't have much of a whine that is typical of roots type superchargers.
@ryanlewis693411 ай бұрын
Are you running any tune?
@tazandtko971611 ай бұрын
Is that the 7 speed dsg or the 6 speed dsg? pls answer
@fabiovelosa382211 ай бұрын
Completely wrong way
@bm_wuratli68838 ай бұрын
can u tell me step by step what to do pls karai? and which part he wrong?
@fabiovelosa38228 ай бұрын
@@bm_wuratli6883 you should drain the excess oil on 35c to 45c that is the reason gearbox start jumping gears and start clucking noises
@bm_wuratli68838 ай бұрын
@@fabiovelosa3822 ok thx
@RSXengineering2 ай бұрын
@@bm_wuratli6883 Put 5 liters in, get the gearbox to about 40deg C and take off the first drain plug again. The excess fluid will come out, wait until it comes down to a single drip and torque it to spec. You can read the DSG temp with an OBD11.
@yacco994611 ай бұрын
I pulled the sensor out i found it dirty cs of the old greasy oil i jst had 2 clean it replace the oil than it's ws gd 2 go
@loganbenson867511 ай бұрын
setup is so clean!
@Vgk36 Жыл бұрын
0:49 Pin 7&19. Thanks buddy it worked.! 0:49
@KAfilmmaker Жыл бұрын
so there is no more dsg fart?
@ajisai12 ай бұрын
It’s manual
@leeeooo6051 Жыл бұрын
Can i use these on stock rotors?
@antonioescalante3644 Жыл бұрын
thanks baby
@Baskarrenmaar Жыл бұрын
Nobody can help me, I have rotors and pads from EBC but it’s making a really crazy sound when I bump into the brakes a little to much. Every time. It’s also smelling and smoking a bit after you push it some more (golf 7.0 gti) standard. No tunes
@thebmwdudebrah3448 Жыл бұрын
WORKS 100 % make sure you insert into 7 then 19 and the holes,,,,dash is off and key in your hand then insert wire ans count 12 seconds seems to work for me. E36 FOR LIFE YO real BMW old school
@mostafahassan6230 Жыл бұрын
Stoptech Rotor can u tell me is good or not before used it ?
@kylevanhorn236 Жыл бұрын
can you post a link to the spacer you bought
@peterelmer9114 Жыл бұрын
Just did my 95 E36 328i Touring - worked great 👍
@JimMcBob42069 Жыл бұрын
Is mk7 bleeder block same as mk6?
@ultrajazz5335 Жыл бұрын
You can’t beat a manual transmission!
@verdeithaca Жыл бұрын
Thanks for the vid man. Doing this job tmrw on my '17. And pro tip.. Tell your pops not to leave the heated mirrors on 24/7. I noticed that toward the end of your vid. It'll melt the glue holding the glass and they can just fall off. I've seen it many times.
@modelaircraft6576 Жыл бұрын
Do you have an airplane in the garage
@modelaircraft6576 Жыл бұрын
I got few bolt ons, dv, intake, throttle pipe, turbo muffler, an turbo outlet. I’m running lean, and I was thinking of a fuel pump upgrade. Did you tune your ecu for that upgrade