Awesome thank you! Most informative I have seen

What an unbelievably, informative video. I have installed firmware for the second time with my lowrance, and it always seems to malfunction after I do. This video, was fantastic! Fixed all of my problems. The people at Lowrance, bless their hearts, seem to be lost in the sauce most of the time. I'm done wasting time on the phone with them. I'll continue to watch your videos and if there's something that you don't cover, I'll certainly be calling your shop directly. Thank you, very much!

Amazing! The service configuration mode steps is exactly what I needed!!!

My head sensor went bad how to you replace that ?

Great video. I'm seeing a lot of reports of the head sensor going bad. Can you do a video of replacing that?

What if head arrow flashing and nothing works ? No sound just flashing .

What was the issue with this motor! I can not follow routes or spot lock. I hit anchor and it will beep 3 times fast. I have purchased 3 tmc1. No luck

I am having issues with my ghost just powering off for no reason. usually happens at the beginning of the day but not always. And usually when its hard left or right and you initially step on the pedal. It powers right back on and works fine. Would this process help that? I also heard you mention a positive stop, mine hits a positive stop both ways, is that not normal? Thanks so much for your help!

Based on Lowrance instruction kzbin.info/www/bejne/l6bcdoCGbsurb9U&ab_channel=Lowrance , they align the direction with the boat and not with the lowrance sign on the trolling motor which is confusing.

I am having issues with my ghost just powering off for no reason. usually happens at the beginning of the day but not always. And usually when its hard left or right and you initially step on the pedal. It powers right back on and works fine. Would this process help that? I also heard you mention a positive stop, mine hits a positive stop both ways, is that not normal? Thanks so much for your help! Bill

What if your trolling motor is 36 Volts?

I've been waiting for you 2 years, a good man! Thank you!

Thank you! Awesome video, Great Information!

How long should it take when u reset it when it's flashing between 24 and 36 volts.

Best damn video. Thanks guys

Could you maybe do a video on how to calibrate the Spotlock again for those motors who go crazy while in Spotlock

Thanks very helpful

What would cause water to get into the head and fry the boards. Ive gone through two boards now and lowrance wont fix it under warranty. First time it went out, i replaced the rubber thinking it might have a pin hole. Put new board in and 4 months later, trolling motor stopped. Took head cover off and full of water again. Board was toast like the first one.

I am having a problem with my spot lock turning off, after It does this when I hit the anchor button again the direction arrow on top of the trolling motor flashes and no spot lock. Do you think doing these procedures could help this issue. Thanks

I’ve called these guys with an issue I had and they went overboard helping me solve my issue! If you have a problem with your Ghost give them a call!

Awesome video, really well explained!

Great video, thanks for posting!

Thanks for the video!