What is that red adjusting cap?? Brand name where to buy..?
@reedjensen4355Ай бұрын
Best step by step video I have come across!
@paultaylor78712 ай бұрын
How did you dry the inside I know silly question
@Dontreadmyprofile0.02 ай бұрын
Second this!
@JayMaverick2 ай бұрын
Hairdryer? Or just connect it to the car. A bit of water vapor won't hurt your turbo.
@jonathanbell79483 ай бұрын
Did you have any issue or did you prime the engine after the next pump install
@Anthony12valve440RB3 ай бұрын
What did you do for the throttle cable since the early trucks have the round hole on the fire wall
@meaganhope62133 ай бұрын
You can put a pin in the tensioner as well
@jaimescott86274 ай бұрын
0:36 😂great video man thx will help a lot with my 30 year old volvo intercooler
@mutantryeff4 ай бұрын
Should have considered installing the Cummins 8.3 oil pump converted for a 5.9.
@pixlbunz5 ай бұрын
good shit buddy, love to see the way it turned out about to pull my intercooler out and clean as-well. another product that works really well for cleaning the oil out is denatured alconhol!
@restauradorcaseiro5 ай бұрын
Gasoline does the same job!
@user-td8uh9yq4jАй бұрын
Gotta be careful with gasoline to make sure all the fumes are gone
@user-xt2sz4xh7c6 ай бұрын
3:38 I like your video! Could you share a link to where you may have acquired the throttle linkage from? I am doing a p-pump 2nd 5.9 swap into my 1st gen. I am struggling to figure out the throttle cable connections. I have cruise control as well. Dave
@Raccoon_cajun4206 ай бұрын
Crankshaft pulley so crazy!
@Raccoon_cajun4206 ай бұрын
Nice!!! Old school more better!! And that ain’t look bad work hard than worse stupid now 🙈
@JoseSandoval-ic5xe6 ай бұрын
Hi nice video did you see an improvement in power after the cleaning?
@AlexB-cn2lo7 ай бұрын
I've been looking at intake elbows on the market and saw this type, looking for a review! Also, you made this look easy but the p-pump & lines were all disconnected so I am not sure if the process is truly that quick or easy?
@mileauxАй бұрын
removal and replacement of the intake horn and plate is not a hard job. the pump stays in place and sometimes you can get by, leaving the fuel lines but removing them is hardly any trouble. on these dual style horns, slight bending of the lines may be required for clearance but it is nothing crazy. they do sell aftermarket lines for dual intake horn setups but they are pretty expensive.
@fabianflax74827 ай бұрын
Great video, keep it coming ! 👍🏽
@JD_HANNAH Жыл бұрын
Thank you for the in depth video I just have one suggestion remove the music in the background as it makes it difficult to hear what you are saying since the music is much louder than the camera audio or if you want to keep it in just lower the volume on it significantly. Hope to see some more videos on the 2.0 TSI in the future.
@BlueDevilGarage Жыл бұрын
Thank you! I apologize for that, I didn't realize I left audio where I was talking. Do you have a VW with a TSI in it? If so do you have any recommendations of something you'd like to see?