Bro how did you do this??

Nice bro!😎

The "hidden" bolt has a 12mm head.

How much did you make after this

Did u lose all your coolant or only some?

slayyyyyy!!!

where did you brace the car to be able to lower the subframe?

if you're gutting these cats can you not just leave them on and take out the honeycomb shit without having to remove anything else just obvious things obstructing downstream ends? ie if reusing them?

How did you get the inside bolt on the passenger side for the cats to the headers

Smart way to do it tho.

Hey someone with the sense to show the mechanism 👏

Any updates? Hows it holdin up?

compound your headlights to make them clear again

Clean!!! 👍💯

Does this mean the catalytic converter on a 2015 S5 is hard to steal?

Can I get your ig or something bro I just have a few qustions

Those bolts looks fishy. Any issues after 3 years?

Don’t try this shit at night I got frustrated lmao 😭😂

☝️ P r o m o s m

looked good man. your strong very strong hope i can be like that one day

Looked clean man. Start doing pause reps and you'll get through that sticking point

Thanks Kings! 🙏

Clean rep! Good work

Stud

Good shit bro happy for you

Clean

clean form well done

get it, bro!!

How does it still run, planning to install same pump on my n55 with e30 tune.

Nice form

Gear?

This is priceless man! Thank you !!

I tried this procedure but it didn’t work for me. I can’t remove the rear bracket but (12mm). Need a deep socket and there’s no enough space between the nut and the car frame, even I used the wobble extension. So I decided to removed the A/C Compressor.

I was looking for a video for a q7 flex pipe which is more difficult to reach than yours……I’ll pay the $850.

I drive the audi s5 3.0 tfsi 2010 it smokes from the exhaust it stinks of exhaust fumes can it be because of the catalytic converter?

Imagine if they had not to put that drain there what type of fires would be caused

Did you have to drop the engine to replace the rear main seal?

did you rotate the connector to fit the original plug or jsut plug it in with an extention?

Hi! Why did you have to replace them? What was the problem with the old cats?

Hello, How long did it take to replace the right catalytic converter?

Hello which aftermarket can I buy

N55 e series?

Use a ratchet strap for the passanger side to get more space

How can you remove the bolts from the exhaust manifold?

Slick! Two thumbs up on this.

I dont know if the S5 is the same as the Q5, but to access the inside nut and stud for the passenger cat. remove the tire,fender liner,heat shields for the axle shaft. then you can easily get to it without touching the trans and subframe. Did this on a 2011 Q5 3.2.

How did you connect the connectors?

Hey are you able to see the oxygen sensor from the engine bay ?

Hey man, did this end up working? Because this operates at a much higher pressure than stock

Part number ?