This can all be done in 10 minutes from below the car.

Very good job thanks 👍🏻

Thank you!

Ok

Okok

I want to upgrade the big 3, I do t have all the tools to do this. Does the gaskets need to replaced also when removed? Will it hurt anything at all to just leave the old 10 gauge wire that runs from my alternator to the starter? The lead goes from there to the battery - starter --> to alternator.

👌👌👌👌

👍❤️

Very good I look

for some reason whenever i go to youtube i always end up finding videos that are for the 3.6L aura and i have the 3.5L xe

That was a good video congratulations sr

Grate video, but I'm just curious if you had a fule leek because the Orings in side in the connection housing are usually cracked because Rubber just doesn't last that long. Just about everything plastic underneath my 2006 is cracking. I have to do the same job, and I'm definitely gonna do it myself based on your video. You made it look easy, but I noticed there were some cuts in editing that concerned me on pulling everything out Because the last time I tried to do a pump removal on a Mini Cooper The pump housing actually had to be screwed in Without any bolts like the Nissan has which makes it so much easier, at least that's what I hoping. I never want to ever have to put on a fuel pump for a Mini Cooper ever again. I still have not been able to take the top off my Mini Cooper fuel pump housing... LOL I really would love to see how you change a starter on this particular car if you have a video please let me know I look forward to seeing it. Anyway keep up the good work you got a new follow

Good job

Thank you for an actual car fixing video with the labeled chapters. Although I still can’t find out what’s up with my car, I appreciate the help!

I use repair videos for the sake of short cuts. I’m his is not one of them. You can access the starter easily from under the car. 20 minutes tops. This is way too much work and liability. You could break bolts.

where's the Pressure Regulator ? 2005 has the PR inside fuel pump housing

Thanks!

So we remove the manifold to just test the starter?

I need to find the air drive switch is on a 2000 mercury mountaineer 4.0 4 wheel drive

Thanks

Saturn Vue same everything else,”.. gave me the absolute hardest time of my life. I was hoping the Jack would fail and put me out of my misery

Good

Doing this procedure tomorrow! Wish me luck

This is good for the 3.6L. For the 3.5L, I'd recommend another video. The other video is the procedure to replace the oil pressure sensor, but you have to remove the starter to get to that sensor. So it has great instructions for it. kzbin.info/www/bejne/fJ-zaXZtqplmrNU

Master slave

You don't need to take the manifold off just waste of time

i have a 2006 mercury monterey , 87k miles on it. out of nowhere beginning to stall. battery is fine , engine stalls , steering gets tight and breaks freeze up a bit. any help would be appreciated ?

Dude Thank You!

Thank you so much. This really helped on what to do and what to expect... I read the comments before doing this and 100% easier going under the car...but seriously thank you this helped a ton 😁

Idle Relearn procedure missing...

mike, how can I make my saturn aura XR 2007 3.6 more veils and replace spark plugs with irilium ones, what more basic things can I do to make it faster? Thanks for your video. I'm a new subscriber

Mike tu video me sirve mucho tengo ese el 3.6 XR

Too many steps... all you needed to do is test the fuel pressure, and it would tell you everything without breaking down 50% of your car.

Really helpful video. Please, can you tell me where fuel filter is in this car, and what kind of filter is? thank you

Not sure how different the 2007 is from the 08 but I did not have to pull the exhaust manifold. Pulled the knock sensor, unbolted the starter and took it out.

This video went from most helpful to not helpful at all real quick

Great walk through bossman appreciate it..gotta gt to it now..thanks again

Just take the cat off and grab it from the bottom

I changed my altinator and my battery is still dying or it getting drain of it's power. The battery light turns on what can be causing this to happen.

Your information is good but your sound is not

Very good video i think it's all the similar until 2018

Pretty good video Will try to do it.

PLEASE DO NOT FOLLOW THIS REPAIR ADVICE!! Sorry Mike - the diagnosis advice is fine, but I just got done replacing my Saturn Aura XR starter (3.6 lt eng.) and starter is 100% accessible for removal from the bottom - it is up and to the driver side of the oil filter. Both bolts are fully accessible as well as plug and battery cable nut. PLEASE DO NOT REMOVE YOUR MANIFOLD TO PERFORM THIS TASK - totally unnecessary- this was just 10% harder than an oil change and is definitely a DIY on this car and motor! Heading back to Advanced Auto to return the manifold gasket I bought and thankfully did not need!

Great video nephew. I'm proud of you

hey bro is there any way to tell the difference if the starter is bad or if its the Electronic Control Module, without any diagnostic equipment? or test light? Battery is good and cables tight and clean, no crank, no start. feel like its gotta be starter or relay / ECM

But you do not have to do anything at all to the exhaust or manifold to take starter off

hey Mike I did enjoy the video and looking forward to the next one. As much as I like the music it is very distracting as I have never really seen someone pulled apart an engine like you do.Please speak and help understand what your doing. I am pretty confident that you will succeed in sharing your passion and knowledge. I am a very novice Diy beginner type..I am rebuilding my fuel pump following your built. I'll know tomorrow if I did good. regardless it's a good video. cheers!!!

Same as the saturn vue v6?

👍🏼

Hey bro great video but i have the problem with my 2002 ser sentra but idk has the same problem but it was brand new the fuel pump now doesn't want to start what would recommend me to do with it?thank you