He already has aftermarket skid plate and motor plate so why go through all this trouble for something that's going to rot out eventually I have to do all this again just put a new one on there aftermarket if possible much t h i c k e r
@micmacpole8 ай бұрын
I find that the POR15 gas tank sealer which is a silver color works better than the black POR15 as more of a permanent sealer which will fill and seal pinholes.
@queensapphire7717 Жыл бұрын
They should put some drain holes in the lowest part, water pools in there, that’s why rust out. Power washing would help too.
@queensapphire7717 Жыл бұрын
I don’t care if electric related or not, I always disconnect negative battery terminal when doing any work where I need to disconnect a harness. 18mm bolts hold the skid plate on. I’d “Blaster” all the bolts the night before so they can soak for 12 or so hours. I just actually scraped and wire brushed mine and painted with some Rust inhibitor, but plan on replacing soon.
@macktaylor43892 жыл бұрын
Thanks for the good help on removing the tank, I have to drop mine so I can remove two broken bolts from the rear floor seat frame attachment. Next time you have rust like that to remove borrow a 4” angle grinder with a wire wheel or cup brush and blast that crap off there a lot easier.
@worththefight61542 жыл бұрын
Dude. Thank you. Great video. Thanks for taking the time.
@Tegz223 жыл бұрын
Pittsburgh Jk here as well. my skid plate is rusted and got flagged during my Pa inspection. You think i can just put on a Rough Country skid plate OVER the rusty factory skid plate and be ok? RC skid plate has great brackets that reinforce over the existing plate.
@Tegz223 жыл бұрын
Oh which impact wrench did you get?
@gabefigueroa96482 жыл бұрын
Yes you can
@MT-rg4dm3 жыл бұрын
Can you drop the skid off of the tank without removing the whole tank?
@gabefigueroa96483 жыл бұрын
Theyre bolted on with same bolts. Its possible. But itll actually be even more work. Might as well take the tank out as well.
@lesstraveled47403 жыл бұрын
Great video
@scottstewart22643 жыл бұрын
The evap line that goes to the white fitting. The one that people have issues breaking. Can you just detach that where it plugs in near the fuel filler line? Instead of detaching it at the white fitting on the tank? I’m trying to avoid breaking it.
@will38212 жыл бұрын
Is this what you’ve done? I’m dropping my this week and this is what I was thinking
@scottstewart22642 жыл бұрын
@@will3821 I can’t remember now but I think so
@jasondevereaux33694 жыл бұрын
Make your own trail!🤙🤙 gotta love the 2 drs and xjs
@mrhoya144 жыл бұрын
So which one is the fuel pump? The one on the upper part of the tank? Or the one thats on the center
@gabefigueroa96484 жыл бұрын
The fuel pump is the circular part on the top of the fuel tank that all the hoses and wires go into.
@mrhoya144 жыл бұрын
@@gabefigueroa9648 i think mine is going out.. Cant find anywhere on how to replace it
@mrhoya144 жыл бұрын
@@gabefigueroa9648 did you depressure the fuel system before removing the tank? If so how did you do it