What are the symptoms of this battery going bad? And how long does this battery last?

i even took my tires off.

Thank you. Worked like a charm. :)

Thanks for the useful vid!

Bingo! Worked like a charm :) Thank you kindly, sir!

This was very helpful some videos just skip steps.

Thank you very good video I am glad I found it I was about to take the bumper off . .

This works great. You don't need to pull off the whole front off. Just reach in and untwist the socket, untwist the bulb and get a small screwdriver or something and pull up the contacts.

Noted I see bcz mine the gears are not entered and when you shift gears having a noise

Good info, thanks. On a 2017 Im working on bolts are torx 27s. Also for push pins, use a pick tool and try to pull the pin up rather than push it down. So you pull the pin out and pry the other part out. A trim tool with a split in the center is helpful.

Thank you sir for your info on this ! I repaired one today just like it ! From a fellow mechanic may god bless you and your family ! Thank you

Good 👍 one mate

Thank you! Helped me fix my ongoing issue on my 2017 VW Tiguan.

Literally I just did this and it worked. Now I don’t have to drive with high beams all the time 😂

I recently changed clutch and master slave clyinder in my nissan juke but the gears often get stuck and i have to pump the clutch few times to make it work again. Any idea what can cause it ?

Really worked thank you!

Do you know what's the part number by any chance ?

Thanks a lot for sharing. May God bless you.❤

My hyundai is is blowing hot on one side and cold on the other. Could it be the actuator?

Great video! I can actually see and follow along

Yes! , under extended warranty.

This was established a year before you posted it. So your remaking another video all ready covered. Be Original. Sloppy

Thanks for your support

Wow! I wasn’t expecting this to work for my daughter’s 2014 Passat, but it totally did. Nice video. I’m grateful for folks like you on you tube. I would have spent day tearing stuff apart and tracing back wires and who knows what else, and I still would not have done this. Thank you!

I love KZbin because of people like you that share their knowledge to us the common man or woman. Thank you so much this worked a treat.

So if this doesn’t work where is the fuse location for the low beam right

Great job

Mghribi la?

That's a Malibu.

Great

You keep saying actuator. But is it the blend, mode, or recirculating actuator? I believe I need to get the mode actuator, but part dealers use the names interchangeably, so it's hard to know if I'm ordering the right part.

Not only Camry, all the Toyota with electronic power steering hav this issue

@Autofix Repair where are you located? I need this done on my 2013 camaro

Thank you I’m having this same problem. I saw a commenter say this will cause the battery to drain, is that true?

How do you do the reset?

Going to try this but wondering, how’s it holding up for anyone that did it?

My air in my 2013 Elantra comes out cold to hat from my far right vent being the coldest the middle kinda cold and my left driver one warm!? So you know why? Thanks

I have the opposite problem. Only hot air comes out of the driver side. Cold and hot air works in the passenger side. Any tips?

You're the man! Great fix, no one else suggests this. They say grounding wire or grounding point, but never ground tab in socket. Worked great thank you!

Great job 👏 🎉

Sir that's not the heater core it's the AC condenser trust me I stabbed it

Left headlight only. Right one apparently requires removal of the air filter assembly first.

Who tf flatlining in there😭

Got a used q5 and the bulbs were nearly worn out. Thank you for a tutorial and actually showing where everything was. Not having to pay 500-700 for labor is worth it

Thank you for this, saved me a ton of headaches this morning fixing these after they went out in my wife’s car last night.

Yo tengo el problema de que sale calenté del lado del piloto y frío del lado del copiloto pero lo demás funciona bien alguna idea de que pueda ser?

Helpful video thank you

QUESTION: am in the process of doing this repair and have hit a snag. The shaft on the actuator motor won’t align with any position that I can adjust the newly installed blend door. It's just slightly off but enough where I can’t even re-bolt the piece on. I’m thinking I can reset with a 9V battery, but can’t find the pin assignment to test. (GM Part # 92215208/ACDelco Part # 15-74128) Any advice would be appreciated. Thank you for your videos!

Thank you sm this fixed our car !

Lord have mercy that seems like a easy fix and I'm about to try tomorrow when I get to my mechanic and show him and see if he can't do that for me how do can I save this