Hi buddy, year 2004. 20 years old and counting.

@forgedforspeed thats great,hope to see more content i also have one too 05'

Hi buddy, there are two breather hose connected to the cam cover. The left hose is the full load breather. And the right side hose is half load breather.

Hi buddy, I use an oil filter wrench (strap type) and help from another person to hold it.

Hi buddy, can you explain again the problem? The power window switch does not work?

Glad my videos helped you out 🫡

Hi buddy, when I started I was not. But now you are right I am pro 😄.

Hi buddy, tighten the camshaft sprocket bolt to the specified torque: 3.0 kgm (30 Nm; 2.013 ft.lbs) Ô 0.2 kgm (2 Nm; 0.134 ft.lbs) + 40 Ô 28 Torque the tensioner bolt to the specified torque: 5.0 kgm (50 Nm; 3.355 ft.lbs) Ô 0.2 kgm (2 Nm; 0.134 ft.lbs) This info is per the manufacturer’s repair manual. For me the tensioner bearing bolt 50NM is on the high side, so do exercise some caution. I tighten it by feel given my torque wrench could not fit in the tight spot.

O i c..Thank you so much for this detail info sir! Fast respond reply!!! Very good sir!!! Hope your bisness growing up everyday by day!!@ Hope sir can uplod more good benefit vdeo to help some people are lack of knowledge for repairing car.

Hi buddy, I am still running this setup which has been 3 years+. When the engine is hot, the bearing is still held in place by the bolt tightly. Bearing itself spins normally.

Ok boss i will try to do it....

Hi buddy, diagnosis was done before the replacement. After replacement just clear fault code, do a test drive and re-scan for error code to ensure it does not appear again.

Hi buddy, when the AC is on do you get cold air in the cabin?

Hi buddy, my dream is to have my own workshop one day in future 🤞

Hi buddy, drop me a message on my instagram “Forged For Speed” I can hook you up.

Hi buddy, I use Permatex Ultra Black.

@@forgedforspeed thanks for ur info, looking for more helpful video.

Hi Buddy, the camshaft sprocket bolt needs to be torqued up to 30nm.

Hi buddy, because I had a check engine light and it was due to faulty oxygen sensor.

Hi buddy, thanks for your suggestion. Will try to do it in the upcoming videos.

Thanks for sharing

Hi buddy, maybe in future will have a shop. Sekarang DIY kat rumah je sebab busy dengan day job.

Hi buddy, no I didn’t have that issue you faced. I managed to easily pump in the grease into all the small holes and have the grease come out at the side of the frame.

@@forgedforspeed thanks for replying. Do any of your holes have a "plate" inside the hole or are they all empty inside? For example, if you stick a needle inside the hole, can you go all the way in or is there something in between? I have the 5000TL....

All the holes have a metal rod inside hence it needs to be greased. For me I could inject grease in all the greasing holes without problem. Maybe try extend the jack up upward and grease it again. That may move whatever the block is away from the grease hole.

Malaysia

@@forgedforspeed semenanjung ka

Saya dari sarawak

Yeah betul, highway pergi pantai timur