What net are you using? I've got a fairly crappy one I'd like to replace :) Not sure I need a carbon fiber pole but some heatshrink to keep it from scraping is a good idea! Ever used one of those whaletail looking attachments on the brush to force it against the sides of the pool?

Great job! Thank you!

Hi can you advise how to get that hardened concrete off the pool surface?

Nice video but actually real time how long takes to clean that pool ..?

:). I remember that pool. Cocoa Beach

Hope the cooler weather is finding its way down to you on the east coast. (I’m located over in Tampa). Question, Jacks Magic Surface gel, is it similar to guys using soapy water to clump debris together on the top surface?

Do you have any videos on how to clean a filter from “below ground level”. I need to know how and I’ve checked many KZbin videos and found nothing.

what is best pool pole to use for cleaning? Need to replace one I have. Do not see on list below?

A video on finding leaks and patching would be good along with maybe demonstrating a bucket test. Seems I have a leak and will be having a team out having failed the bucket test. Hoping it's just jets or something easy! Sadly I think I'm likely out of your general service area but I'm keeping you in mind :)

2:13 😊😊😮😊😮😊😅😮😅 2:17 😅 2:17 😮I

How long did it take you to clean up the mess?

Hiiiiiiiiiii❤❤❤❤❤❤❤❤❤❤❤😊😊😊😊😊😊😊😊😊

The answer turns out to be: drain the pool.

Is this a joke..pools like this are a weekly occurrence here in CA. Just lol @ “disaster”

Awesome Video! Learned a lot!

This is a great learning pool filter leaking and cleaning video!!

I remember that pool :)

Nice trick for siphoning. You should use granulated/powdered Bromine to create the bromine bank (residual), though. It would take time for the tablets to dissolve to create that.

Great video! I first filled the Salt Cell with just water, to see how much cleaning solution I would need to prepare. Also, the solution should not be poured too fast because it bubbles and may overflow.

Oh my God😮

You just saved my life and hundreds of dollars thank you!!!

Flies pov

This siphoning works because of “gravity”, but you must remember that in order for you to keep a continuous flow of water going that the end of the hose MUST be LOWER than the vacuum head and/or the end of the hose that is in the water!!! So, in other words, if the output end of the hose is lifted higher than the suction end of the hose you will lose prime and your gravity siphon pump will not work anymore until you re-prime it and get it flowing again!!!

No BS, clear and simple. This is the best Pentair Clean & Clear Pool Filter maintenance tutorial on KZbin. Thank you!

How much every month

Thank you my friend! I have been struggling for days trying to use our pump to get the massive Algae from the bottom of our pool!!!!!

Those cartridge filters are trash

Can the salt water damage any of your beautiful stone?

So drain pool halfway, clean & refill. This video was so unnecessarily long

If you push f button on that panel the pump will run 24/7 until the next off cycle next day. Just fyi. Use service mode always

Never breathe muriatic acid, no matter how stoned you are.

thanks for the video, I had thought the more gel the better. Actually the good steps are: clean gel and dirt off --> put on O ring --> apply small amount of gel at outer edge which contact the top cover

You saved my ass. Thanks a million

This transformation 👏🤩

If a customer called me out for that and had no clue how its leaking? Id shut up bust out the hydraulic cement repair it. Buck test it and send them a bill. Easy fix.

I got one

I just went through this. Cya was 100 why my HTH kit only gives me 3 tests in the kit pissed me off. Thanks for putting it in a simple way, spent tons of money my clorine was off the chart like a bad urine drug test dark yellow, i was fitting it, it would not come down for weeks then my WELL water i think is the culprit as i was emptying water out the pool and refilling my untreated water ( i ran it out of softner ) it had effect it im not sure whats in it yet, i need to find out.

Only change I'd make, Do not dump the acid water from the cell into the pool. It is a small thing, but why put the calcium you just cleaned from the salt cell back into the pool water where it runs through the salt cell again.

Woah amazing 😮

😳 I don’t think you should submerge the entire Salt Cell to test it 12:20 There are electronics in there that can’t be exposed to water There are great tips in the rest of this video though, that I can come away with knowledge

I’m not so sure I would dump that container back in the pool. Didn’t it contain concentrated calcium deposits from the salt cell?? you just dumped all those calcium deposits back in the pool. I realize the acid broke it down into its components, but they can re-aggregate back together in the pool. Might as well dump it on the gravel, adding lots of water to dilute. Especially where you don’t want plants or weeds to grow. There are great tips in the rest of this video though, that I can come away with knowledge

Thank you so much for the great video you are awesome

Thank you Friend!

That was extremely thorough and articulate, however at around 4:50 you put the stand on and went directly to adding the acid. You didn’t mention that water was added to the cell FIRST! If you put the acid first and THEN add the water, it’s very dangerous. But an excellent video overall. Thank you.

Thank you!

You sir, are a genius.

GREAT BIG MAHALOS AND ALOHA FROM HAWAII 😎

3 PART WATER 1 PART ACID MIXTURE FOR CLEANING SALT CELL kzbin.info/www/bejne/bqfSl3eBgq18na8

Excellent tutorial on how to clean your Intellichlor salt cell. Thanks for educating us.

I’m new to the industry your videos have been very helpful! Keep it up bro! 🤙