hey great video! I need to replace the tucson 2017 aux usb module canyou demonstrate that? Thanks for your help!

so did you poke a hole to run the wires through the caps or do they have a hole already??

Muchas gracias

Thanks for your help,I've done it, I couldn't have done it without your help, again thanks.

👍

I need help with a project. I need to convert a led with 4 wires to 3 wire connector. I got an electric scooter that had leds that had 3 wires. I want to install a led with controller but it has 4 wires.

This way worked so well but when I tried connecting the other LED onto the wires the light connected to the battery but it won’t light up the second LED strip I connected 😭

My Focus!

Thank's Wire Guy, very helpful

Thanks for the Video Sir

Need to remove Center dash speaker first if equipped

Just a quick thing I've found... soldering from the inside out is easier than across. If you solder the inside wires first (red and green), then you won't have to crossover the other wires to solder the other two.

Personally I didn't watch this all the way. Interesting video. But the voice echo and background music together was off putting. You need a body mic.

Didn’t know you had to tin the wires first, thanks for the video!

What can I do if my solder keeps undoing itself when I slightly bend it.

I can safely say your camera was out of focus

Thanks

What a struggle! Thanks for the video👍

I did, but they ended up shortcuiting each other, I threw the strip in the trash and bought others to practice, my biggest issue being that I need to make a u turn

I tried this with 2 of the smaller pry tools with zero sucess. Bought a better set that had that larger tool. Still a PITA but eventually had they pull force needed to free up the dash. Just remember those are straight pins and out with all your might repeatedly

my solder wont stick to the led stripe what could it be?

❤❤❤❤

Anyone know what eeprom to remove to unlock it?

Thanks helped a whole lot I appreciate people like you

What about the plastic coating over the copper connectors? Does the iron melt through it?

My touchscreen is not responding. Can u suggest any repair?

Does the dealer need to unlock the radio with a code??? Someone told me that

After wasting about 20 pixels and 5 connectors, this is the video I needed ^.^ Thanks for making it! Will report back after I try this technique.

Thanks for your removal!

How are these not shorting? It seems like you get the solder covering both the green and yellow pins at 5:03

Where is the rest

what temp thoooo

Great video bro! Helped a lot!

Kick ass video, straight to the effing point! 5FuckingStars!*****

I am really distracted by the poor camera focus

what temperature on soldering tool ? it heats through the wire instantly , something i cant get :(

Thanks. Great video. To heat the heat sync is a butane torch too powerful?

Good stuff Dude! Thanks🌟

what temp is your iron set at?

Thank you for sharing your ideas. Very helpful.

Do you know if you can swap the analog controls/knobs for the digital version

So what the hell do you do when the solder refuses to stick to the copper pads? Because I cannot get the solder to stick to the copper AT ALL

What temperature do you use? I find it easier to tape the led strip to the table so it Will lie completely still and not move

Nice

Would this give you access to the recirculation actuator? I would be better than remove the entire crash pad main assembly

Thank you so much

Nice. Meny thanks

Exciting I think not. Exciting is something that happens when you skydive.

unable to find the products you used on ebay any help would be appreciated tytyty

That’s a terrible solder demo omg 😂 Delete this vid brah