? Did u have to remove the oil stick to remove the starter

This video would have been a lot more informative actually accomplished its goal should it shown how all the components were removed and reinstalled. Otherwise whats the point.of the video?

Are u persian??

I looked up another video how to replace the alternator, they went in from the bottom front instead of the top front. You don't have to remove anything except the belt, and then the alternator. Going in from the top requires you to undo all of those pieces causing extra unnecessary labor time. I am a newer mechanic but I think I could go in from the bottom front instead of how you did in this video, to make life easier.

Am getting check oil level at near gas station but i just serviced the car and the oil is well gagged Could this be my problem My car is w204 c300 2009

Dafuq? all this just for the starter?? The quote be like -part $89 -labor $899

Excellent video,thank you very much👍

Tks

thank you for this video. I have the same vehicle and struggling to get a breaker bar into the tensioner to remove the belt.

The lock at the top of the electrical connector simple came out when I push it backwards… I put it back. The next one was broken. The others were fine. Do you know where I can purchase the lock? I examined the housing and saw that the lock actually only made it easier to be removed. These plugs have never been changed. The car has 69k and it is a 2015 S550 4matic. Thanks for sharing your video.

Does this apply with the 3.5 exl version too?

I just finished doing 8 plug replacement on a 2014 CLS63 AMG. Same setup, coils over plugs. I'll never understand why Mercedes engineers didn't make parallel engine bay walls, which would have left the same space front and rear to access spark plugs. Instead, they tapered the bay walls toward the rear, leaving minimal space. Anyway, using the proper tools makes the job easier, of course, but the plug boot on both sides at the back was a real challenge to remove. I found that heating up up the rubber with a heat gun helped a lot, making it easier to remove the boots. This was all done at 50,000 miles, and with a 10-year-old car... it was fun.

4 Quarts? Holds 11 right?

He sure didn't removed it...I didn't see nothing..plus he probably paid 1000 dollars for the cat..realty??😂😂

Really helpful! Thank you very much!

Thank you for taking the time to post this here for us. Helps us a lot. I will be replacing one today or tomorrow.

Hello, do you know how to replace the pulley that is behind the 2 lines?

You from Turkey?

This should be covered by Lexus warranty if the car is 2021.

What a pain the butt this looks. Cars are becoming to complicated for no good reason.

So...why would a car that new need a new alternator?

I have replaced this part and the arm link kit. This has been about four times and every time I install a new arm link ,3 to 4 days after it snaps broken. Is there something that I have to do after do I have to relearn the car?

What size engine?

Good video Thank you Who else came here cause their cylinder 3 has a miss fire? Lol Why couldn’t cylinder 3 be on that right side of the engine? 🤦🏽‍♂️

Why did u take the battery out I don’t think you know what you’re doing

Can crank sensor fail without throwing check engine light? I have a C230 and when its warm won't start until its cold

I read in a MBforums a guy talking about covering the screw with tape to get the sensor in easier but I was not sure what he meant, your video explained everything. Also the small socket wrench is easier to get too the sensor? Great video!

Wow Fantastic video great explanation good job

I need you to come change thermostat on my car

Great video thank you!

This is definitely a two day job. LOL

How much does this job cost on the 2016 Kia Optima?

Hey Mark Grandomkar i have the same car with same 3.7L i took off the trans oil and it was about 6.1 liter , why urs only 4 liter out ? also from ur information the diff oil and front Transfercase oil do you know what is the correct oil to use motorcraft?

Im trying to replace both my lower o2 sensor but its literally in the tightest space. Would it be best to just remove the converter to gain easy access?

kzbin.info/www/bejne/rHSXlaeCfNZli5I this video shows how to do this job without taking the fan, coolant hoses, and so many other things apart. This should be a 15 minute job.

2014 chrysler 200 need to locate starter to replace the old one 3.6L

جيد جدا

Should of told everyone how you got the top bolt off starter

Or you can just disconnect exhaust on both sides and you will have starter out in no time

Will this cause check oil level at near gas station?

Hi my car 140k miles. Do I need Change transmission fuel? And filter too?

Cardboard creeper... My kind of mechanic right there 👍🏻

2015 gmc sierra 2500hd here. Video helped. Thank you very much

hi, good job !!! How long it takes for everything aproximatelly, ???

Thank you. All of this is good information. The other videos showed removing the intake manifold.

I think I'm experiencing this issue. I have a 2011 with 212,430 miles on it. I just had the spark plugs done and two of the coil pack replaced throttle body and Mass air flow sensor. The issue I've been experiencing after these replacement it's not getting gas and won't go over 40 miles per hour. Its dragging to accelerate is it worth fixing the issue at this point already spent so much money with repairs just ready to say the hell with it.

Other people do not say Anythingabout “activate” anything after installing. Do you have to do this?

So you check transmission oil with engine off? Can this work on a mkt 2015 town car?

Do you have links for the hoses you purchased ?

No help with that bottom bolt. You didn’t show how to do that