I was looking at getting this in the spring but several complaints of frame breaking and the company saying it's normal wear and tear. scares me

This dude is a boob!

Have you had any problems with the convection fan not turning on? It will turn on when I bang on it but slowly

Wear your ear protection at all times. And STOP BITCHING.

What is the coating on them? Yes phosphate/oxide but then what's on top to make them shiny, paint?

Thanks for your review. I purchased the exact vise. I wish I could find a stand like you have to mount it.

Tengo el mismo compresor lleva 4 meses de usó, considero que no lleva un uso constante. Al principio todo bien pero ya lleva 2 dias q lo prendo y aúnque vargue bien no se apaga me ouede ayudar con ello? Temo a q se sobrecaliente el motor y se queme

I have the 770 red and I keep it pugged in most of the time and charge it every 3 months so mine is great.

do you still have this compressor? What do you think?

Clore vs Noco?

Those magnets go a long ways. Your first rack is nice but maybe put that in that back wall-give yourself the aisle with storage on both sides when you come in like you mentioned.

It's fine don't worry about it. Just got a container, looking for tips. Enjoy

How’s the smell

Thanks. It really does seem like mine is low on fluid knowing just enough about how hydraulics work. I'll try this for sure as I've already replaced it once for $700.

The engine is not too strong, the frame is too weak. POS I will be moving on to hopefully a better built machine, nothing but problems.

My light doesnt stay on but truck cranked slow and started . Thennn one day i shut her down an now no crank at all.

I don’t know why are you having issues man, have same mower zero issues, mows great

I have a slightly older yt42dxls with the auto locking diff. It's tearing my grass up on almost every corner. Is yours okay in the turns?

I believe they have changed tips and they do work better now. I used 7 cans last week prepping my vehicle for winter and had zero issues. I put several cans in a 5 gallon bucket of HOT water for about 10 minutes prior to starting and then shook them very well and everything went great!

Sounds like the truck had a lot of rust and repairs before it was fluid filmed. What do you expect when your fluid filming a truck that's already Rusty

Be careful. The propane sometimes leaves water in the carb.

Do you need a mask to spray?

Why are you having a fit over a stove that has lasted 4 years. I have a pleasant hearth ph50ps which is worked with absolutely no problem for 7 seasons now average 3 and 1/2 to 4 pallets a year and finally this year it looks like the igniter is going to need replaced. It should be no problem to come up with something to use for a pin or drill it out for something.

800 bucks...1 year later they are selling them for 12-1400 bucks. I'm sad. Trying to figure out how long a 20lbs propane tank lasts you pulling at least 2000 watts vs Gas..have you tested this?

Your and idiot

WOW I went to an auction as well and saw them there. So glad I did not buy. Thank you!

Nice! Thanks.

The gun matches the can. Won't work with great stuff pro. Would love to find a local supplier

 Dallan Stephens 1.0 out of 5 starsVerified Purchase Died after 6 months of occasional use-- Warranty service ---say they will call but don't!!! Reviewed in the United States on November 29, 2023 Style: 9,000-Watt Dual Fuel Yes I bought this generator in March it ran really good for a few months being used every other week for a short period of time then about a month ago it started having issues when starting with some smoke coming out like the choke was stuck in the on position if you turned it off again sometimes it would start up and run fine- then it would hardly turn over so I made sure the battery wasn't the issue and had it tested. I even tried a new battery and it did the same thing- but it did run once after the new battery just fine then would start again now it won't even turn over. All the lights come on the front and the battery is on a trickle charger to keep full. I have changed the oil as recommended and checked the air filter--- just yesterday I found some troubleshooting videos and went through them. I checked the oil level and then found and disconnected the oil sensor wire to see if that was the problem. No change I am needing this up and running because the RV is being lived in and we use this to recharge our solar unit every so many days for an hour or two. My problem sounds like a common problem in the 1 star category!!

Add $300 and get the honda...Mine only lasted about a year...No help after the sale.

How to check heater? 0:46

What was it you do ? you never specified

Do you still like air compressor?

My next purchase. 😊

Been runing myself that mixture for a while. My original reason is that ss was about 2x more expensive as FF. But I want something runny/liquid to go everywhere inside frame. SS was a bit to waterlike and leak and stain the car when it get out. But by mixing both it just create the perfect product.

I never had a problem with surface shield 🛡 all my cans work but I test them before I buy them

Williams David Gonzalez Robert Johnson Barbara

Yup these are trash. I bought 4 cans and all clogged up and stopped spraying well before half the can was used. Back to fluid film. It's unreal that these made it to production.

Angeline Centers

Price

He probably applied it once and never again in 5 years and it obviously had rust already on it

I am getting ready to swap my engine out. Have one on the way. Appreciate the info. Were you able to leave the AC system intact to avoid having to recharge. Also. Would it be better for me to unbolt The torque converter Before removal because my engine is not frozen.

Damn mine started knocking on 250 miles😢

I thought SS was gonna be it, but... Just got off phone with Blaster support The bad news is SS is just a barrier coating and contains no rust inhibitors or carrier agents to help it migrate\creep Only good for undercoating exposed metal(kinda) Bummer

DO NOT BUY A DUROMAX UNTIL THEY HAVE A WAY TO PURCHASE PARTS! NO PARTS ON WEBSITE OR AMAZON. I CAN'T EVEN GET AN AIR FILTER FOR MINE. CORRECT ME IF I'M WRONG.

why didn't you cut your lineset to the proper length? No wonder it doesn't work worth a shit, how's the oil return cycle suppose to work with all those loops you got going on there.

Now that it’s been a few years, what are your thoughts on NHOU vs. FF and Surface Shield?

I was using Surface Shield and Fluid Film. I’m going to give NHOU (New Hampshire Oil) a go this fall. Nothing against the other two.

Their vise is a 90 day warranty, not a lifetime warranty.

Awesome! Thanks for sharing. I have a park model home that I am converting into a workshop and plan on using this stuff to redo the insulation.