Today I have a 2008 Kia sorento emc needs replaced can’t find one no where they say I can’t get a used one and flash it to go match with my Kia shits bull shit
@JLsAutoSolution2 сағат бұрын
yes you can. you need the pin code for the keys and then you need to reset ecm and reset smartra
@garmonington567320 сағат бұрын
So pretty much what Restore additive does.
@JLsAutoSolution2 сағат бұрын
yes sir
@bassinbillRC530020 сағат бұрын
What year is this car? Engine name?
@JLsAutoSolution2 сағат бұрын
this was a 2014 if i remember correctly
@bassinbillRC530020 сағат бұрын
Takkng off timing cover? Have a 2019 Kia serrento P6😊
@rickpearce4653Күн бұрын
Why are you videoing rescan ( wast of time ) and if your are in a hurry do this when you have the time to be professional.
@GREENGATELLC3 күн бұрын
Why you did not check the HVAC control module you just check the control unit
@StinkyCiv3 күн бұрын
how many KMs have you put on it since?
@JLsAutoSolution2 сағат бұрын
to many lol.. i got busy and forgot to maske the video but i will post the results any way.
@williamorton76004 күн бұрын
I had trouble doing a Lincoln Small SUV, but the manual method of lowering tire pressure in each "learn position " did work. I suspect the TPMS sensor batteries in this vehicle were weak. Also, the book highlights that you can cycle the emergency flasher 3 times with the vehicle off but in Run, and it did go into TPMS relearn mode. Unlike GM, Ford has a few ways to do it👍
@pijoter4596 күн бұрын
Do u need to remove battery from original key?
@mahadwarsame51526 күн бұрын
Hello I have an ultra remote starter installed. And the transmitter/antenna is no longer flashing so the system isn’t working. Any ideas on how to get it back working? I have a 2001 Honda CRV se. the remote starter was working for years. Now the actual antenna/transmitter doesn’t flash red anymore. The remote starter was working for over 5 years and 1 day just randomly stopped. Would really appreciate help
@Ben-hur18 күн бұрын
Same 3,3 as sedona?
@mintylad44209 күн бұрын
I was having serious trouble with a Yamaha SR 125 I purchased last year. Just couldn't get it to run right. I took the carb off, removed all the get, and boiled everything in lemon juice. Carb and gets came out spotless. The bike has been running like a clock ever since.
@dennismarques591011 күн бұрын
I need this done hit me back if u wanna do it
@dennismarques591011 күн бұрын
Why all this for a 4 grand car this makes me soo mad
@moteebankasli766611 күн бұрын
SO ITS JUST THE SOLENOID THE PUMP ITS SELF DOESNT FAIL ?
@peteranania716611 күн бұрын
It seems like other wheel functions would malfunction also if the clock spring is bad. Like cruise control and radio buttons.
@alessandrocolautti465414 күн бұрын
write id4d failed. and now?
@bernardware690414 күн бұрын
This whole video is way too loud. That background noise makes it hard to hear you
@80badboyz20 күн бұрын
can clone smart key hilux revo 2022?
@sahelt1921 күн бұрын
Bro it work 4 a mazda 3 2017?
@JLsAutoSolution18 күн бұрын
Very easy to program Mazda keys. No pin code required. No cloning required. I have not tried to clone the Mazda smart keys, you can always try but I don't believe it will work at 100%,.
@DustinBenton22 күн бұрын
Not sure all the wheel well work was necessary….seems like you could just pop the motor mount, lift the engine, and do all the work from up top?
@philh923823 күн бұрын
How you like that scanner?
@robinaschenbach910825 күн бұрын
Servus meine Kupplung ist verbrannt ich möchte ungern das ganze bauteil wechseln. Hast du ne idee Wo ich die Kupplungscheiben herbekomme ?
@JLsAutoSolution24 күн бұрын
you can order a whole unit from aliexpress for 250$, i looked around but could not find anyone who sells the plates. sorry
@djmobileautoservices25 күн бұрын
Just learned something new
@nonethanks82625 күн бұрын
So yea... everything was spot on,would have been sinple job if the bolt for the ball joint itself wasn't welded together. Had to cut it off with a dremmel ... otherwise thanks for awesome video
@JLsAutoSolution25 күн бұрын
Glad you found the video helpful.
@theragnofam391726 күн бұрын
Fantastic video. Do you have a video on effective bleeding of the coolant system to remove the air?
@JLsAutoSolution25 күн бұрын
thank you very much. Unfortunately i do not have a video on bleeding of the cooling system. but the process on these vehicles is standard so search up some more videos on youtube about bleeding a cooling system. thanks for watching.
@andresflores136927 күн бұрын
I LOVE U!!!
@JLsAutoSolution25 күн бұрын
thank you
@letswalkinthewoods146227 күн бұрын
I removed my drive shaft..🤷 It's 11 years old and over 200,000 klm. So it's a 2wd now. No big deal
@JLsAutoSolution25 күн бұрын
thats one way to fix it, but you can buy these coupling for 250$ from china. amd i think its like 120 shipping, still better that 1000$ from the dealer.
@letswalkinthewoods146227 күн бұрын
I removed my drive shaft and changed the rear diff oil. It's a 2wd now 👍
@travisfletcher18228 күн бұрын
I have same bike but have many question about the carb lines that connect to it can’t figure them out can u help me ?
@Kharimoff79028 күн бұрын
Hello, I don't know if you will answer or not? Santa Fe 2014 has both a heated and cooled seat on the driver's side. When the car starts, when I turn on the heater/cooler, the 3 lights come on, but they go off after 2-3 seconds. When I try to turn it on again, it doesn't come on. What is the problem?
@JLsAutoSolution25 күн бұрын
the system is shutting itself off due to a fault in the heated seat(seats) might be fuse/wiring/ or even module. sorry i cant be of more help as i would need to see the vehicle to diagnose it.
@Kharimoff79028 күн бұрын
Hello, I don't know if you will answer or not? Santa Fe 2014 has both a heated and cooled seat on the driver's side. When the car starts, when I turn on the heater/cooler, the 3 lights come on, but they go off after 2-3 seconds. When I try to turn it on again, it doesn't come on. What is the problem?
@philh923823 күн бұрын
Need a scanner to read the seat module codes
@texaskyle767629 күн бұрын
where is this located on the 2019?
@1EagleDave29 күн бұрын
🦅🦅🦅🦅🦅🦅🦅☑
@adamlee7459Ай бұрын
Your video is fantastic. I’ll be tackling this myself. Any other suggestions besides taking your time..?
@travisthomas8821Ай бұрын
Great video but what type of 200 is that with 280 mhp WOW
@slalomkingАй бұрын
Front right tire first on Fords
@MasQueAutosRDАй бұрын
Hi there! What were the symptoms of this bad sensor?
@oralcengizoglucengiz1127Ай бұрын
❤❤❤
@micke2943Ай бұрын
Hi, thanks for a great vid! i have this coupling on my santa fe. Lost all rear wheel drive... Looked under the car and the coupling has had a major leak! Looks like all fluid has been pushed out! Prop side Of coupling is drenched, pump etc. Thinking of the refill hole not holding fluids when pump activates, or that disc plate where high pressure channel is? What kind of seal was it on that plate screwed on with allen bolts? Just silicon or regular gasket? You think the clutch pack is ok even if it lost the fluids due to a failed seal/gasket? Thanks for a good video, been searching for one of these vids! 😊😊
@micke294324 күн бұрын
Had a workshop inspect it today. Coupling had leaked out about 150ml fluid. Enough to burn the plates and trash the coupling. Insurance covers fortunatly the labour + parts. Otherwise this job costs $2200 with everything original. Now it cost me only $50 and insurance takes the rest. 🙌🏼
@vasparoneАй бұрын
Does anyone know ehat is the spare part number?
@JoseduardoVillagomezАй бұрын
I love you
@kariolar3158Ай бұрын
Great concise video!!
@MrMonsterKILLA123Ай бұрын
I need a video of changing out that exact same sensor.
@MrMonsterKILLA123Ай бұрын
Those sensors are like 400$ at autozone, 200ish on rock auto, wth? Thats way too expensive of a part to come faulty.
@pradeepramdhaney178Ай бұрын
Hi very informative video. Do you know if the spare parts inside the coupler are available to refurbish the unit or do you have to buy a new unit. If available please advise supplier details. Thanks
@nickjovkovic3681Ай бұрын
When you get a misfire code on one specific cyl. the easy 10 minutes test is to swap the coil and spark plug with an other cylinder, if the same problem persists you have eliminated the possibility of those 2 components being faulty.
@JLsAutoSolutionАй бұрын
I agree. But if you have equipment that makes that you do not have to remove any parts for testing why not use it., and what if the coils are under the intake and it will take 3-4 hours of labour to remove and swap a coil. the client is going to pay for a MAYBE answer at that time.. In this field there are only yes and no's, if you reach a maybe answer you missed something and need to go back and recheck your work. Thanks for watching
@hayguey7952Ай бұрын
My godiac gt100+ came with different wire connections.cant hook them up too any ecm.the wiring came with like multimeter wires.
@AverageskillАй бұрын
the actuator only turned 1/2 way....I figure it needs a new pot.