Az Motor 1990

Пікірлер

@WoZIMoo 15 күн бұрын

How much Evaporust did you buy? Only one gallon and you kept moving the tank around, or several gallons? The stuff is pretty expensive.

@AZmotor1990 6 күн бұрын

@@WoZIMoo sorry I didn't get back to you. Yes it is expensive. Actually I got just 2 gallons and i start moving the tank but if you have money, it will be good idea to fill it up.

@AZmotor1990 6 күн бұрын

And you can save it too when you're done you might use it for something else

@maikmexicali4881 17 күн бұрын

Aque temperatura máximo llega esa moto amigo

@driftability 18 күн бұрын

Gotta take the whole front end off damn

@hill_colby9805 Ай бұрын

Doesn’t show shit

@JamesKornIII Ай бұрын

Turn the idle down a little

@pmotosgarage Ай бұрын

If someone ever did this to my bike . You best be throwing hands.

@SLAYNE999 2 ай бұрын

I would have enjoyed the video if you would have stuck that big contraption in that little hole. I am assuming you have to remove the turbo and the regulator from the manifold to install it. I can't find a video anywhere of someone putting one in the only take it out. To make it worse, my driveshaft is right above my oil tube and it will not allow me to remove the tube. I assume in this situation I need to cut the stud off enough to remove it? Your video was not helpful at all. JS

@AZmotor1990 2 ай бұрын

@@SLAYNE999 sorry man if my video didn't help you because I make it so short, not enough information but for me, I have to remove the engine mount and the passenger passenger side and I pulled in a little bit that's why make it easy for me to pull turbo assembly

@majklknight7455 4 ай бұрын

Bro you burn clutch instead of rubber ?

@micheleeurope 4 ай бұрын

La più bella Kawasaki di tutti i tempi!

@ozwasp 4 ай бұрын

It's so big compared with today's superbikes

@U3X6785 6 ай бұрын

He better go with the 600

@ermazargw3908 6 ай бұрын

is a pretty big bike, how tall are you?

@OFFLiN3_Ish 6 ай бұрын

You didn’t have to take nothing out the bottom of the engine to get turbo out ?

@jamesabarela 7 ай бұрын

So once the turbine or propeller has become loose, there is no retightening it and it being ok? You have to replace? If that is the case it will be the 2nd turbo that was replaced in this car, so what happened to mine was I was entering the freeway and when trying to get up to speed I noticed the car would not get up to highway speed or it took a long long time and I had angry drivers behind me ... I pulled over immediately noticed the whining sound and couldn't do much more so I just drove it home and went easy on it. Got home and pulled it apart and noticed a small nut to a screw that was up in the air filter box and was like hmm what the heck, finally got down to the propeller and the nut to keep the propeller on and tight had simply unscrewed and shot up into air box, I was able to reinstall the nut, I wasn't able to get it a tight snug because the propeller spins as your tightening . So am I able to re-tightwn the nut and the turbo will once again be fine or is that a definite replacement?????

@a-yates 2 ай бұрын

When a turbo gets slop in it it’s from the bearings being bad you can replace the bearings and the impeller but most people won’t they just swap out the whole turbo don’t think they sell rebuild kits for them so you would have to spec out the bearings needed and you’d have to find somewhere to get the impeller as well

@AZmotor1990 2 ай бұрын

@@jamesabarela sorry for responding back late. my case my turbo was running dry from the oil because it was plugged with the sludge of oil. that's why making the propeller loose and the bearing wants bad

@felipebusta7660 9 ай бұрын

How do you take out the old one mine gets jammed every where 😅I need help

@AZmotor1990 9 ай бұрын

You have to separate it it will come out easy

@tgap8817 11 ай бұрын

Casco please

@RicardoSantos-wk6dq Жыл бұрын

What are the torque specs for the cylinder head bolts? Thanks

@AZmotor1990 11 ай бұрын

Go online to the metric and find out what's correct specked because every car is different and when you take the bolts off, you have to replace them because the one I did I did 120nm and then 90 degree +90°

@kkristofercampbell4765 Жыл бұрын

That kawasaki is nice

@AZmotor1990 Жыл бұрын

Yes, I wish I find one. I will buy it again. I used to have it couple years ago low mileage, but I sold it.

@OmarSamih-g5f Жыл бұрын

❤

@sugarrfree Жыл бұрын

One solid brick man

@ruanbezuidenhout9295 Жыл бұрын

How many liters does it take

@AZmotor1990 Жыл бұрын

1.9 you can put 2 quarts. It would be perfect.

@damiangregory1932 Жыл бұрын

1 qrt in case 0.8 in oil tank is what specifies on manual correct?

@ruanbezuidenhout9295 Жыл бұрын

Thank you so much, is it normal for the oil to leak out the tank if I took out the dip stick. I personally think there ways to much oil in the tank

@AZmotor1990 Жыл бұрын

@@damiangregory1932 1.8, but me I put 2 quarts

@AZmotor1990 Жыл бұрын

@@ruanbezuidenhout9295ur welcome . shouldn't

@karolkrupa8252 Жыл бұрын

Its not zx750r ......this is zx7r

@alexkeohane143 Жыл бұрын

That poor clutch 🏁🏁🏁

@audiosuits-tailoredsuitsfo9526 Жыл бұрын

its too large for the you - sorry to say it is not the right bike for you - I ve used the zx7r on the racetrack and it was a great bike

@فايزالعزة Жыл бұрын

ماشالله تبارك الله

@AssiyaBassel Жыл бұрын

Lah ihefdek khoya ❤❤❤

@El_PAPO_TV Жыл бұрын

Hi friend, I have a trx450er 2014 but I have a problem, the drowning of the motorcycle does not stay outside is booted and to use it I have to hold it, you know why this happens? Saludos

@AZmotor1990 Жыл бұрын

Text me on my Facebook I might help you out brother no problem AZ Ahmed

@aircraftadventures-vids Жыл бұрын

wtf, you just spray it on, and ride away? 😜

@AZmotor1990 Ай бұрын

@@aircraftadventures-vids it works for me works really good I wipe it after like five minutes 🤙🏾

@bradjean4486 Жыл бұрын

What a newbie poor handling and clutch skills

@robertrodriguez2395 Жыл бұрын

Too much Kawasaki for that guy...! People with no experience are the ones that end up getting killed they're lack of respect for the ROCKET...!

@jordangarrick703 Жыл бұрын

If not the baddest snarling bike ever, it's close enough. Perfect beast 💪

@888jackflash Жыл бұрын

I recently had to remove my fuel pump from a 2008 FJR, due to slight leaking around the gasket. I wonder what ever happened to that tank you have there... it looks BAD. Too much rust! Did you replace it.. or clean it?

@AZmotor1990 Жыл бұрын

I buy the bike like that from somebody he told me was parked for five years. after I clean it becomes really good no leak no nothing just a change brand new pump and i clean the house off the pump.

@masterchief6061 Жыл бұрын

Almost kills him self like 3 times

@rt2255 Жыл бұрын

You actually went through trouble to make and upload video for that bs, give bike to deserving rider. Great bike shit video

@motortoys9942 2 жыл бұрын

Zx7r is a cool and rare bike. That guy is gonna hurt himself on that thing 😂

@kendtchileninjah5905 2 жыл бұрын

He looks tiny on that bike

@beatersnbeers2145 2 жыл бұрын

Ride the clutch some more lol

@arnoldtm31 2 жыл бұрын

Zx7r here in England. One of the best looking bike ever built in my opinion. Wish they bring it back with an aluminium monocoque frame to bring the weight down and maybe with 799 triple to make it unique as opposed to the i4.

@AZmotor1990 2 жыл бұрын

Yes I wish they made them again

@alanphillips8720 2 жыл бұрын

Nice bikes, old school had two of them lovely around fast sweeping bends, but my srad 750 would eat them.

@AZmotor1990 2 жыл бұрын

Yes they are lovely bikes I wish they made them again

@wardstirling7100 2 жыл бұрын

One of my favourite bikes ever!

@melodynelson7219 2 жыл бұрын

Vidéo sans aucun intérêt !!! Vraiment il y a qui n'ont toujours pas compris l'intérêt de faire des vidéos sur KZbin... Enfin il faut avoir un cerveau pour comprendre !

@GIGABACHI 2 жыл бұрын

Who else was waiting to see someone get plastered on a wall, car or else ?

@ruhan6884 2 жыл бұрын

Top show 👍

@AZmotor1990 2 жыл бұрын

Thank you

@СегаШвей 2 жыл бұрын

мотик конечно класный но мне кажется не стоит так подгазовывать-об стенку размажет.у меня приятель так слетел и мотак запортачил,на дрозде если не ошибаюсь-решил пооткручивать газульку как на ижаке