Marr's Heating and Air Conditioning

Пікірлер

@o2slo338 Күн бұрын

Not going to remove and clean blower wheel?

@stevenambrosen4626 8 күн бұрын

Would be better without the music

@joelperigo7213 8 күн бұрын

HI SAM!!!

@EliWheaton-b5z 10 күн бұрын

One major design flaw is the refrigerant lines. Having that flare connection on the air handler makes it challenging and sometimes impossible for installation in situations where there is limited depth in retro fit configuration.

@EliWheaton-b5z 9 күн бұрын

Comment with your opinions I’d love to hear feedback on this.

@donaldwinding8531 16 күн бұрын

Good info but video could be better quality with more close ups and No music

@tjmooney4181 18 күн бұрын

Diy ftw

@Rust-g7y 19 күн бұрын

Don’t try at home if not expert in AC and turn power off

@kevinjk27 26 күн бұрын

Thanks

@daughteroftheking4492 Ай бұрын

i am a mitsubishi Sales ask me anything:

@annrodgers4387 10 күн бұрын

Is this as energy efficient as the hyper heat? I have gas ducted system now I was under the impression This was a ducted system from a dealer near me, now I'm confused.

@rogerthat1962 Ай бұрын

Why did you leave all of that extra line coiled up behind the unit?

@joelperigo7213 Ай бұрын

Could you guys install an energy monitoring system in my home that will tell me which appliances are using the most power?

@val5256 Ай бұрын

“Ooh that would be cool, I’d like something like that in my house.”😊

@marrsheatingandairconditioning Ай бұрын

@@val5256 We would love to find you some solutions. Please reach out over the phone or our website. (833) 976-3111 / marrsheating.com

@drew1930 Ай бұрын

This video is misleading. I installed a 2nd gen mr.cool diy a long time ago after getting a hvac quote that was insane. At the time, with federal and utility rebates and parts, I think it cost me like $300 total to instal. Still running great all these years later. If you are handy (aka can do basic electrical & other diy stuff) then it's easy. In this video you purposely make it look bad and sloppy, most DIY people will read the directions and watch a video or 2 on KZbin before attempting. Just because it is DIY doesn't mean you need to be sloppy. DIY in this case just means that you don't need to flare, pump the lines down, nitrogen pressure test, and vacuum the linsets. None of that is hard but most diy'ers won't have a nitrogen tank or the vacuum pump.

@YoloRanch Ай бұрын

Where can we get the spray and bibs from? If we don't have a coil pressure washer what else can we use?

@MaxReed-h4v Ай бұрын

I wanna listen to the pro. Not you, who’s to lazy to do it yourself. Like you said

@CigTopGun38 2 ай бұрын

No offense but the line sets outside look terrible. 🤮

@johnfr2389 2 ай бұрын

Is it safe to clean it in winter when temperature is slightly above freezing (e.g. 4 deg C)?

@corygouliard9790 2 ай бұрын

Super clean!!!

@TAGUPNBLUE 2 ай бұрын

WHAT IS THE MASK USED FOR

@Tanquen 2 ай бұрын

I think the condensate line from the Water heater is to be open to atmosphere.

@tuckerparsons9182 2 ай бұрын

Great work!! We’ve just started installing these as well

@rogerwhiting9310 2 ай бұрын

What brand collection kit....drainage bag do you use?

@MrDeviousdom 3 ай бұрын

These are chinese junk! Failure after failure.

@copkhan007 3 ай бұрын

How many btus is the ducted unit? Is it sufficient enough for all three rooms? Also, is your floor mount connected to the same Condenser unit?

@analyticalhealth 3 ай бұрын

You didn't remove blower wheel and fan for full cleaning?

@ChrisHVAC 3 ай бұрын

You guys do nice clean work!

@richardmckrell4899 3 ай бұрын

Shouldn't you repair the drywall before installing the new ductwork?

@BigBruPB 3 ай бұрын

Very Nice looking work. I’m a 35 yr HVAC Veteran Service Mgr. I love seeing quality work. Because it seems rare these days. Too many home owners watch the DIY shows to where the see them build a Whole system in 30 min and the expect us to do the same thing. But Cheaper! lol

@sasyaharry4046 3 ай бұрын

Ugly ducts all over the facade!!!

@coolwayrefrigeration 3 ай бұрын

nice service van❤

@louismaynez8852 3 ай бұрын

you didnt clean the wheel

@NoOne-vp7xi 3 ай бұрын

Will the louvers get out of calibration by removing them?

@feboogi 3 ай бұрын

Did this help with running heat in cold temperatures...if so how low of temperature did it get to until heat stopped working .ty !

@peace2725 3 ай бұрын

I get that clean by a professional but now the heat pump turn on but turn off doesnt want a turn on with the remote, can someone have a clue whats the problems can be ...

@joelperigo7213 4 ай бұрын

You guys should pay me to watch this

@joelperigo7213 4 ай бұрын

I should clarify, can I watch this on the clock?

@MAKTEK1022 4 ай бұрын

lol! This is great!!!

@daved9532 4 ай бұрын

You will regret getting a Mitsu system like I did

@joelperigo7213 4 ай бұрын

Don’t let L&I see that furnace kick

@joelperigo7213 4 ай бұрын

This explains Hunter’s haircut

@toddlemons5952 4 ай бұрын

You didn't make a point at all. Major selling point is a cover comes with the pro install? Really? I could buy line covers for myself and all my neighbors with the savings I get by doing my own system. MrCool is generally rebranded high quality equipment. HVAC companies are cons. Two tried to rip me off with 12k installs.