Nice info! For both the faulty fuel gauge and the manual overide tab... Been wondering what that 'ka-hole' was for 🙈🤭😅
@SeekingPipsАй бұрын
That roumd white plastic thing you have in the white plastic pot where does it come from? Mine fell out whilst replacing my switch I have no idea where it fell from. Thanks for you video. Diagnostic yool directed me to a faulty swith and then you video helped with location and access. 👍
@emmanuelkamfwa6893Ай бұрын
I have the same issue on an HR15 could, could it be the position sensor is not sending back pedal position signal? Secondly how many volts did you use to test the motor?
@rogersingh39183 ай бұрын
What did you use to clean the carbon buildup on the swirl flaps?
@lekshmideva68023 ай бұрын
Hi, this floating parts separate available from shop?
@Biksieboy4 ай бұрын
The 2L diesel will eat this
@UptownFights4 ай бұрын
What component inside the aircompressor keeps the air pressure from leaking out the rear valve when its off? I bought an ebay compressor and it pumps up, but doesn't hold air. The new replacement one I received does. What can I fix or maintaince in the defected one? Air check valve? Where is it?
@Don1-zv9gz4 ай бұрын
You never know
@innafrolova87206 ай бұрын
Thank you so much for uploading this video. It saved me $759, this is exactly what Nissan asked me to pay here in Sydney, plus 2-day wait to get a new locker from Melbourne. I declined it and I am sooooo glad I did. The problem with my locker was a tiny piece of plastic that stuck inside preventing the motor from spinning. As soon as I got it out, everything started to work as expected. NISSAN Service didn't even investigate what the problem was. I am so happy I stumbled across your video. Thank you once again!!! All the best to you and your family!
@user-rb5jj8ge2r7 ай бұрын
Ima cars starts up faster than an ice car
@user-en1if9mg5p8 ай бұрын
Can you install a Nissan march and where are you located
@ncwaladlamini23809 ай бұрын
Hi hi sir I have the same problem and I've checked the motor and clean the connections it's working properly but when I reconnect it it doesn't work and the boot light is working but the boot doesn't it's like there's no power in the boot switch or maybe it's the fuse ?
@Ngigi10 ай бұрын
Nice vid! Chwi chwi mainly saves us from these nasty boys who want to harvest car parts
@user-rf8fk1zl4i11 ай бұрын
How can i reach you
@kiphendry84111 ай бұрын
Thank you.
@thecommon5920 Жыл бұрын
that was one of the best explanations I've seen. thank you Shame you didn't do the resistance test just to show how to do it.
@simonmoure7302 Жыл бұрын
You really shouldn’t make videos of fabricated information when you have no idea what you’re talking about. This isn’t a feature exclusive to IMA vehicles for whatever made up reason you just gave. That’s just a feature that was introduced as a convenience, which also helps reduce starter wear for those who hold it too long causing premature wear. I have an 08 Acura TL, 2010 Acura TSX, and a 2012 Honda Odyssey, which all three have this feature and are not IMA vehicles. Smh 🤦🏾♂️
@matthewjames546 Жыл бұрын
Skip bits why don't you
@tineskolljohansen1315 Жыл бұрын
Hey, how did you clean out the water ingress from the socket? I have tried googling, but I can't find a good way to do it...
@aniesahhendricks2175 Жыл бұрын
I have a trail 2012 but can't find the petrol floatin Cape Town South Africa. Any advice or help pls
@peterndungu2196 Жыл бұрын
Nice video there. Thumbs up
@mgakowski Жыл бұрын
Back pressure from restricted DPF or PCV valve bypass?
@savageblades360 Жыл бұрын
OK yall can anyone help diagnose when a 2010 Insight dies 2-3 seconds after starting? -thanks
@pearlswithchristine1812 Жыл бұрын
how do u achieve 26km/l?
@margaretphilip9679 Жыл бұрын
Where are you located
@dulands Жыл бұрын
do we drive AUTO or 2WD better fuel economy?
@Mestvi55 Жыл бұрын
2WD of course
@mikealsop8248 Жыл бұрын
After being plagued with this problem for a long time, the answer actually turned out to be simple. Exactly as Mista found and after I replaced both sensors, still this exact same gauge problem persisted. Even bought a second hand cluster from the wreckers and fitted it. Same problem. Then I found this simple procedure to re-calibrate the fuel gauge and finally fixed!!! Follow this. Hold the odo button down and turn the ignition on. Wait 2 seconds, then press the odo button 3 times within 5 seconds holding button in after 3rd press. Turn ignition off. Turn the ignition on and voila!!! Gauge reading perfectly. Will see if this holds.
@matejmelis501 Жыл бұрын
you push odo/trip button? on xtrail T30?
@nep0stojeci8 ай бұрын
Work on t30?
@sarahhealy981 Жыл бұрын
Do you have a video with instructions on how to remove and replace the locking mechanism from a Nissan dualis j10 2013 or similar? Mine stopped working the other day and I'm trying to work out if I can fix it or replace it myself or if i should take it to the mechanic. I've been looking for instructions online with no luck so far
@jayjayampathy3624 Жыл бұрын
Clear like anything. Thank you
@rallyttitomedina4098 Жыл бұрын
No seas malo amigo pásame el diagrama estoy desesperado compré. Motor y ecu sin tacómetro y mi tacómetro es de 2 entradas y el qué vino es de tres te agradeceré mucho y seré tu fiel seguidor. Gracias
@jermaineallen7450 Жыл бұрын
Hello I have a nissan cube with the same Trans which line on Trans is the in and out put line ?????
@docpepere9198 Жыл бұрын
Thanks a lot for sharing your knowledge. My guage lost precision when the gas tank is full... your video will help me ;)
@CaptnTripsАй бұрын
Mine can't be trusted below 1/2 tank. I broke down without fuel and my gauge still reported 1/3 full
@kelvinmwandai577 Жыл бұрын
Where can I reach you?
@mwansamusondacooks Жыл бұрын
Need help please ,how can you arrange the buckets/valve cups if you forgot to mark them
@gideongichamba Жыл бұрын
How much is the after market cooling system
@TheYoungBoaty Жыл бұрын
Nice work! What spring hose clamps and mount kit did you use? I don’t trust the worm gear clamps as those often cause leakage. I read reviews on both Dorman and Hillman spring clamps were made of cheap weak steel so I am thinking of Denso/Toyota brand but they don’t seem to sell those along.
@guitarguy322111 ай бұрын
I would use the hi psi stainless fuel line clamps, maybe evil energy brand
@dom1982c Жыл бұрын
Great video, I’ve got the same issue, will use this tip, 😁👍
@chrisr9199 Жыл бұрын
what bolts hold the lock in..m5 10mm..? cheers
@lichee6181 Жыл бұрын
Nice tutorial. Does this work on a 4afe head? *Update: It does, I just replaced all the valve seals on my 4afe cylinder head by using this method*
@oscarmusembimarco6081 Жыл бұрын
Very informative........ keep up Lobsta..God send techie
@TheShakir982 жыл бұрын
Instead of that, I wish Honda would’ve just put a button to start the car
@tinnguyen1432 жыл бұрын
I wish you were in California so I can have you as my tech. I really appreciate your thoroughness and using data. Nice work
@Jg-su5sp2 жыл бұрын
Thanks! This video helped me get the boot of my dualis opened after it jammed and possiblely fix it enough to suffice until i can afford to get the mechanism replaced.
@abbamurule18002 жыл бұрын
Princess hehee
@hectornagano18192 жыл бұрын
Good detailed explanation bro. Thanks.
@avinash22052 жыл бұрын
Hi. I have a honda insight 2010, the car is chewing fuel. How can i contact you?
@humraaz786 Жыл бұрын
Hi, I have the same car n same problem. I dont think its shifting into higher gears on time. Seems to be ok up to gear 4 then engine revs high. I change up manually now and getting better fuel economy .
@user-rj6lr8cq4l3 ай бұрын
I have a 2010 Honda Insight Hybrid car that consumes 5 liters /100km of fuel on the highway, but when I enter the city, it increases to 9-10liters/100km. There are no issues with the hybrid battery, the spark plugs have been replaced, and there are no error codes. The Honda service cannot find the problem, but I think they just haven’t looked carefully enough. My car consumes an excessive amount of fuel until it reaches a speed of 20 km/h when starting. After reaching a speed of 20-30 km/h, there is no problem, but if I press the brake and reduce speed, fuel consumption increases again. The car shakes back and forth at startup, and the engine RPM increases and decreases spontaneously. I can’t solve this problem, please help. I’ve seen 5 mechanics, but they all say there is no problem.
@kenkaranja33052 жыл бұрын
Hi bro, how do I get in touch with you?
@kenkaranja33052 жыл бұрын
???
@koomemicah8799 Жыл бұрын
Where is your garage?
@peterlakers12 жыл бұрын
What's the temperature at normal operating temperature
@deirdrestacey47372 жыл бұрын
Will the brake switch stop the engine from starting please? Mine shows ESP inoperative and wont start at all.
@Bo-Medyan Жыл бұрын
No I have this issue since 2019 until now my engine keeps working