Kees Beekmans

Пікірлер

@elculi989 6 ай бұрын

Ziet er weer leuk uit Kees! Ben jij ook nog in beeld?

@philipsengers8338 6 ай бұрын

Een van de allerbeste jammer dat hij wr niet meer is

@keesbeekmans9275 6 ай бұрын

Inderdaad een van de allerbeste. Dankjewel voor de reactie.

@paulcollins9098 7 ай бұрын

That runs lovely

@MrJoop830 7 ай бұрын

Geweldig om zulke film terug te kijken

@keesbeekmans9275 7 ай бұрын

Jazeker mooi om terug te zien. Dankjewel voor je reactie.

@christopherrundle7845 Жыл бұрын

Iv recently acquired an old villiers water pump. Would love to know more about it. And how you got parts

@willemgjaltema2996 2 жыл бұрын

Is er in 2022 ook een show ?

@keesbeekmans9275 2 жыл бұрын

Daar heb ik navraag naar gedaan. Misschien in september als er een geschikte locatie gevonden wordt.

@dirkvanglabbeek3762 2 жыл бұрын

geweldig hoe Frank verteld

@keesbeekmans9275 2 жыл бұрын

Precies. Hoe vaak ik ook kijk, elke keer moet ik er enorm om lachen.

@geertschrijen7805 Жыл бұрын

@@keesbeekmans9275 een van zijn beste optredens !!

@egidioborg3421 2 жыл бұрын

Hi again, I will do some tests on the coil and resistor, eBay doesn’t seem to have the same type of coil. Can I send you a pick of my electrical system, is that possible, cheers george.

@egidioborg3421 2 жыл бұрын

Hi, where can I buy ignition parts from please.

@egidioborg3421 2 жыл бұрын

Hi, do all villier motors run on unleaded fuel, and where can I purchase ignition parts from, cheers.

@egidioborg3421 2 жыл бұрын

Hi, I recently picked up a Alcon water pump and it doesn’t seem to have any spark, could you help me diagnose the problem cheers george.

@eddiedeleon2425 2 жыл бұрын

the specifications are written in nameplate, users guide and alike, thumbmark of manufacturer, thank you Sir

@keesbeekmans9275 2 жыл бұрын

Thank you for the response. You're welcome.

@geertschrijen7805 2 жыл бұрын

Geweldig,en wat een enthousiast publiek !!

@keesbeekmans9275 2 жыл бұрын

Inderdaad. Frank was heel geliefd en populair in Aarle-Rixtel. Hij was niet alleen een goeie tonproater, hij was alles! Een cabaretier, komiek, entertainer, acteur, enz.

@geertschrijen7805 2 жыл бұрын

Prachtig,gekeken met een lach en een traan !!

@keesbeekmans9275 2 жыл бұрын

Kan ik me heel goed indenken. Dankjewel voor het kijken en mooie reactie.

@BensWorkshop 2 жыл бұрын

Some interesting engines there, including a portable steam engine and a Stirling engine. Many thanks for sharing.

@keesbeekmans9275 2 жыл бұрын

I recently came across these recordings in my archive. Of course nice to share with other stationary engines enthusiasts.

@BensWorkshop 2 жыл бұрын

@@keesbeekmans9275 👍 Good work.

@dunbar837 2 жыл бұрын

What else can you use a stationary engine for nowadays 🤔

@dunbar837 2 жыл бұрын

I'm getting no spark and the flywheel is sized on. Iv tried to get a bit of sandpaper in to clean the contacts. It's been sitting 20 years and was sized but I got it freed up and feels smooth to turn over by hand.

@adriangray6951 2 жыл бұрын

@@dunbar837 Apologies if I am teaching you to suck eggs here - do you know how a Villiers flywheel pulls off? It's on a taper, the centre nut loosens for a turn or two, then tightens again - at that point you welt your spanner with a mallet (Villiers used to sell flogging spanners for just this job), and the flywheel should pull off the taper. Conversely, when you put it back, it needs to be *really* tight or it slips and you are left with no idea why it won't run (guess how I know?). Don't use a puller - it'll just mash the thread. Your videos look UK - google L&S Engineering, Villiers parts and Villiers spares for ignition bits. Hope that helps!

@track1219 2 жыл бұрын

Reminds me of our Briggs and Stratton engines here in the US. Nice job!

@keesbeekmans9275 2 жыл бұрын

Thank you. There is also a part 2 on You Tube. In this part the engine is further finished and drives a dynamo.

@track1219 2 жыл бұрын

Reminds me of our Briggs and Stratton engines here in the US. Nice job!

@larsdunselman8727 2 жыл бұрын

Leuke motor hoor

@BensWorkshop 3 жыл бұрын

Looks good, sounds good. Well done. I am particularly curious about the way the valve works, looks like it is driven by an eccentric. Is that correct? Also, I presume that it has a self acting inlet valve.

@BensWorkshop 3 жыл бұрын

@@keesbeekmans9275 Is the exhaust driven from an eccentric rather than a cam?

@nandurathore2115 3 жыл бұрын

कितने का है ओर कामपेशर चले गा कया मो देव

@kundansinghofficial1622 3 жыл бұрын

इसका नया carboratior कहा मिलेगा

@TheFlyingBusman 3 жыл бұрын

Just acquired one of these myself so will be doing pretty much the same thing. No idea what to use it for afterwards. Might make myself an hydraulic log splitter.

@larsdunselman8727 4 жыл бұрын

Leuk filmpje hoor Kees. Heb veel plezier beleefd aan de foto's en nu dan de film. Gr. Lars

@gijsbertberghoef4031 4 жыл бұрын

Kees Beekmans Mooie serie motoren; ik wil je graag wat vragen over Mark 10! Hoe kan ik je bereiken

@wiebevanderwal5135 4 жыл бұрын

Excellent nice little machine, . Enjoying the quality of engines build during the 60 and 70 of the previous century, nice work, I like the people who spend a great deal of time and money to keep theses old machines working. , quite something different then the plastic engines built today. Rating 5 stars , WW.

@keesbeekmans9275 4 жыл бұрын

Thank you. The MK20 and MK25 are very nice engines to work on. Mainly because cylinder block and ignition part can be removed separately.

@BensWorkshop 4 жыл бұрын

That looks a lot like the previous video you uploaded. Did you change anything?

@BensWorkshop 4 жыл бұрын

@@keesbeekmans9275 agreed. I need to find work for mine.

@BensWorkshop 4 жыл бұрын

That's quite some pump 👍

@keesbeekmans9275 4 жыл бұрын

Indeed, it is a very powerful pump. I could go to the fire department for any assistance.

@BensWorkshop 5 жыл бұрын

Not ideal weather for it.

@keesbeekmans9275 5 жыл бұрын

Indeed bad weather. It's more colorful with sunshine.

Ең жақсы KZbin

Пікірлер