RossTheBoss

Пікірлер

@AndrewTinWA 15 сағат бұрын

looks like half inch socket bits not quarter inch. Thanks for the vid very helpful

@-RossTheBoss 14 сағат бұрын

Yes you are correct, that is a 1/2 inch. My bad

@AndrewTinWA 14 сағат бұрын

@ I am now shopping for a 27mm deep socket! A bit of a harder job for me as I’m fitting an adaptor under the sensor for an extra sensor to run a separate gauge

@spudsmckenzie4123 Күн бұрын

Great video mate. Just an FYI at 7:25 don't forget to tighten the water pump pulley bolts once the belt is re-aligned and tension is back upon it.

@-RossTheBoss Күн бұрын

Thanks for the comment. I forgot to record that part but I can assure you I tightened the bolts back up. The pully hasn't fallen off... Yet..

@spudsmckenzie4123 Күн бұрын

Oh yes, it was obvious when you started her up. She would have went for a six if you hadn't. Thanks for the video. Made my job easy as. 👌

@toastwings2190 23 күн бұрын

cheers mate this helped a lot

@ianstewart8243 28 күн бұрын

Thanks. Very comprehensive video. About to go and change mine!

@hollandparkhouse Ай бұрын

Great tutorial mate good work

@ToddBinNM 2 ай бұрын

1989 and still sounds great.

@burthammer2871 2 ай бұрын

Shout out to the previous owner for the cross thread!!! Lmao 😂😂

@melvinnavarro8025 2 ай бұрын

Where do I get the adapters ?

@-RossTheBoss 2 ай бұрын

They're included when you buy the lights, or at least they should be..

@booonzy7240 2 ай бұрын

Did you end up getting the issue fixed? I’ve got a vn doing the same thing

@-RossTheBoss 2 ай бұрын

I did actually, there's a few reasons why these cars can run rough. Like a bad crank angle sensor or ignition coil for example. For me it turned out to be the ECU itself, as soon as I put a new one in it ran fine! Of course that was after I replaced everything else though. rip my wallet

@booonzy7240 2 ай бұрын

@@-RossTheBoss yeah I’ve just bought it and it has new injectors new leads new coils I just put new plugs in it and a new crank angle sensor and it still runs like shit hardly even runs just had a look under it then looks as if it has a new fuel filter in it too 🫠

@-RossTheBoss 2 ай бұрын

Do you have a check engine light? Could also be the throttle body being dirty or the iac valve stuck. I had these issue as well, fixed them now my vp runs way better.

@florinodeguia6055 2 ай бұрын

Thanks for the video, I'm going to upgrade my lights this weekend. Thanks mate.

@jackwright6246 3 ай бұрын

What size is the fitting you used?

@jarradgreen6741 4 ай бұрын

Nice vid mate Do you do any of the other fluids yourself? Diff oil etc

@ozwasp 4 ай бұрын

Don't forget the nuts are imperial, not metric

@domstrains3984 4 ай бұрын

So will it harm the bike if the oil is too high? I overfilled mine and it is spitting it out like you say here, but I don't want my bike damaged.

@DaRucksogsepp 4 ай бұрын

This helped me alot. Now my 00 Camaro v6 has a New Waterpump. Big thanks from Bavaria.

@RossEllis-wz8ht 4 ай бұрын

hi do you need to wire the parkers?

@Crust2013 4 ай бұрын

Got the link where to buy these mate?

@TheHispanicPrince 5 ай бұрын

Thank You !!

@yagmurcakir 5 ай бұрын

What an awesome bloke. That’s a job well done mate.

@jsaplays33 5 ай бұрын

0:41 nice use of the force there 😂

@Kookakurra 5 ай бұрын

What bulbs?

@-RossTheBoss 5 ай бұрын

@@Kookakurra I'm pretty sure they're T5 wedge globes. I just bought a kit off ebay when I did mine, comes with everything you need.

@GrantMaxwell-cf3rt Ай бұрын

@@-RossTheBoss Can you post a link to the bulbs you used? The color and light diffusion looks spot on.

@paul5683 5 ай бұрын

You would have been better off using a screw driver to pry the clip off and either holding a rag or your hand to catch the clip. That pliers was made for a different kind of clip.

@-RossTheBoss 5 ай бұрын

That's a great idea, I'll keep that in mind when I do similar jobs. Thanks.

@frias2287 5 ай бұрын

Nice job 👍

@danielmillard8134 6 ай бұрын

You just gained 10RWKW doing that yourself

@nuffholz1468 6 ай бұрын

Haha this is bloody awesome 😅

@enkulman4096 6 ай бұрын

I dont have the same oil filter cover, i think i have to take off the ester pump to chatte filter?

@dynomite991 6 ай бұрын

Good video, nice and simpl3

@natymaher21 7 ай бұрын

Do you get static noise when using the radio ? Since installing mine the exact same way im getting static when using fm or am radio.

@davidsobin2405 8 ай бұрын

Awesome video mate. Just what I needed

@pov4278 8 ай бұрын

Got a link to the ones you bought at all mate ??

@jason-tk5rs 8 ай бұрын

Great job here

@ColinPearce-nr6lp 8 ай бұрын

Did you retighten the four bolts on the pulley?

@-RossTheBoss 8 ай бұрын

Yes you need to tighten them back up

@scotthoward4836 10 ай бұрын

Question sir. How did you get engine temp to come up on the dash? I have a 2002 VY

@braydonhallows8118 10 ай бұрын

Hold the mode and up (or down) on the left hand side whilst car is In accessory before starting and then wait for beep. Then start

@blankgen8003 11 ай бұрын

Good video a good refresher course. Dads old vs needs some tidying up to get it back on the road, he’s been gone six years.

@scottrussell7659 Жыл бұрын

Where are you located mate?

@Anthony-fq9ct Жыл бұрын

Great video brother!

@dutchbulls1 Жыл бұрын

i bought a new speedometer sensor becouse i bought the bike with the speedometer not working they said but the sensor was gone and now it says i'm driving 360 but i'm standing still 🤣🤣🤣

@stephensimpson9367 10 ай бұрын

Mine say 199mph on a 50cc fast as f#ck 😂

@davegunner8642 Жыл бұрын

Great Vid,excellent job

@nathanielgraham8588 Жыл бұрын

Need to change my water pump I'm confident doing it after this video cheers mate very helpful

@manadesigner2341 Жыл бұрын

I didnt get any plug and play when i ordered mine, do you know what i can do?

@adrianwhittlestone71 Жыл бұрын

Cheers buddy 👌😎 informative and a job now for the VX 😬

@lanceschbeiker5359 Жыл бұрын

Appreciate the video mate, I'll be able to actually see which globe I need to replace on mine now. (Since I've been looking all morning for someone to explain "how I tell which of the three indicators globes" has actually blown (Google had F all solutions).

@mavrickduxfield3682 Жыл бұрын

Where did u get the lights from

@-RossTheBoss Жыл бұрын

I put a link to the exact ones I bought in an older comment. There are multiple styles to choose from, have a look on ebay that's where I got mine from.

@ortizerikgaming240 Жыл бұрын

Great video 🙏 nice and simple

@paulsz6194 Жыл бұрын

Inecredibly simple process to replace the shock absorber bushings. Wouldn’t it have been better off replacing the rear shock absorbers, considering their condition?

@-RossTheBoss Жыл бұрын

At the time I needed to replace the rubber asap, as you could see there wasn't much left of it. I didn't get new shocks because it wasn't a priority and they're a bit more expensive than 2 bits of rubber.

@andrewlockley251 Жыл бұрын

Great video mate just ordered a set for my old rodeo

@Ducktape- 5 ай бұрын

What lights are they?

@thedavesofourlives1 Жыл бұрын

a rear wheel drive 3800, that's new

@-RossTheBoss Жыл бұрын

Here in Australia we've had the RWD 3800 V6 since 1988. First introduced in our Holden VN Commodore

@UNITED2009100 Жыл бұрын

Keep making them brighter so we can all blind those coming at us!

@invisableobserver Жыл бұрын

LED is a downgrade from incandescent.

@cpzmelbs Жыл бұрын

From memory the instruction sheet for the water pump mentioned the spacer only being needed for S1 buicks i believe. Working in spare parts I've opened many of these wp boxes and some dont come with the spacer at all

Ең жақсы KZbin

Пікірлер