Good job buddy! ordering the stuff now.

I think USGate makes a better way to go for those who do not want to fuss around with programming or deal with an incompetent service staff. Plus it sells for about $800 including solar panel, Lithium battery, and a 36/60 month warranty.

Seems to me the worm gear on the motor shaft is not secured due to roll pin failure.

I didn't get the part with the USB charger. and I don't see it anywhere. Can you explain please?

wondering how you balanced PID Temperature ( temperature you want it to smoke at ) and the temperature you need to make sure the woodchips start smoking

So whats the problem?

I am having the same problem now with an aleko ac2700. They tell me to change the close and open seen control. It did it with the same result. Cannot get hold of any by phone, only by email. The have the worst customer service I gave ever felt with. Spend some more money and get a better opener.

I had same experience, when i had it hooked up to solar system only, and yes I had to replace the control board also but still the gate moves only 4ft and stops, so batteries have 24v, BUT!!! measured amperage while the opener in operation, it is supposed to be 10amp rate, but it only reads 5.6amp then after gate slows down and stops after 4ft the meater drops till 0amps, so i hooked it up to 110v and it worked fine,I see yours is connected to 110v and still does the same, I just hope mine does not give me the same result.

I think we got the point without 20 opens/closes dude..

did u check soft start soft stop programing??