Transmission not shifting because of dirty transmission fluid. Wach full video to learn. Before damage your transmission

is the culprit worn out carbon brushes?

Which vehicle type?

Good video bro.. i have a 2004 spectra 2.0 and the temperature gauge dosent indicate that is over heating but after i run it for like 10 min a clicking noise start sounding what can it be ? The oil level is good .. Can it be the oil pump ?

Wach full video of how to get your AC compressor engage because of low freon, use r134a to recharge car AC system

Thank you!!!

What does it mean if it doesnt rotate fully

There is no need to charge your system! If your freon is low then you have a leak. FIX your leak.

There are probably a dozen or more videos on how to do this job properly. This is NOT one of them.

Let a pro do it .If you are using this you don't have a clue

Thank you I was struggling...

Adding freon if too low will turn on the compressor if not broken. No need to replace compressor.

Remember for safety use safetyglass, mask, and gloves for protection

Wach full video learn how to recharge your AC system on cars

Yes please! Service your Car AC yourself. R134A is very easy to over fill. I made 1000's of dollars from people trying to do this themselves. 3 or 4 oz. too much R134A in a hot climate will explode a compressor. Do that and you need to replace not just the compressor but the Condenser too. Flush the hoses and replace the accumulator too. Don't forget the expansion tube or valve as well. The reason you have to replace the Condenser is because today's condensers have very small refrigerant holes inside the tubes and you can't flush out all the metal derbies stuck inside from the compressor failure.

If your AC compressor not working. You can still try to recharge then it should start clicking, if not then replace. Or get it checked.

Loosen the nut, hold the bolt

Nice! I see it. 😉 looks good. 💯

Makes no sense. What engine? What year? What car? 🚘

Dude, completely disconnect the brake lines from the strut before you try yanking it out 🙄🙄

Stolen content

Daaam, the break lines are still attached too the strut,😢

Wow!!! Funny how good some people think they are 😂😂😂

Yes Strut assemblies are great but don't let them fall and cut your CV boots and it works better if you remove the break line too!

You forgot a word! How to NOT remove a strut!

Lol brake line

Learn how to replace strut with spring on a 2004 to 2006 Mitsubishi Outlander wach full video

If only it was that easy

Hey brother, my ratio control valve “T” shaped part next to the stepper motor gets stuck. Any idea how I can get it to move in and out smoothly?

How do you check the starter with this scanner?

Full video is out everyone go an wach full video

Do not top off brake fluid. As the pads wear more brake fluid is stored in the caliper. Now when you replace the pads, the master cylinder will overflow. Brake fluid doesn’t just vanish, and if it does you have a leak which needs to be fixed instead of “topping it off”

Refill while your bleeding keep it full

bro you need to do a whole lot of shit as well hahhaa

Um...

Was that neg or pos?

Lol you'll barely get the carbon of the outside of it like that. You need to clean the inside using injector cleaning and flow bench or ghetto it up and apply voltage to open injector and spray brake clean into inlet.

Wow, what a revelation

Try removing the nut first

🇯🇲 yaad man 🤔

MEUI injectors are pretty cool

Especially don't forget to lube before sticking in..😅🎉😊

This video was very helpful! Thanks.

Thank you for showing me this

That's how you destroy ratchets.

Amazing!! Lol

Depends what car and suv you have, usually complete strut with spring available online you can do it. Just wach full video to learn

Engine light didnot came off i will do a follow up on the other two oxygen sensor this minivan have 4 oxygensensor

Honda...push it in a little and it'll come out

It's called a door panel tool.Wal Mart