jeff would you use the same process fortransferring from an ix20 to an ix14

Very kind review in helping others. Great video work also!

Great information. Never noticed the shadow X in the casing. Thank you for explaining this so completely.

Im having a problem on my ix20, my battery continously drains even after i turn it off and while i charge the battery from inside the transmitter it beggings to boot loop. I bought another battery (not spektrum) but the problem stays. Any ideias?

You’re paying for quality I’d rather do that then support commie china imo

G'day Jeff, great video mate. Just a few questions. Did you take out the thrust tube to run your rudder extension and run it along the top or bottom?and did you use the recommended throws on the skywing video for low and high rates?

Great video Jeff. Lots of good information.

Hi Jeff, thank you for sharing. It will be great if you can share your Transmitter settings for this same plane. Thanks.

I didn’t know naphtha was pronounced napa.

Hi Jeff, have you made part-2 of this yet? Thanks

Thanks for the very informative video ❤

oh my goodness gracious! if only Michael Wargo had explained it like this when I started in the hobby last year! Thanks!

Hi Thanks for the quick informative video .. how was the CG after test flight? Any fine adjustment?

IMHO: HAVING "GYROS" TO HELP "STABILIZE" OUR AIR VEHICLES, IS VITAL, BECAUSE WE ARE NOT GETTING ANY DIRECT, IMMEDIATE FEELINGS FOR THE "G-FORCES", BECAUSE WE'RE NOT "ONBOARD".... ALL WE MIGHT BE GETTING IS THE DELAYED VISUAL FEEDBACK, THEN, OUR DELAYED REACTION TIME, AND, LIKELY OVER/UNDER CONTROL, WOULD LEAD TO CATASTROPHIC CONTROL RESULTS!!!...

So basically you know how to make a cruise missile! 😮

What Spektrum recievers can be used on small turbine jets ? Like the sebart mini avanti with K45g4 ? Is it possible to contact you directly ?

OMG your funny…. “Build a Pro R on a Budget”.. lolololol.

Jeff does the AR20410T have the option to modulate the brakes? For my turbine I got an AG68 brake gyro to have proportional braking.

Sorry, I have been out of the hobby for 40 years, I used to fly rc fixed wing and helicopter. I would use a gyro on the tail rotor in the heli, but never used one in a fixed wing. Why do you use a gyro in a fixed wing, and how does it integrate with the controls?

Hot glue them in. Done. Need to remove it? Rubbing alcohol

The brakes are terrible

Hi Jeff. you know anyone who is selling a Spektrum DX18 radio Mode 2? Great vid brother.

Nice video Jeff , what size are the 2 cell batteries you are using for the receiver itself

These were design by a friend of mine in NC. named Ken, His are the best I have seen, But there are a lot of different style on different web sites that work well. email for me is [email protected]

Nice!

Hi Jeff great video I don't know where to find your email address, are you able to post a reference to the stl files you used for printing all these items?

That's awesome just set up mine like that 1st jet not done maden that will make life easier 😂

Nobody tell about GPS moduls on the brand new NX8+ and AR8360T+ recivere. is it possible to see speed on the plane with the GPS module

A little off topic question? Is there a video on how to turn on your airplane from the transmitter, thanks

Any links? What size chase light bar is that?

I've been trying to tell guys about servo arm length and not turning down the travel in their transmitter for years. I'm glad I'm not the only one who knows this. Thanks! - However, when the gain channel is at -100%, the gyro gain is zero. When the gain channel is at 0 (the center), the gain is 50% of the max value, and when the gain channel is at +100%, the gyro gain is 100% of the max value. The gain channel doesn't need to go below -100% or above +100%. It's been like this in the AR636 and the newer Smart AS3X/SAFE receivers, and still is with the new AS3X+ firmware. And, this applies to the AS3X, SAFE, Heading, Stop Lock, and Stop Release gains. Also, Miguel says they've doubled the gain in the AS3X+ algorithm, plus they've added the sensitivity settings of 0.25X and 0.5X. I'm having to change my setups from 1X to 0.5X to keep my planes from going into oscillation. I like to use a gain sensitivity that allows me to set the gains between 30 and 70 percent. I don't like using the bottom or top 30% of the scale. I calibrated precision test equipment for 35 years and we never used the bottom 25% of scale in our measurements. Check out my latest video on using AS3X+ with my iX14 transmitter.

Thank you

Really good explanation of the reason for maintaining maximum servo resolution.

Great video as iv just got this as my 1st jet

We need more turbine trainers on the market. Some folks want to be the Tom Cruise of the airfield and play Topgun music while flying the jet on pavement for bragging rights...

Any chance I could get a measurment from you on the exact width of the exhaust outlet without the thrust tube. I'm bulding mine EDF and everything hinges on what the size of the outlet is as to the fan unit I can use.

Wow! nice to know. I've been out of RC for a few years and just getting back In . So much has changed, it is hard to keep up. Thanks

Just had my first turbine flight. What fun. No going back

hi my name is Bill and have been an aero moudler for 40 years and this is my first Turbine and have gone all out whith the purchase of plane and recomened equipment incluiding a new IX20se and a synaps reciver and was interested if you could point me in the right direction for programing and thanks for all your help in my build

what a nice video.. thank you man... really helpful

do you have a link or model name for the charger you use not the usb c

What’s the difference between the g4 and g5 king tech turbines? Is it true the military scheme mb339 has upgraded landing gear?

Nice plane Jeff. Hey Jeff, I have the MB339 (non-military version 1) MB, and I am looking to upgrading it with buying and installing the gear from the military scheme MB. Is the gear controller box for both Version 1 and Version 2 are the same, that way all I need to do is buy from Horizon the version 2 gear and drop it in. Thanks.

Also what is the minimum battery voltage that you should not fly the airplane? Thanks. Great videos

What is the fully charged battery voltage, to know when you have a full charge.

Can’t thank you enough. I was almost regretting my move from NX10 to IX20SE because I couldn’t figure out how to set up the time remaining. It’s so easy with the NX series.

thank you man.. you solved most of my questions. I wonder not if I wrap up the AR10360T in foam and 3D print a casing for that I f I can uyse that receiver in a jet plane 6kgs and 8kgs thrust which I usually fly and prevent interfeerance.

Hi Jeff I have the New ix 14 spectrum Transmitter. Can I use a spectrum AR 9020 DSM X plus receiver with 2 Satellites.

I don't think so last time I tried it there were some sort of incompatibility issue

Great tutorial! Can this be accomplished between an iX 20 and an iX14 as long as both are updated?