3 ай бұрын
3 ай бұрын
4 ай бұрын
4 ай бұрын
2 жыл бұрын
2 жыл бұрын
2 жыл бұрын
2 жыл бұрын
2 жыл бұрын
2 жыл бұрын
3 жыл бұрын
3 жыл бұрын
3 жыл бұрын
3 жыл бұрын
3 жыл бұрын
3 жыл бұрын
4 жыл бұрын
5 жыл бұрын
6 жыл бұрын
7 жыл бұрын
7 жыл бұрын
7 жыл бұрын
Пікірлер
@spicydogsoup Ай бұрын
Just install a new washer with my old Samsung dryer. The SKK8K is backward compatible with all previous Samsung older model which is nice.
@3personality 2 ай бұрын
Do you have some tab note of this song for bass?
@wswartz79 2 ай бұрын
Tried watching, got seasick from the swaying 😂
@leightontavico2396 4 ай бұрын
omg very helpful thank you
@georgeparkins777 4 ай бұрын
Careful, this didn't end well for Jack White
@inking5917 4 ай бұрын
😊
@NIZZGA 11 ай бұрын
Nice bass cover!!!
@Mikehoncho191 Жыл бұрын
Have you ever considered a guitar? I might be able to help out
@DanielMacEachern1 Жыл бұрын
LOL what the hell is this and why post it LOL
@sg-gj4ex Жыл бұрын
Thanks ya i bought a kit for 50$ replaced belt , rollers and also belt pully. Both rollers and belt pully were seizing up. Clean up the lint as well inside been good so far. Concerned will need to do again after some time
@mikeyergler9599 Жыл бұрын
It's the rollers, those units are not as bad to work on as you think
@mr.goalie4014 Жыл бұрын
I think you should repost this video and either higher the bass or lower the sound audio so we can hear it better
@sg-gj4ex Жыл бұрын
Im planning to do a second take on this and reupload thanks 🙏 also check out my full video if you have not already
@inking5917 Жыл бұрын
👍
@jonathanhavel1036 Жыл бұрын
I bought the same stacking kit model.. I have a 2 year old Samsung washer and it worked perfectly with my new Samsung dryer. You obviously used the wrong brackets. It comes with two pair. One for older models and one for newer models. It's funny how the stupid delivery guys didn't know either. I almost thought I was screwed until I decided to READ THE DIRECTIONS! LMAO!
@tripcerberus4384 Жыл бұрын
If you must have your dryer near your water heater/furnace, make sure to not use dryer sheets. This will protect the ignitors. I learned this the hard way.
@sg-gj4ex Жыл бұрын
Thanks good to know. I ve never used dryer sheets and never will now.
@tjtewshews5531 Жыл бұрын
Sorry, I'm not getting why you shouldn't. What exactly can happen?
@tripcerberus4384 Жыл бұрын
@@tjtewshews5531 flame sensor rod gets coated with contaminates and fails. Cat litter also causes a similar effect. Sealed combustion chambers with outside air intake may prevent these issues.
@sg-gj4ex Жыл бұрын
@@tripcerberus4384 Thats good info to know now even before i moved my washer dryer near the furnace id always have to clean flame sensor bi yearly and always wondered what causes this. The furnace mans said mostly carbon and its normal but others i know with furnace’s never had this issue at all. I have a new furnace now so i will see but no sealed combustion chamber. My hot water tanks is like that but ive never had clean the flame sensor even on old one that was not sealed
@inking5917 Жыл бұрын
I really love this song thank you for doing this bass cover
@rfishrfish4242 2 жыл бұрын
AUTO FLOOR SUCTION SETTING, Automatically changes to the correct suction, no matter what type floor surface your on....
@sg-gj4ex 2 жыл бұрын
The rocking has continued but very minor and not enough to be dangerous its just before a spin starts but just mildly , its far better than without pads when I got massive vibrations and shaking . I have continued to use them to date no issues and nothing had got worse so at least its stable
@datdo9283 2 жыл бұрын
I'm having the same problem with the vibration with my stacked machines. Did you keep the vibration pads or were the machines rocking too much? Thank you
@hutzman7664 2 жыл бұрын
Do you still use it or did it get destroyed?
@sg-gj4ex 2 жыл бұрын
Still in use, its very durable. Works perfectly no issues
@jamiefronk7587 2 жыл бұрын
For God's sake...stand still. I'm sea sick half way through.
@ngocphuong91 2 жыл бұрын
Great
@FAPMTCProductions 2 жыл бұрын
amazing
@beachboyness 2 жыл бұрын
Thank u for the info
@Tiddliwinkz 2 жыл бұрын
I can't find this kit anywhere :( It looks to be the one I need.. I purchased the 7k and the holes don't match up with my dryer, the brackets are set too far back.
@sg-gj4ex 2 жыл бұрын
If the holes match up with your washer on on the on skk7a they should line up with a samsung dryer. The bracket does sit far back and then you push the dryer back onto it and screw in. The dryer is meant to over hang the washer on the back with these brackets. Also do you have manual for your washer? It will say which bracket you need to use. When did you buy your washer ? Did you buy it new?
@sarahjustice8804 2 жыл бұрын
Thank you for this! I am going through the same thing. Had to replace our previous washer but kept the dryer.
@dchorzempa 2 жыл бұрын
*I can’t say enough about this vacuum🌼 **allabout.wiki/Miele-C3** We replaced all our old, but dense, carpet with new, even more plush carpet. Could not use my Dyson with it! Love the various suction settings and the height adjustment settings on the power head.*
@setjofarm582 3 жыл бұрын
nice
@randyjackson1517 3 жыл бұрын
I have the c3 complete same model but I don’t have controls on the handle wonder why
@sg-gj4ex 3 жыл бұрын
Is it a c3 complte power plus, does your power head have a light. Miele releases so many models and variations and promotions even for specific stores. Is it green?
@loucrappi5869 3 жыл бұрын
The bags are probably expensive to
@loucrappi5869 3 жыл бұрын
For the money that you pay for it you should be getting a little powerhead for the Upholstery and for the stairs
@joealcala4406 3 жыл бұрын
Why are you dancing? Lol
@stevenrooney6525 3 жыл бұрын
I have a very similar Miele it has the same floor tool but the vacuums a different colour. I'd agree it's an excellent vacuum cleaner.
@PlayerBassThe 3 жыл бұрын
👍
@NoName-zz8nl 3 жыл бұрын
They look nice as hell
@ianmayer2951 3 жыл бұрын
The dumbest vacuum reviewer... he doesn't deserve a Miele that great.
@bettyhordeclinic6147 3 жыл бұрын
Hey if it works why not I must be honest i the UK we just put th3e drier on top and don't use any brackets massive like fW
@avrobertson01 3 жыл бұрын
Super helpful Thank you
@lindseyb982 3 жыл бұрын
How tall is the top of the dryer when stacked?
@sg-gj4ex 3 жыл бұрын
About 78.5 inches. This will depend on your washer and dryer heights and leveling.
@dennischallinor8497 3 жыл бұрын
Hey genius they give you an owner's book for a reason. I hope for your sake it isn't in German!
@hotcookiesnana 3 жыл бұрын
Thanks for the video!! Made it super easy to install. Using the handy dandy genie lift to put dryer in place.
@sg-gj4ex 3 жыл бұрын
Id like to see what you used to lift the dryer, a genie lift?
@hotcookiesnana 3 жыл бұрын
@@sg-gj4exm.northerntool.com/shop/tools/product_200619392_200619392?cm_mmc=Bing-pla&Bing_PLA&Material%20Handling%20%3E%20Pallets%20%2B%20Pallet%20Handling%20%3E%20Pallet%20Lifters&Genie&msclkid=ea9e762df22a15285f24297060bc31d3
@devilkidism 3 жыл бұрын
Wonder if there were any grommets in the steel studs that had wires running through them
@sg-gj4ex 3 жыл бұрын
Yes there is
@christos7440 3 жыл бұрын
Nice work - I can actually USE this video
@mohawksteel2215 3 жыл бұрын
well done and well explained
@KEVPR 4 жыл бұрын
Thanks for sharing
@jstcs61 4 жыл бұрын
thank you it was useful
@brianemanuelnasiah93 4 жыл бұрын
Dude... Thats me🤦♂️😆🤣🤣🤣
@celticstephenhill 4 жыл бұрын
Do you need to unscrew the legs on the dryer before popping it up onto the washer? I didn't and when I slid it into position it scratched the face and top of my washer. So much for my brand new 2000 dollar machines. 😥
@seanwdowling6546 4 жыл бұрын
just saying its pronounced mele or meler not miel
@rfishrfish4242 2 жыл бұрын
Y,LIQ....
@keibisesq 4 жыл бұрын
Oh my god... you're a life saver!