Great vid.... Guarantee every dealer cheats and pours coolant in.... Wish they were as good as you!!!!

This video helped me out of a jam. Thank you so much! You saved me a lot of trouble. For some reason, the water pump sprocket wouldn't pop all the way onto the hub, and I think it was a design defect. But the same thing happened with the tensioner. I know how much slack is supposed to be in these balance shaft chains, and this thing was CRAZY tight, and ratcheted out like you said.

You have no idea what your doing

No revs?

Will this work with the driver side?

Hello, I can’t find the fill plug on my 22 Mdx up top

What’s VSA MODE?

Good video, thanks!

Excellent video. Thank you! Expending on marketing rather than on quality became the go to business strategy for so many manufactures of almost everything these days. I will remember that brand and avoid it regardless of how appealing its products may be priced.

I have same problem how did you solve it?

Ive had three different brands and the longest ive gotten from yhem is 3 years. They are all p's o.s.

Hola disculpa de la forma que tu lo hiciste, cuantos litros le pusiste? Y como se puede extraer todo el fluido, muchas gracias, saludos

Hi. How has this held up over time? Seeing if it’s worth a new or doing this for long term.

cheaper to make thinner walled coils than add an extra layer of tubing to get needed heat transfer- between efficiency standards and profit motive, quality gets killed. new ones end up wasting more resources than good old inefficient ones because of how frequently they fail.

What solution? Change transmission?

We replaced the water pump but not that tensioner and now we have the whining noise do you recommend replacing the tensioner or just resetting it ?

Yew😂right about dat nothing better taahdu€😅 2:22

So I have this same one. Worked great for 2yrs, recently started icing up. It appears to have no leaks, low on refrigerant?

( What when why how ) you replacing those parts , waisting time

hi how much do you charge for this job

hi how much do you charge for this job?

Nice vid bro! One question I’m confused about. Is the transfer case the same as the center differential? Thanks in advance!

To confirm this is OB5 7 speed s tronic gearbox? .... The transfer case and the front diff only had about 1 litre of oil in each? I'm doing my cat delete now and it's really easy to do this maintenance work now as well. Just wanna order the correct amount.

This is what i need! Ive tried figuring whats wrong w/ some research but also maintenence & repairs along the way. A couple yrs of staying broke & no actual good advice concerning 'noise', trans smell, a/c issue, possible water pump due to noise, timing, hasnt helped the cause. Your timing video led me here. Thank you although i doubt i can do this myself. Need a tool shop about now

So how much is the cost here? Whats involved w/taking exhaust sprocket out w/ both guides & reinstalling the chain? Tools & cost? This is my next step after transmission fluid & replaced both solenoids which were in bad shape, gunked & stuck. Now im totally gonna check in the am as to where my engine cover has that 'most wanted' ring you speak of

I wish you could go over how you filled it with the r-410a, you didnt show how you connected the lines to fill the unit with refrigerant. You have the best video so far that i could find, but still lacks that detail.

this low quality manufactured junk is whats filling up the landfills

Does it retract the rear ebrake?

Ok after pulling put pin 3 . What are the rest of the PIN numbers ?? After 3 then what ??

How is it working?

i don’t hear anything wrong

So that is why my blend door actuator didn’t fit on my driver side. I guess I have to set up to that setting so it would be able to fit. Is that correct?

Set temp to 64. Took out actuator and cleaned. When cleaning I did not move any gear positions. On reinstall, my damper air mix door lever had dropped (I think). I had to push the lever up so the plastic square gear lined up with the lever square opening. On test, the actuator moves the lever down when at 60 deg. But on raising the temp to 64 degrees, the actuator moves the lever all the way up and blows warm air. I don't think the cog/alignment was off by 180 degrees. question 1: should the actuator be lifting the lever in small steps with temperature or one big motion. question 2: anyone try resetting the software controller somehow?

Darn good video, thanks.

So I literally just got my wife's car out of the impound shop.. just earlier today the damn key broke inside the cylinder.. smfh.. I now how half the damn key inside the car.. in the parking lot of a CVS.. praying to god it doesnt get towed.. AGAIN.. and cost me another $600... any suggestions?? I'd like to just buy the entire damn ignition cylinder with key n all cheap or not theres a couple on Autozone, O'Reiley's, ect., may not be the best but I know they'll suffice for now.. therefore I have no key essentially to pull the cylinder out with or even turn over to accessory as you have.. I suppose I'll have to pick the lock in some way??

It's been 2 years since this video was uploaded, how are the exhaust holding out?

if my fan speed control isnt working, can i apply 12v to the gray wire with the black strip to verify the control switch is bad? I have tested the BCM and blower motor and that all checked out but the fan wont turn on or change speed when i turn the knob. from the wire diagram i have, that wire runs to the 16 pin C! on the back of the control box

can you do this with a map gas torch? To repair leak I mean.

Do you know which companies let you keep the original (broken) dehumidifier after using their 1 year warranty?

Will it work for a 2022 Honda Pilot black edition?

it doesn't need the pump to come down, as long as the fluid is still in the cyl's it will just come down normal.

Where did you buy R410a?

What normal R410a pressure should you read on these demuhidifier when turned off at room temp?

LOL I'm sure same problem: Not even 1 year old top Frigidaire Pump 70 pint unit - has the same tint blue coil. Ran for about a hear, then no gas, pump rungs coils room temperature LOL I wonder if this issue is related to the "blue" coils???

I'm about half way thru this job tonight. I was really annoyed when I spent about an hour searching for the right tool to remove the harmonic balancer and it was about a minute to actually do the job. I was starting to worry why mine was so loose when I pulled the bolt and you needed a puller. Bravo for posting that, your an honest man who I'd trust to work on my car. And thanks for a laugh (with respect). I used an "Earthquake" cordless impact wrench that was recently given to me to loosen the crankshaft bolt. After I finally found an 18mm socket I realized it was a 1/2''' drive tool and I had to search some more. When I had it all together that tool brrraped that bolt right off and the balancer was clearly loose. hour searching for 45 seconds of working. lol

Thanks for the video brother, after topping off the fluid did you have to hook up to vcds?

I made the mistake of buying a Frigidaire FFAP5033W1 from a wholesaler off of Mercari for $90 less than Amazon. It was great for about 10 months. After sitting most of the winter, I noticed blue liquid in the tank. I cleaned that out, turned it on, and it ran awhile then quit, displaying "EC" without ever producing a single drop of water. I contacted Frigidaire. They said no warranty since it wasn't purchased from an authorized retailer. I took it apart and ran it with the cover off, compressor and blowers run, but nothing gets cold except a little coil (I think it's the capillary tube). If run long enough, the compressor gets too hot to touch. There was a little blue/green dried residue in random places in the unit, I assume is corrosion, but couldn't really tell the source of it. I'm assuming it's leaked out all of its R410a. I've replaced compressors and filled refrigerant on cars, but your video shows me this is probably over my head. I guess moral of the story is don't buy one of these without a good warranty. Or in my case, don't buy one of these at all and just live with a humid basement.

Thank youuuuuu🙏🙏🙏🙏🙏🙏🙏🙏

My car sounds like it got a super charger and I don’t like it it’s seems like it’s getting quieter but it’s not

Thats spark knock, its pre detonating. I know its an old post but for anyone else, could try some octane booster