Great info but the audio is not good

love your wife's lil hand wave

I built this system,WithOut the two soda stream bottles. When breathing from regulator i can hear the pump sound change as if im drawing the pump down. Any suggestions how i could check this out? Thank you

Was this with you dc rig you made? Thank you

Hello, your information is very valuable. Can you share the brand and model of the engine you use?

for the accumulator why not use heavy wall PVC?

I have received a Chinese made portable hookah but it does not have an accumulator or inline particle filter, just a tiny carbon filter for moisture. Would you be able to provide a parts list how you were able to link the accumulator air in and out plus joining the soda stream bottles together and linking the air filter, water separator. Including those quick release purple connectors. I am from Australia so NPT is not that readily available (but can be ordered) as the British system is what we are used to. I bought an air hose from Gator GIll, but just not familiar with the connectors. Cheers.

How long it passed to get that amount of barnacles?

Che pressione massima può raggiungere? grazie

thanks for the video and information i have purchased acq 910 but am finding it a little difficult drawing air with the regulator...

With these 2 bottles did you pop the fitting out of them thank you

How has this held up? Are there rebuild kits available for the pump? Thanks

Thank you

Does anyone know how much pressure this compressor puts out? Thanks

Can't back off adjustment nut on regulator to work with this low pressure setup,need to get using 5mm socket...what's the trick to popping off cap on side of this reg..seems glued on real good..thanks

Satisfying work you're doing, that's the job I love to do, I'd done it on several military boats but as a military diver that was done for free 😐

Is that a 60w motor,120liter per min? Or a 120 watt 160 l per min? Thanks

You can contact unmanned robotic systems to access this service.⚓

Time to hualout

Is this the ACQ 910?

Is the accumulator tanks necessary if I’m going to be only going maximum 10ft under

May I ask how many watts is this aerator?

would that pump run off a small 12v battery for a decent amount of time? I want to build this in a floating tote setup for metal detecting. any advice appreciated thanks!.

Güzel olmuş Abi

How often should you do this

Can’t hear you !

l am in moroco l want toi buy it how Can bay it

how many liters per minute is that pump 120lpm or the 160lpm

Is the fitting in the pump casting 1/4 NPT Female if the hose barb is removed? Seems most people are keeping the short section of hose and putting a barb into that. (Edit: No it is not 1/4 NPT, it is smaller.)

Audio is crap

Bravo Danke danke

how long was the hookah that you used

Where'd you get the suction cup?! I must know immediately

Where'd you get the suction cup?! I must know immediately

Dear Sir/Madam, I would like to apply for a full time position as a commercial diver. I have all the relevant certificates and experience that is needed. My resume is attached to this email. Thank you for your time and consideration. Regards, Manikandan

Try: hullcleanin15.com - Drive-in Boat wash! - will clean sailboat keel

Hi. Great videos! I have a question, when the pressure in the tank reaches the maximum around 18 psi and the pop-off valve isn't activated, will this damage the pump if it stays on?

Can i ask what needle you used?

That was cool!

Tks for your help. this is my product : www.poseidon.ouiprod.com/?page_id=1302

I’ve thought about doing a couple of the wallets that Sailrite shows on their KZbin channel made from Cordura nylon with the banding around the edges. Do you think this machine would have any problems with that? Thanks

I want to buy that compressor

Looks dangerous!

Do you know the amperage draw on these pumps? I just ordered one for a hookah system but I am trying to get my battery assembly set up. I need it to run at least 1 to 2 hours on a charge. I do plan on adding a solar panel to it to help keep it charged. I was thinking about a lithium Ion battery or a Life POV4 .

what thread did you use for the bottom thread - according to Singer you can't use a heavy thread on the bobbin as there is no tension adjustment. thanks

I can see myself doing this

I'm looking to build a hookah myself and thanks for the details on cleaning the pump and the tape for the separator. Good content. Thanks 🇺🇸👍😎

Great video, I am building one of these and have most all the parts purchased. I did get the same cheap Chinese regulator and am wondering how you adjust it. All other regulators are adjusted with a screwdriver after removing the air hose. There is no slot for a screwdriver in this opening. Do I need to remove front cover, loosen lock nut and turn out the mechanism on the inside to make adjustment? Thanks!

Great video. I have just received the air pump but it didn't come with a part to attach a hose. Could you tell me what part you orderd or where I could track one down. A parts list for the whole build would be great.

Nice job! What would you charge for job like that?