SkidStarT66

Пікірлер

@tentman4fun 4 күн бұрын

Nice system I bought that and made a camping kitchen pantry I love it works perfect for this

@russbeard3665 Ай бұрын

Nice, Thx!!!!

@billymcmillen202 2 ай бұрын

Nice looking attachment. I’m thinking about buying one of these for my Kubota 75-2. Are you running this on high flow or just standard flow on your machine? Nice video, thanks!

@skidstart66 2 ай бұрын

I have a two stage pump on the skid loader. So yes I can run in “high flow”😂 mine is like 25 gallons a minute on high.

@billpedersen568 5 ай бұрын

How did the engine braking work out for you on this ride?

@jzsuperstar9948 7 ай бұрын

I'm loving the Bauer line. It's right at my budget level and they are quite tough and so far reliable. I've built a catio, shed, rolling cart for my HF band saw (had that for 20 years almost) and 2 flip top rolling carts for my table saw, spindle sander, drill press and belt sander (both 20 years also) and a few other things. I just got the Bauer cordless 7 1/4" sliding miter saw and I'm in heaven. I'm looking into this rolling tool box for convenient tool storage and I'm pretty sure you sold me on it. I don't care, I love Harbor Freight. Thanks for the review!

@The_Bow_Show 9 ай бұрын

I need a community to create stl files for dividers for these bad boys

@lynneldridge480 9 ай бұрын

All mulching videos should use classical music to go along with them. So relaxing and therapeutic.

@Controls27 Жыл бұрын

Do the tires rub on the mud guards when you do full turns?

@joerutkowsky3261 Жыл бұрын

The service manual says to warm the motor up at idle. Then put the jumper in as it’s idling. That’s how you check the tps. I did this and it was good. But cold and not running it was on the bottom like yours.

@DOOMRiderfpv Жыл бұрын

@skidstarT66 is that a speaker cargo box on the rear of the atv?? If so how is the sound and where can I get one??

@Yellow1000canam Жыл бұрын

I have one on a 259 CAT. I have over 500 hours on mine I love it aside from the teeth

@pdbuilder8212 4 ай бұрын

What up with the teeth issue, I'm thinking about buying one of these

@Yellow1000canam 4 ай бұрын

I was not sharpening or replacing enough.

@billhillegass946 Жыл бұрын

I installed my Andersen weight distribution hitch per instruction, it seams to me that every time I disconnect and reconnect the chains are to long or to short. When I get to my destination and disconnect I loosen the nuts on both sides and remove the shark fin all is good. When I leave and reconnect the amount of threads remaining at the end of the nuts are always different. Sometimes I run out of threads sometimes I don’t have enough threads to even start the nuts. Thank you your comment is appreciated.

@rone1523 Жыл бұрын

This is a bomb waiting to be set off with a static electricity charge. The compressed air you are putting in it contains oxygen and when mixed with gas fumes becomes and high volatile gas and just like in the combustion chamber of a internal combustion motor, supply a spark with the removal of the lid or air line and that's all she wrote. Fuel pumps in newer vehicles are mounted in the fuel tank and a spark in there won't cause an explosion because there is no oxygen, just gas fumes. The fumes need oxygen to be able to burn or explode. I have replaced several in tank fuel pumps that have shorted out or arced on the fuel sending unit or the wires being shorted and no explosion because of the lack of oxygen. That is one of the reason you are not supposed to fill a gas can when it is in a vehicle, trunk, truck bed, but to set in on the ground before filling it. Remember today just may not be your lucky day but your last day.

@Gunmetalbluejeeptjs Жыл бұрын

What vehicle is that

@tieoneon1614 Жыл бұрын

And then the Bro's wonder why their nice riding Tacoma now gets 16mpg, feels sluggish and cant hold 6th gear on the highway.

@mojavedesertsonorandesert9531 Жыл бұрын

Looks clean, stocked!

@mojavedesertsonorandesert9531 Жыл бұрын

Looks like your "Bauer out" there. How you liking there drills? I do like the hand sanders, have three, they are excellent for the price.

@mojavedesertsonorandesert9531 Жыл бұрын

Was looking at Milwaukee's will have to give this a serious look!

@bobbyjones2112 Жыл бұрын

I don’t like how the wheels are attached by a cotter pin that seems kind of cheap.

@neilmays6744 Жыл бұрын

Did you break those first? If not that was very impressive.

@brandonhuitron Жыл бұрын

Quick question how much psi should I run them with?? Same size

@jeffnaval4894 Жыл бұрын

different brand tires means different PSI. you have to check the manufacturer.

@treimche Жыл бұрын

Do you have any tricks to get the last 1/2 gallon or so out of this fuel caddy?

@brz757 Жыл бұрын

Did you ever use this? There's only one actual review on KZbin of this unit model.

@brz757 Жыл бұрын

It's the much improved Lowe's version of the tabletop grill. Coincidentally it looks exactly like the pit boss navigator 150 that they sell in Europe.

@Charlie2Socks Жыл бұрын

Where'd you get the black ramps?

@skidstart66 Жыл бұрын

Hey Chuck they are automotive oil change ramps. Here is a link for some on amazon. amzn.to/3GOJWga

@judichristopher4604 Жыл бұрын

Is this brand new? I have never seen this one. How about a Pizza in this puppy? This is really nice, thank you for sharing this video.

@lobbyrobby Жыл бұрын

What your thoughts on the Bobcat snow pusher. Is it good at following the ground without digging? I'll be pushing on gravel and would like something that floats and oscillates a little bit as our ground isn't completely flat without digging up a bunch of gravel. Thank you

@skidstart66 Жыл бұрын

Yes it does a good job of following the ground without digging in. You may have to adjust the cutting edge so it doesn’t pick up gravel. I found that I can roll the bucket/plow back enough to skim the surfaces with loose gravel. That works well for me. Thanks for watching!

@lobbyrobby Жыл бұрын

@@skidstart66 thanks for the reply

@timbradeen8459 Жыл бұрын

Thanks for the video! I just bought one of these heads.

@skidstart66 Жыл бұрын

You bet! Have you used it?

@timbradeen8459 Жыл бұрын

@SkidStarT66 Not yet it's stuck in a trucking yard. -30 here! I'm anxious to use it.

@sasquatchrosefarts Жыл бұрын

That first tree was good lumber. It woulda been a beam for a shed.

@keithloucks7167 Жыл бұрын

I have had 4 sets of KO2 on different Trucks and they work great in snow and highways while icy in Northern Ontario. If it is icy and at freezing, nothing works, stay home.

@MikeelMoose Жыл бұрын

Thanks for the video. I was looking at getting the Decked system but wondering if it would really stand up to supporting the weight of an ATV. Any issues with now that you’ve had it a while?

@skidstart66 Жыл бұрын

No issues! The deck system supports my atv just fine.

@leanit5756 Жыл бұрын

BFG has been the answer in AT tires since the 70s. They aren't passenger cars tires with a tread that looks like an AT tire, they are an AT tire. Seems like many of the tires that are presented as competitors today are really a different class of tire. It you plan to drive at any speed on dirt and more importantly rocky surfaces, you need puncture resistance. The class of tires that have an AT tread but a light weight sidewall/carcass are going to let you down, sometimes in the first mile or two of use on sharp rock, unless you like to drive around near idle speeds.

@robertsponge1744 Жыл бұрын

No auto locking is a deal breaker for me. When I stack, I don't want to waste my time or forget to lock the box. Snap on and walk off.

@slickrickdarula9483 Жыл бұрын

How has it held up? I noticed the locking latches on the side are plastic just wondering im looking into getting some

@jwatt95 Жыл бұрын

Has anyone had both these and the new mickey Thompson Baja boss at? I'm extremely impressed with everything I've put the bb ats in. They've done exceptionally great in deep snow, wet, dry, mud ( I try to keep it a pavement princess) and everything. By far the best tire I've ever ran but these things are also heavy. I have 275/55r20 10 ply on a 20x10 wheel. 04 yukon denali that weighs roughly 7k pounds from the extra weight and I tow often as well. Have 50k miles on them with 13/32 left out of 18/32. I'm considering trying the bfg ko2 out since its lighter but I've heard wet traction sucks and they wear more since the original bfg kos. If anyone has any input that's ran both I'd greatly appreciate it

@Seattle808 Жыл бұрын

Boss AT is a newer more superior tire than the KO2, stick with the Boss don’t downgrade.

@jwatt95 Жыл бұрын

@@Seattle808 I was looking at them because they are a 8 ply tire and was trying to split the difference between the previous 6s I've ran and these 10s. I can't go back to a 6 with as much weight as I've added in this thing and as much as I tow now. I doubt they'll perform better. I've been severely impressed with these.

@tonyschowalter7314 Жыл бұрын

I ran BFG AT'S originals and KO'S for 22 years on all my trucks ford rangers all way up 1 ton trucks and I put two sets on my wife's SUV'S trust me I definitely put them to the test of heavy hauling deep snow, mud,sand ice, I never had never had a problem with them even on wet roads or hydroplaning in deeper water it will pull you to one side but that will be expected for any Tire I work construction and I own farm now I'm running Firestone destination XT because they where cheaper they perform the same as The BFG AT'S I live Northeast Wisconsin hopefully the answers your questions

@guyfawkesuThe1 Жыл бұрын

This is the same system as sold in Menard's stores under the "Masterforce" brand. And yes they probably do interchange, although the Masterforce seems more expensive.

@nickm9102 4 ай бұрын

Masterforce is more expensive, has fewer options and has cheaper accessories. The inserts in the big box doesn't have the elastic straps and the containers are lower quality and do not have an attached lid. Realistically HFT did it better all the way around.

@TVUtah Жыл бұрын

Amazing machine to watch. Wow! Great work.

@wiredperformance6130 Жыл бұрын

Great for those who aren’t into a specific brand. Cheap. Seems to be built as well as the others. Not my choice but after 2 years of buying packout I like the options.

@Gracebeliever077 Жыл бұрын

Thanks for this video. It's helped me to make a decision. I just have to wait, as I'm told they're out of stock on these until later in October 2022.

@richardphysician5640 Жыл бұрын

How has it held up?

@epenaloza52 Жыл бұрын

5 BOXES!? FOR 180?! FUCK THAT I'm taking my ryobi back and getting of these

@robertsponge1744 Жыл бұрын

Don't do it, it is a trap. You will like the Ryobi Link better.

@joerutkowsky3261 Жыл бұрын

That is awesome that yours has that many miles on it. My 2008 has 3100km on it so hopefully mine I will last as long as yours.

@MAJorgy70 Жыл бұрын

Holy crap!!! That tank was bulging! I thought that tank was going to rip a seam and blow apart. It doesn't need that much PSI to make the fuel flow out. And it is cold out as well. 😨