Thanks for the explanation and demonstration I need to change mine 1st coil and spark plug

Thanks for the video! What are the torque specs for the shock nut, and the bolts attaching to the carrier and body?

How do you replace the clips

Can you install a Nissan radio from a 19 sentra SV (or other) trim into an S trim? Looking to get Apple Carplay, but S trims don’t come with that.

the price is

Just finished mine, thank you for the video! I didnt bother with taking the battery out but I probably should have. Spent some time fishing for a dropped bolt!

Never use Duralast parts (autozone) you’ll be sorry ..

The foam is to deaden the noise of the high pressure fuel pump. They are still loud 🤣

Camera sucks. Blurry

Wa guan Momo! Glad to see every video as always

Can't stand those cheap gdi engines lol...Great video brother!! 👍🏼🇨🇦

Yeah thanks for showing to get sensor out proabaly worst part of replacing and u skip it nice

Chevrolet equenox

I used a magnet

My vacuum pump doesn’t fit flush on cam shaft bolts line up but there’s a gap and oil leaks bad

Pretty much simple 👌🏾

Thanks bro!!

How in the hell did you lower the baron so it would fit?

Hey Sir, wanted tho say thanks for uploading your work. I just replaced my wife’s latch on a Sonata. It was quick and easy thanks to you. I even went out and bought some sockets. The latch I ordered was only $17.00 off Amazon.

amazing video🙏🏽

I have nisssan altima 2019 i have done two time completed flash tramission but i never have chance the filters inside the tramission

Could use some advice, my 2018 Nissan Sentra was having this issue where it would get cold and then it would get warm so I turned off the AC and back on it and it worked by recharging the freon. Then this morning the compressor wouldn't kick on and we had to drive 2hrz in a hot car... Advice!

Ok what is the name of the part you are holding

I usually put the low pad indicator on the down side Foo ; )

Amazing video! Very clear and concise I have a short in my 2013 Malibu car, I put the lamp tester to the negative battery post and the other end I put it to the negative terminal disconnected and the tester light turns on, I have already removed all the fuses, relays, micro fuses, disconnected TCM, ECM, BCM and the light does not turn off, above the battery, it has a module with fuses, where is indicated cable 1 or X1, I disconnect only that one, and leave the others with electricity and the short ends, but I can't find what feeds that cable, you will know, please can you help me with advice or what should I do can you help me with some advice, it is a 2013 Malibu car. Greetings in advance

Thank you!!

If anyone knows if this works for 2024 Nissan sentra? Thanks!

if you use the car stand like that you're soon going to find out why you should not use it like that

A few extra pointers: 1. Pay a professional to remove the refrigerant. This guy's method is illegal and still releases the refrigerant into the atmosphere. 2. Do NOT use the star-hex key to loosen the pulley holding the serpentine belt. There is a bolt ABOVE that pulley that you will turn to move that pulley and loosen the serpentine belt. 3. NEVER assume there is proper compressor oil in the compressor. Drain the oil from the compressor and refill. This particular Nissan generation take 4.19 oz of compressor oil.

what about the 3.2l?

👍🏻

The problem with removing the battery this way like most batteries the newer vehicles have a lot of electronics s it can mess up the system down the road that's why you should take it to your local garage . Should have constant power going to the electronics ask your mechanic

Grease up ears on them pads , always get new hardware with pads no hardware means cheap shit pads aftermarket next clean up calipers and piston with breake cleaner

I had to change mine last week I couldn’t believe just after 5 years following buying brand new I had to spend 600+ dollars to replace it.

Is there a way to reset the error code after replacing or does it go off on its own after a while?

Thanks bro,you’re the best! 😮‍💨

I love Jamaica but I love Jamaicans more much respect 🫡 much Love big up ya self tek it off and clean

Muy bien explicado!!!! Muchas Gracias!!

I wish you were in Florida

Pulled both doors apart before finding this video, legendary stuff

BROOOO THANK YOU!!

just ordered my assembly, going to use this video

I have ran through 4 of these battery fuses and 3 different starters. Why does these fuses keep blowing? And it’s always the starter part.

Thanks for sharing bro! Helped me a lot 2024 🔥🔥🔥🔥🔥

U ain’t lying I just got mine done 3 days ago now the damn serpentine belt popped

Is it safe to drive the car with this issue ?

Mechanic working at a rental car company. I didn't know about this, but it saved me some effort. Already swappped the window switch with another Corolla sitting out in the lot, which didn't fix it. This did the trick. Thanks.

you are the best you know that?? keep posting videos about rogue 😊

Man this is the only video tht shows how to actually do it hope this man is thriving in life

Do you have to do the throttle body relearn on these ?