If the rear is a torque distribution differential, the center chamber uses 75W90 Fully Synthetic Hypoid Gear Oil, and the outer 2 chambers use very expensive BMW SAF Carbon Mod Differential Oil. Think you had it in reverse. But your video helped me locate the plugs for my x5 f15 with dynamic torque vectoring.
@claynoah902514 күн бұрын
Could u tell me where you bought the hood pins or like part number or something, I have the same car and have the same problem cause the car was wrecked
@MINIzguy4 күн бұрын
Stetion Quick Release Latch off Amazon
@matthewowen557415 күн бұрын
Does it drain ur battery at all? It's draining mine and I always have to jump it off with my jump pack.
@JaCk-ep6px16 күн бұрын
Hi thanks for posting this video. I have 318ti compact m44. recently it started giving headaches: engine will stop, especially short distance driving, usually an explosion in exhaust follows. Found out crankshaft breather hose that was cracked, changed it but problem seems to repeat. could it be a faulty PCV valve ??? I know nothing about how engine works 😱😱😱
@brentkhack640419 күн бұрын
No need to remove the parking brake and the front cover. Other than that, good job.
@mnbimmer22 күн бұрын
Hows this clutch holding up? Considering it for my e46 as well.
@MINIzguy4 күн бұрын
Still fine after 2000 or so miles and many track days
@Tony-jv5pr22 күн бұрын
wow! the first video from so many I watched that talks about the subframe in detail. Thanks
@phillyshoota215423 күн бұрын
Why take the EPB off if you put it in service mode or why put it in service mode if you take the EPB off? Just so you know, if you work on a vehicle that has an EPB which you can not retract via vehicle DIC, you can manually retract them by taking off the EPB and turned the screw on the back of the caliper.
@cesarcarranza4228 күн бұрын
I think the sensor checks that is made out of the special coating (the radiator) not the temperature of it
@MINIzguy27 күн бұрын
it doesn't
@cesarcarranza4227 күн бұрын
Ok I read somewhere that but not sure. I think you are right, Let me share my experience for others. - Bought 328xi 2009 e90 manual transmission. - It had the check engine soon light on. - The guy who sold it to me said he just had the radiator changed and I did have the 2AD8 code. - Got. CSF radiator and a eac sensor from uro parts (got them both at fcp euro. (even when fcp euro say that radiator doesn’t come with a control sleeve and you should consider buying one separately (which I did), that radiator comes with two control sleeve (long for automatic, short for manual) (Also fcp Euro will tell you that that radiator only works for automatic transmissions not manual… not true) - Got the parts yesterday and changed the radiators but for testing purposes I used the old sensor which was grabbed with zip ties to the old radiator that had no port for the eac sensor. The probe and clips were broken so I zip tied it to where it was supposed to go to see if it would do anything, it didn’t. Light and code would still come up. - went back to the car, and exchanged sensors (doing the cable repining before hand) and I installed it with NO GLUE. - it did fit snug and light and code is gone. Will be driving more today throughout the week and seems that it works. So no glue necessary.
@enobishop141928 күн бұрын
Thank you - I did all these things and my chk engine is not 4:11 4:11 communicating with the cars 🖥️ computer- is what the unknown code is saying?
@wvieira981Ай бұрын
I just change my rear differential fluid with Honda VTM-4, and have half gallon left . Can I use the same fluid to change the front one as well ??
@Mr_frost467Ай бұрын
Personally, I'd remove the axles from the hub completely
@MR-xt3wpАй бұрын
where i can get one ?
@Tonyplat98Ай бұрын
I had the V3 version of this spot welder and absolutely loved that thing my wife tossed it in the trash along with the Turnigy battery that was another $75 at the time (probably a lot more now) I'm so mad will need to get the V4 now.
@SirGipsyАй бұрын
The hose snap … where I can get a replacement?
@1WinstonSmith1984Ай бұрын
Just had my airbag recall and guess what they found? Split cv and an engine oil leak. I love these cars but it’s a money pit
@nil4309Ай бұрын
Great vid, helped me thanks!!
@mbperfection2 ай бұрын
Great. Video , I have e70, similar situation , gonna do the same to mine
@sultan267062 ай бұрын
I think all aluminum is for FE5 all steel for FE1
@Teggymania2 ай бұрын
Did you do the reinforcements up top?
@MINIzguy2 ай бұрын
No after a certain year BMW added more spot welds so the top reinforcements won't be needed for my situation. Of course, if you're drifting, rallying or plan to have higher grip/HP, that might change
@Teggymania2 ай бұрын
@@MINIzguyWould you recommend doing it on an early model E46? I've seen a lot of conflicting things so far, even from the companies making the kits.
@MINIzguy2 ай бұрын
@@Teggymania for sure
@ChibiKeruchan2 ай бұрын
so it doesn't spot weld 0.2mm then. it has a little brother called DX10. it's probably won't do too. btw how much is the different of the price of pure vs plated? coz there are so many scammers in the market. some of them might be selling aluminum plated and calling it pure since it doesn't rust on salt water test it's hard to figure if it is a scam.
@MINIzguy2 ай бұрын
I bought the strip from a friend, Liionwarehouse, so I know it's pure. I didn't shop around
@leveluplife85852 ай бұрын
Do you have the leveling motor and harness too?
@MINIzguy2 ай бұрын
Not on this one because it had halogens originally. It can take motors though
@leveluplife85852 ай бұрын
@@MINIzguy Is there not a way to get the motors to work if it came with halogens originally? My x5 03 has two connectors on each side that aren’t being used and they are each 3 wires to them. Any idea what they go to? I have the headlight sprayers as well
@MINIzguy2 ай бұрын
@@leveluplife8585 check the wiring diagram to the color codes of the wires. I don't have a clue what they would be for. To get the motors to work, you'd need to wire up the leveling sensor and reprogram the LCM at the minimum
@xxxgpakos62372 ай бұрын
cars are pain xd
@Hyper4mance2k2 ай бұрын
Tire and wheel size?
@MINIzguy2 ай бұрын
17x9 245/40/17
@glennroberts4612 ай бұрын
What a waste. You didn't show any of the hard work.
@beterbey2 ай бұрын
Hi, is it the same procedure for 2008 X3? Thanks
@IndiansAuto2 ай бұрын
That’s a D pillar sir. A B C D
@AlvinQuach2 ай бұрын
Nice lap!! It was nice meeting you out there
@InstabilityControl3 ай бұрын
How did you get the cv axles off
@MINIzguy3 ай бұрын
Pop them off with a pry bar
@dogwatur3 ай бұрын
What is the smaller thinner hose coming out of the fuel pump assembly? You only mentioned the one going to evap,
@noelszabo12913 ай бұрын
I want to ask, if the air pump working and all the lines are good, but the relay get so hot wenn i try to pump the bolster. Then the relay is the bad?
@baims83673 ай бұрын
Absolutely love and hate my x6 😊/ 😡 /🥰/😩
@bobnutz72413 ай бұрын
If you drain your transmission completely and fill it up with only 5 quarts,you will destroy your transmission.You have to fill it up with 10 quarts of ATF(9.4 litres)
@MINIzguy3 ай бұрын
you can't drain the transmission completely without removing the torque converter
@bobnutz72412 ай бұрын
@MINIzguy Actually, we ended up destroying our 5L40E after doing a recent oil change.We filled 5 quarts of ATF after completely draining the transmission.We took it for a test drive and the transmission started overheating and went into Trans Failsafe program.We then discovered that the oil capacity was actually 10 quarts and it ended up taking another 5 quarts of Dex III,but we were too late as it had already damaged 1st and 2nd gear.There is now a grinding noise coming from the transmission
@ZishanMalik4 ай бұрын
How much weight does thinning the wiring harness weight save? Are there other benefits?
@MINIzguy4 ай бұрын
I think I removed at least 15 lbs of wiring. Just the audio wiring is pretty heavy and it comes out separately from the body harness. Simplying the harness helps diagnosing issues in the end as there are less unconnected wires that could chafe and short
@user-cl7hk1gm3i4 ай бұрын
هل من الممكن جعل هاذه المكينه تلحم للحام مستمر دون انقطاع
@ander83294 ай бұрын
I bought a use car and it came without the sensor and the radiator didn’t have any place to put the semsor that I bough so my car is running without it
@danielsenno29624 ай бұрын
Hey, did you remove the carpet to do these?
@MINIzguy4 ай бұрын
nope
@danielsenno29624 ай бұрын
thanks@@MINIzguy
@HalfVccTronYente4 ай бұрын
That's a time bomb. Why dont u use just a small transformer, 1 bridge rectifier, and capacitors!, 10,000uF 25v in parallel of 6 pcs would be enough for connecting batteries.
@Covkiller5 ай бұрын
Great explanationation.
@brucevarmez23085 ай бұрын
Great job..
@JC-Panda5 ай бұрын
will that be any error code to reset the break ?
@MINIzguy4 ай бұрын
No error codes when I did this
@rickyverrill40935 ай бұрын
Was it down shifting hard before you
@MINIzguy4 ай бұрын
Yes it was
@Jessie.w2225 ай бұрын
What’s the tube called? I need it please I’ve been looking everywhere for the name
@natereilly53765 ай бұрын
Whats your 3 ywar review? Any issues?
@MINIzguy4 ай бұрын
Sold the X5 a while ago. No long term damage though; just a small spring to help the hatch open
@davidweiner78085 ай бұрын
Hello! Do you have spacers on the front, and if so what size? I'm thinking of getting this same tire in 245/40s on a Kosei K1 8.5 wheel on my E36 but have heard that they run very wide so am considering 235/40s instead.
@MINIzguy5 ай бұрын
20mm
@tiberiudumitru6 ай бұрын
hello, I have a 2013 n26, if I install a Mercedes sensor, will the car recognize it? will the error be cleared? Thanks!
@EF504046 ай бұрын
Nice work!
@jonbardell70796 ай бұрын
👀 Promo_SM
@ShawnsTrains2657 ай бұрын
What kind of track? I'm going to Road America for a few days this year. Would you recommend these?
@MINIzguy7 ай бұрын
Both NJMP tracks. They should be fine at RA since the straights are so long